Open Access. Powered by Scholars. Published by Universities.®
- Keyword
Articles 1 - 2 of 2
Full-Text Articles in Metallurgy
Application Of 3d Printing Technology In Porous Anode Fabrication For Enhanced Power Output Of Microbial Fuel Cells, Bin Bian
Electronic Thesis and Dissertation Repository
Microbial fuel cells (MFCs) are widely researched for application in wastewater treatment. However, the current anodes used in MFCs often suffer from high fabrication cost and uncontrollable pore sizes. In this thesis, three-dimensional printing technique was utilized to fabricate anodes with different micro pore sizes for MFCs. Copper coating and carbonization were applied to the printed polymer anodes to increase the conductivity and specific surface area. Voltages of MFCs with various anodes were measured as well as other electrochemical tests such as linear sweep voltammetry and electrochemical impedance spectroscopy. 3D copper porous anode produced higher maximum voltages and power densities …
Resonant Spectra Of Metal Nanotoroids Of Various Sizes, Huong Quynh Tran
Resonant Spectra Of Metal Nanotoroids Of Various Sizes, Huong Quynh Tran
Electrical Engineering Undergraduate Honors Theses
Nowadays, the manipulation of light by using metallic nanostructures has wide applications in photonics, optoelectronics and energy conversion. Along with other universities all over the world, the University of Arkansas is researching on nano-antennas’ design, fabrication and applications. Current research in Dr. El-Shenawee’s Terahertz Imaging and Spectroscopy Computational Electromagnetics Group, has computationally investigated the behaviors of plasmonic nanostructures by using the commercial finite element electromagnetic solver Ansys® HFSS. This work reproduced the previous work of spectral absorption enhancement of infinite and finite arrays of silver and gold nanotoroids with sizes of the inner radii: 13nm – 21nm, while outer radius …