Applied Mechanics Commons^™

Liquid Transmission Line Pulser Circuit For Laser Excitation, Carl Stultz

Dissertations and Theses

The subject of this thesis is the study of liquid dielectric transmission lines and their potential application as an excitation source in high speed, high-repetition rate laser designs. The design problems associated with the construction of high repetition rate (khz), short wavelength lasers have been reviewed and the major shortcomings of conventional electrical driving circuits identified. The identification of these shortcomings and a review of the available literature on electrical circuits for various types of lasers suggested that liquid dielectrics and transmission lines could potentially have significant advantages over more conventional circuitry used in high repetition rate, short wavelength lasers. …

Reduction Of Capacitor Switching Transients By Controlled Closing, John Herman Brunke

Dissertations and Theses

This thesis presents the theory, analysis, testing and implementation of a scheme to reduce shunt compensation capacitor switching transients. The described method is switch the capacitors very near the instant when the bus voltage is at a power frequency zero. This was accomplished with a vacuum breaker on a 230 kV shunt capacitor bank.

The Design And Construction Of A Flashlamp-Pumped Frequency-Doubled Dye Laser Applicable To Long Path Monitoring Of Air Pollutants, Joel Craig Johnson

Dissertations and Theses

The subject of this thesis is the development of a laser light source which could be used in an air pollution monitor to measure the average concentration of sulfur dioxide gas over long paths (>1 km). Many of the problems encountered in designing a long-path pollutant monitor such as instrument cost and reliability, the selection of an optimum spectral region for making the measurement, and light losses due to scattering and turbulence, are considered. The result of these considerations together with a survey of available laser light sources suggested that a frequency-doubled dye laser possessed several advantages over other …

The Development And Testing Of A Fluidic/Pneumatic Position Servo, David Lyle Portin

Dissertations and Theses

This thesis reviews the design and analysis of a fluidic/pneumatic position servo. Rolling diaphragm piston actuators are used for the system drive, and a hydrostatic gas journal bearing is used as the position sensor. The servo has a 1 inch range which is monitored using an electrical capacitive position transducer that was built as an integral part of the system.

Open-loop frequency response testing provides the basis for a mathematical model of the system.

The servo response is linear at frequencies up to 3 Hertz.

The frequency response appeared to be limited by the design of the gas bearing sensor, …

The Analysis Of The Deflection And Containment Of A Hot Plume By Side Draft Exhaust Hooding, Douglas H. Macgowan

Dissertations and Theses

A common industrial ventilation and pollution problem results when a thermally buoyant polluted plume of air must be exhausted away from a work area to allow achievement of air pollution standards. Generally, a close fitting canopy hood is one of the most effective means of exhaust containment; however, physical restrictions or the operation itself often prevent such an arrangement, and a hood located to the side of the operation is required. This arrangement requires the exhaust to bend and contain the vertically rising plume with a horizontal sweep of exhaust air across the surface of the operation.

A review of …