Geological Engineering Commons^™

Discrete Element Modeling Of Granular Soils: Critical State Behavior Applied To Impact Pile Driving, Esteban Patino Marin

Graduate Studies Theses and Dissertations 2026

This thesis investigates the use of the Discrete Element Method (DEM) to study two complementary aspects of granular soil mechanics: critical state behavior of granular materials and dynamic response of driven piles in sand, both of which are governed by the same particle-scale mechanisms of dilation, contraction, and fabric evolution.

The first examines the critical state behavior and fabric anisotropy of granular soils through DEM simulations of direct shear, direct simple shear, and true triaxial tests. Sphere-cluster particles representative of a uniform sand are used in two assemblages of approximately twenty-five thousand and one hundred twenty-five thousand spheres to evaluate …

Detecting Electrical Submersible Pump (Esp) Failures And Estimating Run Life Using Artificial Neural Networks, Mostafa Ahmed Sobhy

Theses and Dissertations

Electric Submersible Pumps (ESPs) are one of the important artificial lift methods for sustaining production in mature and high-water-cut wells; but may suffer frequent failures due to mechanical, electrical, hydraulic, chemical, and operational failures. These failures can yield substantial deferred production and intervention costs. Plenty of ESP installations are fitted with downhole sensors. Yet, it is observed that the current industry practice underutilizes the wealth of available sensor and operational data and lacks standardized, explainable failure-type identification and classification.

In this thesis, a comprehensive Machine Learning (ML) and Deep Learning (DL) framework was introduced for ESPs that simultaneously estimates remaining …

Evaluation Of Practical Methods To Determine If A Karst Creek Is Gaining Or Losing: Case Study Of Leith Creek, Elizabeth Jones

Graduate Theses/Dissertations

Karst landscapes are abundant in Missouri, with features such as caves, springs, and sinkholes that form through the dissolution of limestone. Leith Creek is a small stream in Polk County, Missouri fed by two springs and the shallow unconfined Springfield Plateau aquifer, a highly karstified aquifer which is made up of limestone and minor interbedded shale-mudstone units. To determine if Leith Creek is gaining or losing, stream flow, water chemistry and temperature sensors were monitored. Stream flow results required multiple visits to take measurements while temperature sensors required two visits, one to install the dataloggers and another to remove the …

Applications Of Reservoir Simulation And Machine Learning In Subsurface Energy Systems For Decarbonization, Seyedmohammadmehdi Nassabeh

Theses: Doctorates and Masters

The transition to a low-carbon future necessitates innovative approaches to carbon management and hydrogen storage, particularly in the context of enhanced oil recovery (EOR) from hydrocarbon reservoirs. This study employs advanced analytics and machine learning techniques to optimize carbon management strategies. One key focus of this research is to evaluate the effectiveness of flue gas and CO2 in Water Alternating Gas (WAG) injection within a homogeneous fractured carbonate reservoir characterized by low porosity and permeability. A computational model was developed to depict the flow regime in the reservoir and simulate reservoir fluid behavior using Eclipse (E300) software, various hybrid EOR …

Simulation Of Wave Propagation In Granular Particles Using A Discrete Element Model, Syed Tahmid Hussan

College of Graduate Studies: Theses & Dissertations

The understanding of Bender Element mechanism and utilization of Particle Flow Code (PFC) to simulate the seismic wave behavior is important to test the dynamic behavior of soil particles. Both discrete and finite element methods can be used to simulate wave behavior. However, Discrete Element Method (DEM) is mostly suitable, as the micro scaled soil particle cannot be fully considered as continuous specimen like a piece of rod or aluminum. Recently DEM has been widely used to study mechanical properties of soils at particle level considering the particles as balls. This study represents a comparative analysis of Voigt and Best …

Multi-Mode Regulation Of The Drying Process Of Industrial Gas, Isamidin Xakimovich Sidikov Pr, Nashvandova Gulruxsor Murot Qizi Phd

Technical science and innovation

Currently, much attention is paid to the issue of energy efficiency of gas processing enterprises. The continuous growth of world prices for energy resources requires constant improvement of the management system, providing the most optimal conditions for the flow of technological processes. A conceptual model of the heat-mass transfer process occurring in the absorber as an object of research has been developed, which characterizes the relationship of the variables involved in the drying process of natural gas, control, measurable and immeasurable, as well as controlled parameters have been selected, which are used to develop and study a mathematical model of …

Beirut Arab University - Faculty Of Engineering - Newsletter Issue 0, Faculty Of Engineering, Beirut Arab University

Engineering Newsletters

No abstract provided.

Energy Dissipation In A Sand Damper Under Cyclic Loading, Ehab Sabi

Civil and Environmental Engineering Theses and Dissertations

Various seismic and wind engineering designs and retrofit strategies have been in development to meet structures' proper and safe operation during earthquake and wind excitation. One such method is the addition of fluid and particle dampers, such as sand dampers, in an effort to reduce excessive and dangerous displacements of structures. The present study implements the discrete element method (DEM) to assess the performance of a pressurized sand damper (PSD) and characterize the dissipated energy under cyclic loading. The idea of a PSD is to exploit the increase in shearing resistance of sand under external pressure and the associated ability …

A Review Of Current Construction Guidelines To Inform The Design Of Rammed Earth Houses In Seismically Active Zones, David Thompson, Charles Augarde, Juan Pablo Osorio

Articles

Sustainability in the materials we use for construction is a prime concern, focusing on reducing the embodied energy and carbon footprints of the materials used. The cement used in concrete products is responsible for a significant proportion of Man's CO2 emissions and its production requires substantial energy input, as do fired clay products. For this reason, products formed from unfired earthen materials are of increasing interest and the current challenges include devising means of robust design for strength and to address durability concerns. One form of earthen construction that employs an in-situ method is rammed earth, and it is a …

Investigating The Possibility Of Using Smelted Water-Cooled Copper Slag Regolith As A Terrestrial Based Lunar Regolith Simulant, Scott A. Morley

Graduate Theses & Non-Theses

There is a need for a stable, efficient, and cost-effective option of a terrestrial lunar regolith simulant that can be easily made and at a lower cost to the consumer. A lunar regolith is the layer of unconsolidated rocky material covering bedrock that is on planets. All simulants fabricated for the moon, are based off three types of lunar regolith areas. The first is the lunar highlands which are the high areas of the moon, these areas are anthracitic. The second is lunar mare which is the meteoroid bombarded areas of the moon that look like dark grey areas from …

Treatment Of Mine Tailings Through Two Methods Of Calcite Precipitation: (I) Using Natural Mineral Trona, (Ii) Microbially Induced Calcite Precipitation Via Denitrification, Nathaniel Small

Graduate Theses & Non-Theses

Mine tailings not only pose environmental risks such as dust emission and acid mine drainage but also present geotechnical risks in cases of tailings dam failures which could lead to loss of human life and severe damages to infrastructure. In-situ cementation of tailings has the potential to reduce the risks associated with such failures as well as the related environmental problems. Over the years, different methods of chemically and microbially induced cementation of tailings have been examined many of which have shown promising results on a laboratory scale and some even on a ϐield scale. In this paper, a new …

Development Of A Marine Biodegradable Target Balloon, Blake Samuel Robinson, Arash Sam Akhavi, David Leonardo Albarran-Martinez

Materials Engineering

The US Navy utilizes PVC target balloons, known as Killer Tomatoes, that are inflated onboard a naval vessel then deployed into the ocean to calibrate a variety of weaponry. The Navy has requested the investigation of biodegradable polymers to replace the PVC in attempts to reduce ocean waste that is generated from the leftover PVC material. After communicating with American Pacific Plastic Fabricators (APPF), the current manufacturer of the Killer Tomatoes, we gained an understanding of the manufacturing process and the material requirements that would allow a new material to be integrated into their current process. Two proprietary, trial polymers …

Characterization Of Landslide Processes From Radar Remote Sensing And Hydromechanical Modeling, Yuankun Xu

Earth Sciences Theses and Dissertations

Landsides are a natural geomorphic process yet a dangerous hazard which annually causes thousands of casualties and billions of property loss in a global scale. Understanding landslide motion kinematics from early initiation to final deposition is critical for monitoring, assessing, and forecasting landslide movement in order to mitigate their hazards. Landslides occur under diverse environmental settings and appear in variable types; however, all types of landslides can be mechanically attributed to shearing failure at the basal surface due to stress regime shift contributed by internal and/or external forcing. Typical internal factors include soil/rock weathering, whereas typical external triggering forces encompass …

Flooding, Landslides, Wildfires, Air Pollution, And Income: Risk In California, Brittany Bondi, Alyssa J. Kaewwilai

Gettysburg Social Sciences Review

California is infamously known for its likelihood of environmental hazards such as flooding, landslides, air pollution, and forest fires which can be attributed to the natural climate of the area as well as anthropologically influenced climate change. Air pollution also poses potential threats and dangers to the civilians of California as increasing populations and uses of fossil fuels continue to contribute to the growing issue of climate change. The goal of this study was to examine and analyze the geospatial trends environmental hazards in California such as landslides, air pollution, flooding, and forest fires. A weighted test, zone and slope …

Experimental Investigation Of And Constitutive Model For The Thermo-Poro-Mechanical Deformation Of Granular Salt Under Hydrostatic Compression, Brandon C. Lampe

Civil Engineering ETDs

The influence of pore pressure and porosity on the ductile deformation of granular salt was experimentally investigated under hydrostatic compression. Confining and pore pressures were independently controlled while granular salt samples exhibited rate-dependent deformation that resulted in large decreases of sample volume and porosity. The sample deformation rates were observed to correspond with both the sample porosity and the pressure difference between the confining and pore pressures. Post-test observations revealed that the reduced porosity was caused by the solid particles deforming in a ductile manner. Insight into the cause of ductile deformation was gained by considering the local stress distribution …

An Analysis Of Common Drill Stem Vibration Models, Mohammed F. Al Dushaishi, Runar Nygaard, Daniel S. Stutts

Geosciences and Geological and Petroleum Engineering Faculty Research & Creative Works

Excessive drill stem (DS) vibration while rotary drilling of oil and gas wells causes damages to drill bits and bottom hole assemblies (BHAs). In an attempt to mitigate DS vibrations, theoretical modeling of DS dynamics is used to predict severe vibration conditions. To construct the model, decisions have to be made on which beam theory to be used, how to implement forces acting on the DS, and the geometry of the DS. The objective of this paper is to emphasize the effect of these assumptions on DS vibration behavior under different, yet realistic, drilling conditions. The nonlinear equations of motion …

The Fractal Dimension As A Measure Of The Roughness Of Rock Discontinuity Profiles, Y. H. Lee, J. R. Carr, David J. Barr, Charles J. Haas

Geosciences and Geological and Petroleum Engineering Faculty Research & Creative Works

An important factor in the analysis of deformation and failure of rock masses along discontinuities is the roughness of the jointing surfaces. The fractal dimension is proposed as a method of objectively quantifying the roughness profile of such discontinuities. With this method much less engineering judgement and experience are required in determining the surface roughness,sb than is required for other methods such as the widely used joint roughness coefficient (JRC) suggested by the International Society for Rock Mechanics [1] (Int. J. Rock. Mech. Min. Sci. & Geomech. Abstr. 15, 319-368, 1978). The fractal dimension, suggested by Mandelbrot [2] (Fractals-Form, Chance …