Open Access. Powered by Scholars. Published by Universities.®

Applied Mechanics Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 3 of 3

Full-Text Articles in Applied Mechanics

Hitch Cart “Landing Gear”, Rebekah White, Jose Raygoza, Randy Hernandez, Brandon Leon Dec 2024

Hitch Cart “Landing Gear”, Rebekah White, Jose Raygoza, Randy Hernandez, Brandon Leon

Mechanical Engineering

This report aims to allow our sponsor, to review our design process of the Hitch Cart Landing Gear Prototype. In the design overview section of this report, we discuss the primary design modifications we made to the wheel mechanism of the existing hitch cart prototype, including the addition of the ACME screws and the folding brackets. This allows our sponsor to see the intended improvements made to the past prototype and understand the primary goal of our project. Then, in the implementation section, we cover the entire manufacturing process to allow our sponsor to understand what manufacturing steps must be …


Rogue Rotary - Modular Robotic Rotary Joint Design, Sean Wesley Murphy, Tyler David Riessen, Jacob Mark Triplett Dec 2017

Rogue Rotary - Modular Robotic Rotary Joint Design, Sean Wesley Murphy, Tyler David Riessen, Jacob Mark Triplett

Mechanical Engineering

This paper describes the design process from ideation to test validation for a singular robotic joint to be configured into a myriad of system level of robots.


Lightweight Uav Launcher, Ben Miller, Christian Valoria, Corinne Warnock, Jake Coutlee Jun 2014

Lightweight Uav Launcher, Ben Miller, Christian Valoria, Corinne Warnock, Jake Coutlee

Mechanical Engineering

This report discusses the design, construction, and testing of a lightweight, portable UAV launcher. There is a current need for a small team of soldiers to launch a US Marine Tier II UAV in a remote location without transport. Research was conducted into existing UAV launcher designs and the pros and cons of each were recorded. This research served as a basis for concept generation during the initial design development stage. It was required that the design weigh less than 110 lbs, occupy a smaller volume than 48" x 24" 18" in its collapsed state, be portable by a single …