Power and Energy Commons^™

Implementation Of Sic Power Electronics For Green Energy Based Electrification Of Transportation, Naireeta Deb

All Dissertations

Increase in greenhouse gas emission poses a threat to the quality of air thus threatening the future of living beings on earth. A large part of the emission is produced by transport vehicles. Electric vehicles (EVs) are a great solution to this threat. They will completely replace the high usage of hydrocarbons in the transport sector. Energy efficiency and reduced local pollution can also be expected with full implementation of electrification of transportation. However, the current grid is not prepared to take the power load of EV charging if it were to happen readily. Moreover, critics are doubtful about the …

Modeling Supercritical Fluids And Fabricating Electret Films To Address Dielectric Challenges In High-Power-Density Systems, Farhina Haque

Theses and Dissertations

Wide bandgap (WBG) devices and power electronic converters (PEC) that enable the dynamic control of energy and high-power density designs inevitably contain defects including sharp edges, triple points, and cavities, which result in local electric field enhancements. The intensified local electric stresses cause either immediate dielectric breakdown or partial discharge (PD) that erodes electrical insulators and accelerates device aging. With the goal of addressing these dielectric challenges emerging in power-dense applications, this dissertation focuses on 1) modeling the dielectric characteristics of supercritical fluids (SCFs), which is a new dielectric medium with high dielectric strength and high cooling capability; and 2) …

Load Modeling And Evaluation Of Leds For Hardware Test Bed Application, Jillian M. Ruff

Masters Theses

The lighting industry was revolutionized with the emergence of LED lighting. Over the last 15 years, LED lighting device sales and utilization have grown immensely. The growth and popularity of LEDs is due to improved operation of the device when compared to previous lighting technologies. Efficient performance of the device is critical due to the growth of global energy consumption.

As nonrenewable generation fuel is finite, utilities have begun the transition to renewable energy generation. Generation and distribution systems become inherently complex to comprehend and maintain with incorporation of emerging supply and load technologies. With the unprecedented growth of LED …

Smart Usb-C Wall Plug For The Dc House Project, Ridge Lahti, Dino Maslic

Electrical Engineering

DC operated devices and appliances powered by AC systems suffer inefficiencies resulting from the losses of converting AC energy into DC energy. At Cal Poly, the DC House Project aims to minimize the need for AC electricity in homes and encourage the use of renewable energy systems. The DC House uses a 48V DC bus that must be stepped down for use with increasing number of DC loads in a typical home. In this project, a Smart USB-C Wall Plug is designed to work with USB Power Delivery to provide a variable voltage output for use with these DC loads …

Current-Source Dc-Dc Converter For Fiber-Optic Communication Systems, Jissell C. Jose

Master's Theses

In this thesis, a proof of concept for a current-source DC-DC converter for powering sensors used in an underwater communications system is presented. The proposed converter steps down an input current of 0.9 A to 0.625 A, while maintaining an output voltage of 24 V and output power of 15 W. The complete steady-state analysis and design of the proposed converter in its single-stage form is also explained in detail. Performance evaluation of the proposed converter was carried out using LTspice. Results of the simulation demonstrate that the design was able to produce average output current of 0.639 A at …