Open Access. Powered by Scholars. Published by Universities.®

Physical Sciences and Mathematics Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 8 of 8

Full-Text Articles in Physical Sciences and Mathematics

A Library Of Low Molecular Weight Fluorescent Probes For The Detection Of Cu(Ii) And Fe(Iii) Ions, Ashley Johnson Dec 2020

A Library Of Low Molecular Weight Fluorescent Probes For The Detection Of Cu(Ii) And Fe(Iii) Ions, Ashley Johnson

Dissertations

This dissertation reports the synthesis and photophysical properties of a family of rhodamine dyes (compounds 3.9-3.13 and 4.6). The rhodamine dyes are prepared in two steps, and fully characterized by ESI-MS (Low and High resolution), X-Ray crystallography, NMR spectroscopy, and FT-IR spectroscopy. The coordination environment of the low molecular weight fluorescent probes (LMFPs) was systematically changed to investigate the thermodynamic behavior between the LMFPs and an array of metal ions (Cu2+, Fe2+, and Hg2+ ions) in protic and aprotic solvent systems. Upon coordinating to metal ions, the π-conjugation of the LMFPs changed, resulting in …


Practical Adhesion Measurements In Organic Coatings; Advancing Understanding And Mechanical Methods Development, Diana Gottschalk Dec 2020

Practical Adhesion Measurements In Organic Coatings; Advancing Understanding And Mechanical Methods Development, Diana Gottschalk

Dissertations

“Adhesion” can be considered either a mechanical or chemical phenomenon. The mechanical interpretation describes the difficulty of separating surfaces and is useful for quantifying performance within applications that depend on bulk and interfacial properties. Chemical adhesion describes interfacial resistance to chemical attack and does not depend on bulk properties. Predicting chemical failure through mechanical measurement is confounded by the influence of bulk properties. However, the prospect is attractive because of the robust tolerance for sample geometries, allowing experiments to resemble an end-use system. The present work's primary goal was to elevate mechanical methods to provide a detailed interfacial characterization of …


Synthesis Of Alpha-Methylselenocysteine, Its Relevant Analogues, And An Unnatural Glutathione Disulfide Core, Robert J. Wehrle Aug 2020

Synthesis Of Alpha-Methylselenocysteine, Its Relevant Analogues, And An Unnatural Glutathione Disulfide Core, Robert J. Wehrle

Dissertations

Selenoproteins, such as glutathione peroxidase, have gained interest for their ability to act as antioxidants, and their potential to act as anti-cancer agents. Synthesizing and studying selenoproteins can be problematic, however, due to their propensity to degrade from over-oxidation. The degradation from over-oxidation can be avoided by the incorporation of the unnatural amino acid, alpha-methylselenocysteine. A synthesis utilizing methyl malonic esters was used to synthesize protected (R)-alpha-methylselenocysteine efficiently (46% over four steps) and in high enantio-purity (88% enantiomeric excess). Using similar procedures, the (S)-enantiomer was also synthesized as well as a beta-analogue.

The use of enzymes …


Machine Learning Approaches For Improving Prediction Performance Of Structure-Activity Relationship Models, Gabriel Idakwo Aug 2020

Machine Learning Approaches For Improving Prediction Performance Of Structure-Activity Relationship Models, Gabriel Idakwo

Dissertations

In silico bioactivity prediction studies are designed to complement in vivo and in vitro efforts to assess the activity and properties of small molecules. In silico methods such as Quantitative Structure-Activity/Property Relationship (QSAR) are used to correlate the structure of a molecule to its biological property in drug design and toxicological studies. In this body of work, I started with two in-depth reviews into the application of machine learning based approaches and feature reduction methods to QSAR, and then investigated solutions to three common challenges faced in machine learning based QSAR studies.

First, to improve the prediction accuracy of learning …


An Atomistic Study Of The Effects On Mechanical Properties And Bonding Interactions Of Carbon Nanofillers In Nylon 6 Nanocomposites, Michael Roth May 2020

An Atomistic Study Of The Effects On Mechanical Properties And Bonding Interactions Of Carbon Nanofillers In Nylon 6 Nanocomposites, Michael Roth

Dissertations

Polymers have potential for a wide range of applications. The effectiveness of polymers can be further enhanced through the addition of nanofillers that improve thermal, mechanical, and electrical properties of the polymer. Carbon based nanofillers such as carbon nanotube (CNT), graphene, and carbon nanofibre (CNF) are of particular interest due to their high properties and high aspect ratios. However, limited understanding of the governing interactions of these nanofillers with polymers limits the effectiveness of the final nanocomposite.

The first facet of this dissertation focuses on determining the dominating interactions between pristine CNT and graphene with nylon 6 monomer and the …


Effect Of Selfsame Microparticles On Epoxide Amine Network Formation And Matrix Mechanics, Travis Palmer May 2020

Effect Of Selfsame Microparticles On Epoxide Amine Network Formation And Matrix Mechanics, Travis Palmer

Dissertations

Epoxide amine matrices are widely utilized in aerospace carbon fiber reinforced polymer (CFRP) composites having engendered significant reductions in weight and fuel consumption. This dissertation focuses on the effect of constrained space during network formation on the matrix mechanics of these highly complex composite systems. Precipitation polymerization conditions are developed to prepare epoxide amine microparticles (EMs) based on tetraglycidyl-4,4’-methylenedianiline (TGDDM) and isophorone diamine (IPDA). Surface functionality of EMs is tuned via control of epoxide to reactive amine hydrogen ratio, where unreactive, amine- and epoxide-functional EMs are prepared. We demonstrate that EMs are polydisperse, but can be filtered, yielding low dispersity …


Huisgen 1,3-Dipolar Azide-Alkyne Cycloaddition “Click” Reaction In Polymer Synthesis And Curing, Jie Wu May 2020

Huisgen 1,3-Dipolar Azide-Alkyne Cycloaddition “Click” Reaction In Polymer Synthesis And Curing, Jie Wu

Dissertations

This dissertation’s key focus is on utilizing Huisgen 1,3-dipolar azide-alkyne cycloaddition (AAC) reaction in copolymer synthesis and modification, including thermoplastic block copolymer and commercially available two-component polyurethane system. It can be divided into two major projects, introduced as follows.

The first project involves the development of a modular synthetic approach toward polyisobutylene (PIB)-based triphasic pentablock thermoplastic elastomer with enhanced moisture permeability. This terpolymer consists of a poly(styrene-b-isobutylene-b-styrene) (SIBS) core and appended hydrophilic polymer blocks (HBs). The SIBS core was synthesized via living cationic polymerization (LCP) of isobutylene followed by sequential addition of styrene. AAC was utilized …


Geochemical Tracers Of Arctic Ocean Processes: A Study Of Gallium, Barium, And Vanadium, Laura M. Whitmore May 2020

Geochemical Tracers Of Arctic Ocean Processes: A Study Of Gallium, Barium, And Vanadium, Laura M. Whitmore

Dissertations

The Arctic Ocean is linked to the global oceans and climate through its connectivity with the North Atlantic Ocean and the regional thermohaline deep water formation sites. It’s also a region undergoing rapid environmental change. To inform the community of potential changes in geochemical and biogeochemical cycles, this dissertation addresses three dissolved geochemical tracers (gallium, barium, and vanadium) as indicators of Arctic Ocean processes. Gallium is tested as a replacement for nutrient-type tracers in an effort to deconvolve Pacific and Atlantic derived waters in the Arctic Ocean basins. These water masses carry different heat and salt content and can influence …