Other Engineering Commons^™

Determining A Community Retrofit Strategy For The Aging Housing Stock Using Utility And Assessor Data, Nathan A. Barry

Department of Construction Engineering and Management: Dissertations, Theses, and Student Research

Residential buildings account for about 21.5% of the nation’s primary energy consumption and carbon emissions, and about 38% of electricity use. The housing stock in the United States consists of over 128 million residences with over 60% being constructed prior to 1979 when building codes and regulations began standardizing building practices. Seeking an opportunity to understand and reduce consumption, the scientific community developed a number of model-driven auditing software. While these computer models have been successful in predicting usage patterns in newer residential structures, they have been inaccurate in predicting and analyzing energy use in aging housing stock, predominantly homes …

Role Of Information On Probability Of Traffic Conflict On The Onset Of Yellow, Nathaniel P. Burnett, Anuj Sharma

Department of Civil and Environmental Engineering: Faculty Publications

This paper examines the effect of information provided to drivers through advance warning flashers (AWFs) on driver’s probability of conflict at the onset of yellow at a high-speed intersection. AWFs are specifically designed to minimize the number of vehicles trapped in their respective dilemma zones at the onset of yellow. A probit modeling technique was used to establish dilemma zone boundaries. Based on the dilemma zone boundaries probability of a perceived conflict curves was computed and compared against actual conflicts observed at each of the studied intersections. The comparison between the actual and theoretical probability of conflict curves generated a …

Incorporating Spatial Data And Gis To Improve Sea Of Land Use Plans: Opportunities And Limitations: Case Studies In The Republic Of Ireland, Ainhoa Gonzalez Del Campo

Doctoral

This research aimed at establishing whether spatial data and Geographic Information Systems (GIS) can contribute to Strategic Environmental Assessment (SEA). To achieve this, an integrated GISEA approach was developed and applied to a number of spatial planning SEAs in the Republic of Ireland. The practical applicability of the approach was examined, evaluating the potential benefits derived from using spatial data and GIS in SEA and assessing the potential barriers to an effective GIS use. The implementation of the SEA Directive incorporated a new dimension into plan-making by calling for the assessment of potential environmental effects that may derive from implementing …

An Assessment Of The Use Of Structural Deformation As A Method Of Determining Area Of Fire Origin, Andrew T. Tinsley, David J. Icove

Safety, Security and Emergency Management Faculty and Staff Scholarship

Current methodologies of origin investigation have yet to include the structural deformations seen in steel buildings as a viable indicator of the area of origin of a given fire. As many steel structures are of relatively large size, it is often difficult to determine the area of origin using the typical dig and sift methods advocated in NFPA 921, especially if the extent of the fire was large and there were no witnesses as to the origin of the fire. As has been investigated for years, the performance of steel is highly affected by the application of heat. The science …

Lipid Productivity Of Algae Grown On Dairy Wastewater As A Possible Feedstock For Biodiesel, Ian C. Woertz

Master's Theses

The objective of this thesis is to develop a biological wastewater treatment system that utilizes algal growth to simultaneously create renewable energy in the form of biodiesel and digester biogas, remove polluting nutrients, and abate greenhouse gases. Research under the Department of Energy Aquatic Species Program during 1978-1996 concluded that cultivating algae for biofuels was cost prohibitive at that time and that an integrated approach should be studied that combined wastewater treatment with algal biofuel production. Nutrient removal, in particular nitrogen and phosphorus, from wastewater is a growing regulatory need and the use of algae cultivation could create a unique …

Inside Unlv, Erin O'Donnell, Diane Russell, Carol C. Harter

Inside UNLV

No abstract provided.

Effects Of Oxygen Content Of Admitted Gases In Sulfide Flotation, Brian J. Boyle

Bachelors Theses and Reports, 1928 - 1970

No abstract provided.

Methods Of Studying The Effects Of Frothers, Frank L. Bazzanella

Bachelors Theses and Reports, 1928 - 1970

No abstract provided.

Studies In Modulation Of Interfacial Reactions For Certain Sulphide Minerals, Robert Owen Beyaert

Bachelors Theses and Reports, 1928 - 1970

No abstract provided.

Habit Modification Of Naclo3 With Nai, William A. Coghlan

Bachelors Theses and Reports, 1928 - 1970

No abstract provided.

Production Of Standard-Grade Ferromanganese In An Electric Arc Furnace, Force F. Baney Jr.

Bachelors Theses and Reports, 1928 - 1970

The investigations conducted in this project were essentially concerned with the effects of various compositions of two different slag systems upon the increased recovery of manganese in a standard-grade ferromanganese.

Investigation Of The Ternary System Silver-Aluminum-Indium (Ag-Al-In), Elvin H. Beardslee

Bachelors Theses and Reports, 1928 - 1970

This thesis paper contains material pertaining to & preliminary investigation of the ternary system Ag-Al-In. Procedures in this preliminary investigation are discussed in detail.

Preliminary Examination Of The Aluminum Corner Of The Ternary System Aluminum-Silver-Indium (A1-Ag-In), Jerome J. Blake

Bachelors Theses and Reports, 1928 - 1970

In this paper the author attempts to lay the groundwork for future work on the Al-Ag-In system.

Increased Corrosion Of A 304 Stainless Steel Upon Bending, William C. Tiddy

Bachelors Theses and Reports, 1928 - 1970

No abstract provided.

Identification Of Nonmetallic Inclusions In Armco Ingot Iron With Polarized Light, Frank E. Panisko

Bachelors Theses and Reports, 1928 - 1970

No abstract provided.

The Hydrometallurgy Of Uranium, John E. Cesarani

Bachelors Theses and Reports, 1928 - 1970

No abstract provided.

Crystal Habit Modification Of Sodium Chlorate, Michael R. Keegan

Bachelors Theses and Reports, 1928 - 1970

All single crystals have a particular habit or morphology. The crystal habit refers to the relative degree of development of crystallographic planes into surfaces which make up the external appearance of the single crystal.

In this paper, NaClO3 is used as a parent crystal. Its simple cubic habit is modified to tetrahedral by the use of impurities of SO4=, S2O3=, Cr2O7=, and NO3-. The degree of habit change is studied as a function of impurity concentration and temperature. The problem and phenomena are explained in terms of surface chemistry and thermodynamics.

Physico-Chemical Principles Of Sixteenth Century Metallurgy, Robert E. Johnson

Bachelors Theses and Reports, 1928 - 1970

Following a review of sixteenth century metallurgical literature and a discussion of Gibbs free energy, this thesis discusses thermodynamic considerations of galena (PbS) reduction by iron from a lead assay of this period. The importance of fluxes in this assay is emphasized. The discussion covers both equilibrium and non-equilibrium conditions at 1100 degrees Celsius. Possible substitutes for iron are also covered.

Information from twenty-one small controlled lead assays is correlated with the thermodynamic discussion to determine the purpose of each constituent in the assay.

The Beneficiation Of Titaniferous-Magnetite Sands, Ronald Lloyd Nordwick

Bachelors Theses and Reports, 1928 - 1970

The purpose of this investigation of beneficiation methods is to develop and study possible economic methods for recovering an iron-titanium concentrate of sufficient purity to meet metallurgical requirements for subsequent direct reduction to pig iron and a high titanium slag.

Stress-Corrosion Cracking Of Brass, Paul A. Fossey

Bachelors Theses and Reports, 1928 - 1970

the mechanism of stress-corrosion cracking of brass has been sought for many years. Investigators have proposed many mechanisms, but each of these mechanisms has always had several drawbacks. This paper presents an account of experimental work done in the laboratory on this subject and compares it to the work of previous investigations. It evaluates the mechanisms presented by investigators and shows the failures of these mechanisms. A theory of Nitrogen Embrittlement is presented and an evaluation of this theory with experimental work follows.

Experimental Arc Furnace Smelting Of Titaniferous Iron Sands From The Northern Oregon Coast, Allan P. Herring

Bachelors Theses and Reports, 1928 - 1970

This investigation is an attempt to experimentally smelt titaniferous iron sands from the Northern Oregon Coast in a laboratory arc furnace.

The Effect Of Ph Upon Chelation Reactions In Montmorillonite Clays, Joseph Michael Keane

Bachelors Theses and Reports, 1928 - 1970

The purpose of this thesis is to investigate several chelation reactions and determine the effect of variable pH upon these reactions.

An Investigation Of The Sintering Of Iron-Wire Compacts, George L. Vivian

Bachelors Theses and Reports, 1928 - 1970

A study of the sintering of iron has been made by observing the rate of bonding of iron wires wound on iron spools. The specimens were sintered at a constant temperature of 850c in vacuum furnaces capable of producing pressures of 10-5 to 10-4 mm of mercury, and the growth of the bond between wires was observed as a function of time.

It has been concluded that the volume-diffusion mechanism is strongly operating in the sintering of iron at 850c, but in an evacuated system, the evaporation-condensation mechanism also contributes to the sintering process.

The Identification Of Montana Clays By X-Ray Analysis, David Stephen Malyevac

Bachelors Theses and Reports, 1928 - 1970

The purpose of this study is to identify the various Montana clay minerals by means of X-ray diffraction. The ultimate aim of this investigation is to identify the different clay mixtures through an analysis of their respective diffraction patterns, and diffraction patterns obtained after various chemical and thermal treatments.

The Design And Construction Of An Electrolytic Cell For Aluminum Reduction, Thomas H. Melrose

Bachelors Theses and Reports, 1928 - 1970

The purpose of this investigation was to design and construct a laboratory size electrolytic cell in which to reduce alumina, using the same basic materials that are used in a commercial size cell. The cell was designed to have a capacity of approxi­mately 100 grams of metallic aluminum produced every 8 hours. The cell was constructed so it could be operated continuously.

Investigation Of Inclusions In Armco Ingot Iron, Edwin J. Duncan

Bachelors Theses and Reports, 1928 - 1970

Various chemical and electrolytic separation methods were investigated in an attempt to separate the in­clusions in Armco ingot iron. Residues obtained were X-rayed for identification purposes. The microstruc­tures of this iron were studied with the object of de­termining the relative sizes, locations, and possible compositions of the inclusions.

Effect Of Recovery On The Recrystallized Grain-Size Of High Purity Aluminum, Rodney L. Helterline

Bachelors Theses and Reports, 1928 - 1970

When a cold-worked metal is annealed, it’s physical properties hange as a result of a new grain structure. The annealing treatment is divided into three stages according to the changes that occur in the distorted metal: (1) recovery, (2) recrystallization, and (3) grain growth.

Polarography Of Indium, John Jackson

Bachelors Theses and Reports, 1928 - 1970

The purpose of this thesis is to study the various aspects of the polarography of indium. The eventual goal would be to develop a method of analyzing indium in unknowns. The investigation is approached by studying the indium ions in various electrolytes and in various concentrations.

Geology Of The Ragged Point Oil Field Musselshell County, Montana, David M. Amos

Bachelors Theses and Reports, 1928 - 1970

The Ragged Point oil field is located in Northwest Musselshell County, in the Lake Basin field of central Mon­tana, and on the western border of the Great Plains region. The surface topography is that of a plain marked by erosion and moderate folding. The stratigraphy of central Montana shows periodic marine invasions from the Cordilleran trough, with normal marine limestones interbedded with sandstone sand shales. These sediments are over 12,000 feet thick, with the Creta­ceous Eagle and Colorado formations exposed at the surface on the Ragged Point anticline. Undifferentiated Cambrian lime­stones and shales are the oldest rocks encountered in drilling.

The Application Of Electric Energy To The Metallurgy Plants In Montana, Edwin J. Duncan

Bachelors Theses and Reports, 1928 - 1970

Since the year 1800, metallurgy has been affiliated with electricity. In fact, the two industries have grown side by side, being naturally dependent upon each other and having a parallel growth.