Animal Sciences Commons^™

Design, Construction And Cost Analysis Of Manufacturing Horse Bits, Erica L. Timmermans

BioResource and Agricultural Engineering

This report discusses the design, fabrication and cost analysis of two unique horse bits. On the market today, there are many different kinds of bits to serve a multitude of purposes. However, this project explored the option of having two different shanks types made of stainless steel in addition to three mouthpieces that are able to fit in both types of shanks.

Design, Acnd Construction Of A Portable Artificial Insemination Chute, Chris Herrera

BioResource and Agricultural Engineering

This senior project report discusses the design, construction, and evaluation of a portable artificial insemination chute for the use of the Cal Poly Beef Department. The design was based on the suggested modifications from operators of several other chutes currently in use.

The main areas considered for the design were; Ergonomics, cattle safety, factors effecting maximum breeding conception rates, and Portability.

The breeding chute proved superior over traditional chutes in a variety of ways. Improvement occurred in the areas of consideration as follows, user operation was simplified, animal stress was decreased, and maximum breeding efficiency was obtained.

Design, Planning, And Evaluation Of Upgraded Cattle Handling Facility, Lindsey Kaeli Tulloch

BioResource and Agricultural Engineering

This senior project discusses the design, planning, and evaluation of a livestock handling facility for Tulloch Ranches. The facility will be an upgrade to the facility currently used at the ranch in Pine Valley, California. The design parameters for the facility were narrowed down to the following: 1. Must reduce stress to animals during handling. 2. Must be cost effective to save labor and maintenance. 3. Must show improvement from the current set- up. The above parameters combine to form a system that enables the handlers of Tulloch Ranches to manage and work cattle in a more calm and humane …

Identifying Alternative Waste Conversion Technologies For Use At California Polytechnic State University San Luis Obispo, Matthew R. Bono

BioResource and Agricultural Engineering

This project was undertaken to identify and study alternative technologies for converting waste streams available on the Cal Poly San Luis Obispo campus into energy. As a large campus on the Central Coast of California Cal Poly not only produces lots of waste, but has limited options for its disposal. Furthermore, the campus is in the midst of an on-going green initiative, and more efficient use of its waste products would be a welcome development for the entire campus community. This report gathers information on waste streams originating at Cal Poly and information about waste to energy conversion technologies. The …