Open Access. Powered by Scholars. Published by Universities.®
- Discipline
- Publication
- Publication Type
Articles 1 - 2 of 2
Full-Text Articles in Manufacturing
Energy Efficiency Evaluation Of Blower Heater Non-Purge Compressed Air Dryers, Alexandra M. Botts
Energy Efficiency Evaluation Of Blower Heater Non-Purge Compressed Air Dryers, Alexandra M. Botts
Graduate Theses, Dissertations, and Problem Reports
There are several compressed air dryers available for industrial use including, refrigerant, desiccant, and membrane. This research focuses on twin tower regenerative closed loop desiccant dryers, specifically: blower heater non-purge (BHNP) with and without cooling water pumps, Compressed-air Heater Purge (CHP), Blower Heater Purge (BHP), and Pressure Swing Heaterless (PSH). These styles of dryers are used mainly in industries that require extremely dry air such as, food manufacturing, medical air, or sensitive technology manufacturers. The research was conducted by collecting and analyzing real time current draw data on air compressors and associated dryers at eight different facilities (13 compressor systems) …
Rotary Friction Welding Versus Fusion Butt Welding Of Plastic Pipes – Feasibility And Energy Perspective, Ramsey F. Hamade, Tarek R. Andari, Ali H. Ammouri, Ibrahim S. Jawahir
Rotary Friction Welding Versus Fusion Butt Welding Of Plastic Pipes – Feasibility And Energy Perspective, Ramsey F. Hamade, Tarek R. Andari, Ali H. Ammouri, Ibrahim S. Jawahir
Institute for Sustainable Manufacturing Faculty Publications
According to the Plastics Pipe Institute, butt fusion is the most widely used method for joining lengths of PE pipe and pipe to PE fittings “by heat fusion” (https://plasticpipe.org/pdf/chapter09.pdf). However, butt-welding is not energy-cognizant from the point of view of a phase-change fabrication method. This is because the source of heating is external (heater plate). The initial heating and subsequent maintenance at relatively high temperature (above 200 C for welding of high-density polyethylene pipe) is energy intensive. Rotary friction welding, on the other hand focuses the energy where and when as needed because it uses electric motor to generate mechanical …