Open Access. Powered by Scholars. Published by Universities.®
Physical Sciences and Mathematics Commons™
Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 5 of 5
Full-Text Articles in Physical Sciences and Mathematics
Rf Tests Of Rf-Dipole Prototype Crabbing Cavities For Lhc High Luminosity Upgrade, Subashini De Silva, Hyekyoung Park, Jean R. Delayen, Zi Li
Rf Tests Of Rf-Dipole Prototype Crabbing Cavities For Lhc High Luminosity Upgrade, Subashini De Silva, Hyekyoung Park, Jean R. Delayen, Zi Li
Physics Faculty Publications
The superconducting rf-dipole crabbing cavity is one of the two crabbing cavity designs proposed for the LHC high luminosity upgrade. The proof-of-principle (P-o-P) rf-dipole cavity operating at 400 MHz has demonstrated performance exceeding the design specifications. The prototype cavity for SPS beam test has been designed to include the fundamental power coupler, HOM couplers, and all the ancillary components intended to meet the design requirements. The crab cavities will be installed in the SPS beam line prior to the installation in LHC; this will be the first crabbing cavity operation on a proton beam. The fabrication of two prototype rf-dipole …
Lessons Learned From Rf-Dipole Prototype Cavities For Lhc High Luminosity Upgrade, Subashini De Silva, Jean R. Delayen, Z. Li, H. Park
Lessons Learned From Rf-Dipole Prototype Cavities For Lhc High Luminosity Upgrade, Subashini De Silva, Jean R. Delayen, Z. Li, H. Park
Physics Faculty Publications
The RF-Dipole Crabbing Cavity designed for the LHC High Luminosity Upgrade includes two higher order mode (HOM) couplers. One of the HOM couplers is an rf filter, which is a high pass filter designed to couple to the horizontal dipole modes and accelerating modes up to 2 GHz, while rejecting the fundamental operating mode at 400 MHz. The coupler consists of a high pass filter circuit where the rejection of the operating mode and transmission of HOMs are sensitive to dimensional deviations. An rf test box has been designed to measure the transmission of the rf filter in order to …
Measurements Of Frequency, Temperature, Rf Field Dependent Surface Resistance Using Superconducting Half-Wave Cavity, Hyekyoung Park, Subashini De Silva, Jean R. Delayen
Measurements Of Frequency, Temperature, Rf Field Dependent Surface Resistance Using Superconducting Half-Wave Cavity, Hyekyoung Park, Subashini De Silva, Jean R. Delayen
Physics Faculty Publications
A theory of surface resistance of superconductor was rigorously formulated by Bardeen, Cooper, Schrieffer more than 50 years ago. Since then the accelerator community has been used the theory as a guideline to improve the surface resistance of the superconducting cavity. It has been observed that the surface resistance is dependent on frequency, temperature and rf field strength, and surface preparation. To verify these dependences, a well-controlled study is required. Although many different types of cavities have been tested, the typical superconducting cavities are built for specific frequencies of their application. They do not provide data other than at its …
Cryogenic Probe Station At Old Dominion University Center For Accelerator Science, Junki Makita, Jean R. Delayen, Alex Gurevich, Gianluigi Ciovati
Cryogenic Probe Station At Old Dominion University Center For Accelerator Science, Junki Makita, Jean R. Delayen, Alex Gurevich, Gianluigi Ciovati
Physics Faculty Publications
With a growing effort in research and development of an alternative material to bulk Nb for a superconducting radiofrequency (SRF) cavity, it is important to have a cost effective method to benchmark new materials of choice. At Old Dominion University's Center for Accelerator Science, a cryogenic probe station (CPS) will be used to measure the response of superconductor samples under RF fields. The setup consists of a closed-cycle refrigerator for cooling a sample wafer to a cryogenic temperature, a superconducting magnet providing a field parallel to the sample, and DC probes in addition to RF probes. The RF probes will …
Progress On The Interaction Region Design And Detector Integration At Jlab's Meic, V. S. Morozov, P. Brindza, A. Camsonne, Ya S. Derbenev, R. Ent, D. Gaskell, F. Lin, P. Nadel-Turonski, M. Ungaro, Y. Zhang, C. E. Hyde, K. Park, M. Sullivan, Z. W. Zhao
Progress On The Interaction Region Design And Detector Integration At Jlab's Meic, V. S. Morozov, P. Brindza, A. Camsonne, Ya S. Derbenev, R. Ent, D. Gaskell, F. Lin, P. Nadel-Turonski, M. Ungaro, Y. Zhang, C. E. Hyde, K. Park, M. Sullivan, Z. W. Zhao
Physics Faculty Publications
One of the unique features of JLab's Medium-energy Electron-Ion Collider (MEIC) is a full-acceptance detector with a dedicated, small-angle, high-resolution detection system, capable of covering a wide range of momenta (and charge-to-mass ratios) with respect to the original ion beam to enable access to new physics. We present an interaction region design developed with close integration of the detection and beam dynamical aspects. The dynamical aspect of the design rests on a symmetry-based concept for compensation of non-linear effects. The optics and geometry have been optimized to accommodate the detection requirements and to ensure the interaction region's modularity for ease …