Physical Sciences and Mathematics Commons^™

Evolution Of Platt Shoals Northern North Carolina Shelf: Inferences From Areal Geology, Philip C. Sears

OES Theses and Dissertations

The evolution of Platt Shoals, a complex ridge and trough system on the south side of the Albemarle Shelf Valley, was determined and the modern hydraulic regime was inferred. The methods used were surficial grain size, 11 vibracores, seismic profiling and bathymetric maps. Platt Shoals developed in a three step process. The first, step was the formation of a substrate of late Pleistocene regressive deposits from 15,000 to 30,000 yr B. P. The second step, occurring approximately 11,000 yr B. P., was the formation of estuary mouth shoals of the ancestral Albemarle River. Between 4,4.00 to 5,000 yr B. P., …

Seismic Refraction Study Of Post-Pliocene Stratigraphy, Dismal Swamp, Virginia, William Brian Fraser

OES Theses and Dissertations

This study examines Pliocene-Pleistocene lithostratigraphy and the Yorktown unconformity within the Dismal Swamp by means of remote sensing analysis, Wyrobek-Gardner seismic refraction profiling and split-spoon coring. Pre-Sangamon fluvial/tidal channel deposits are not present and the Yorktown unconformity dips irregularly southeastward at 0.35 meters/kilometer (2 feet/mile) from a high at 4 meters above sea level to a low of -1 meter (+12 to -2 ft) below sea level. The marker velocity for the Yorktown Formation is 1600 mps (5250 fps) and regression of seismic depths of the Yorktown Formation with corresponding split-spoon depths yields a high correlation. Short line upper layer …

Grain Size Reconnaissance Of The Virginia-North Carolina Inner Shelf Analysis By Settling Technique, Robert Bailey Sanford Jr.

OES Theses and Dissertations

The 2-fold purpose of this study is to calibrate a Rapid Sediment Analyzer and to use it to aid in the determination of the genesis of sediment on the inner continental shelf between Cape Henry and Cape Hatteras. Rapid Sediment Analyzer calibration was conducted by comparison of sieving and settling results of similar sands.

The study area was divided into sediment provinces by both a qualitative procedure (grain size and topography) and a quantitatively procedure (factor-vector analysis). Qualitative provinces are beach and surf, upper shore face, lower shore face, sea floor, and terminal shoals. The berm fines from each terminal …