Orthodontics and Orthodontology Commons^™

Measured Effects Of Rapid Palatal Expansion On Nasal Cavity Volume Utilizing Cbct, Jon Neal Robinson

Loma Linda University Electronic Theses, Dissertations & Projects

The purpose of this study was to evaluate and predict the expected changes that occur in the nasal cavity volume following rapid palatal expansion. Eighteen subjects (11 female, 7 male), ages 9 to 18, requiring rapid palatal expansion in conjunction with comprehensive orthodontic treatment, were selected for the study. Rapid palatal expansion was accomplished using the standard, banded hyrax appliance. Three-dimensional cone beam computed tomograms using the NewTom 9000™ were acquired before and after expansion. Serial coronal slices of the nasal cavity were made using the QV9000™ software program. The resultant serial images were imported into 3-D Doctor™ for analysis …

Comparison Of Bracket Bond Strength By Total, Self-Etch And Laser Treatment, Kyo Sung Shawn Kim

Loma Linda University Electronic Theses, Dissertations & Projects

Laser etching of enamel surfaces alters the physical and chemical characteristics of the enamel. These changes in characteristics enhance the bonding to enamel. The purpose of this study was to compare the shear and tensile bond strength of Er,Cr:YSGG hydrokinetic laser system (Biolase) with 37% phosphoric acid and self etching primer 30 minutes and 72 hours after bonding. Four different laser power output setting was observed: 1.5W, 2.0W, 2.5W, and 3.0W. Two hundred forty bovine teeth free of defect, caries, and dentin exposure were mounted in acrylic resin and divided into 24 groups of 10 teeth. Sixteen groups of 10 …

A Bond Strength Comparison Of Led And Halogen Light Curing Units, John Richard Kavanagh

Loma Linda University Electronic Theses, Dissertations & Projects

The purpose of this research was to compare the tensile bond strength of orthodontic flat based buttons bonded to bovine teeth with four commercial light-emitting diode (LED) curing lights and one conventional quartz tungsten halogen (QTH) curing light.

The dental market has recently been introduced to a number of commercially available light-emitting diode (LED) curing lights. Tensile bond strength was evaluated for LED curing lights (Rembrandt® Allegro^TM, Den-Mat Corp, Santa Maria, CA), (LEDemetron, Kerr/Demetron Corp, Danbury, Conn), (Ortholux LED, 3M^TMESPE^TM, St. Paul, MN),and (FLASH-lite 1001, Discus Dental, Culver City, CA) are compared with one …

The Histological Effects Of Mandibular Distraction Osteogenesis On Rabbit Condyles, Eunice Jungmin Hong

Loma Linda University Electronic Theses, Dissertations & Projects

The present study is a histological evaluation of condyles taken from rabbits that underwent either a midline or paramedian distraction osteogenesis procedure on the mandibles. Fifteen rabbits were originally operated on and eight of these fifteen successfully made it through both the distraction osteogenesis procedure and the 1 month holding period that followed. There was one control animal.

In the present study, the condyles from these nine rabbits (1 control, 2 midline distraction osteogenesis, 6 paramedian distraction osteogenesis) were prepared for histological evaluation (18 total). Step serial sections were cut along the coronal plane and the sections from the anterior …

Healing Following Placement Of A Subperiosteal Orthodontic Anchoring Device, Oliver Hoffmann

Loma Linda University Electronic Theses, Dissertations & Projects

Background: A method to accomplish orthodontic anchorage using a hydroxyapatite-coated disk that is placed below the periosteum in the mid-palatal area has been developed (OnPlant, Nobel Biocare, Yorba Linda, CA, USA). This report describes the early to 8-month healing events of the first 8 consecutive cases of placement of the OnPlant device at the Advanced Periodontics Clinic at Loma Linda University School of Dentistry. In addition, it presents the results of a questionnaire on how the patients experienced the various procedures. A radiographic analysis of the side of placement of the device was performed.

Methods: At 2 weeks and at …

Synovial Fluid Hydrostatic Pressure In The Tmj After Mandibular Advancement In Sus Scrofa, Samuel A. Demirdji

Loma Linda University Electronic Theses, Dissertations & Projects

Mandibular advancement is performed in patients routinely by traditional bilateral sagittal split osteotomy (BSSO) or less commonly by distraction osteogenesis (DO). The influence of mandibular advancement on the temporomandibular joint (TMJ) is well recognized but not fully explored. This study involved the direct measurement of synovial fluid hydrostatic pressure (SFHP) in the TMJ after mandibular advancement by either BSSO or DO in two male mature minipigs, Sus scrofa. Titanium pressure transducers were inserted into the right superior temporomandibular joint spaces of the minipigs and the measurements were displayed on an AC/DC amplifier. The first minipig underwent BSSO, which involved immediate …

Orthodontic Faculty Recruitment And Retention: Goals And Perceptions, Sheldon L. Peck

Theses and Dissertations

There is a shortage of faculty in academic dentistry and orthodontics in particular. The purpose of this study was to quantify real and perceived differences in income, workload, and satisfaction between full-time academic and private practice orthodontists. Surveys were returned by 119 (70%) faculty, 79 (36%) private practitioners, and 160 (59%) orthodontic residents. Average annual income for faculty was less than half that of private practitioners. Faculty also reported working significantly more hours per week and taking less vacation time. Though both faculty and practitioners perceived their own jobs to be more satisfying overall, faculty felt academics was more stressful, …

Measurement Of Forces And Moments In Three-Dimensional Archwires, Dwight Van Buelow

Theses and Dissertations

AbstractMEASUREMENT OF FORCES AND MOMENTS IN THREE-DIMENSIONAL ARCHWIRESBy Dwight V. Buelow, D.D.S.A thesis submitted in partial fulfillment of the requirements for the degree of Master of Science at Virginia Commonwealth University.Virginia Commonwealth University, 2003Major Director: Steven J. Lindauer, D.M.D., M.D.Sc.Chairman and Professor, Department of OrthodonticsOrthodontic tooth movement occurs in response to the application of controlled mechanical force systems. The purpose of this study was to improve understanding of those force systems by evaluating differences between the resultants of two-dimensional and three-dimensional orthodontic appliance activations. An in-vitro model was constructed and three force-moment gauges were used to measure the forces and …

Lip Profile Preferences In Varying Sagittal Mandibular Positions, Grant Gordon Coleman

Theses and Dissertations

The purpose of this study was to determine the influence of sagittal mandibular position on preferred lip position in profile. Five androgynous silhouette profiles differing only in the degree of mandibular retro- or prognathism (-25º, -18º, -11º, -4º, & +3º facial contour angles) were created. Using a computer animation program, evaluators moved the lips independently into the position deemed to be the most esthetic for each profile. Evaluators included adolescent orthodontic patients, parents of patients, and orthodontists. In general, no differences in preferred lip position were found between the –11º & -4º profiles or between the –18º & +3º profiles, …