Power and Energy Commons^™

Development Of Si Device Based Power Converters For High Temperature Operation In Hev Applications, Zhuxian Xu

Doctoral Dissertations

In this dissertation, the feasibility of operating Si devices at 200 ˚C [degree Celsius] is investigated and the guidelines on the development of a high temperature Si converter for operating with 105 ˚C high temperature liquid coolant in hybrid electrical vehicle (HEV) applications are provided.

First, the characterization of a Si IGBT operating at 200 ˚C junction temperatures is presented. It is shown that the commercial 175 ˚C Si IGBT under test can be successfully switched at an elevated junction temperature of 200 ˚C with increased but acceptable losses.

Second, a comprehensive evaluation of Si IGBT ruggedness at high temperature …

Wide-Area Measurement And Applications In Power System Dynamic Modeling And Control, Yong Liu

Doctoral Dissertations

Synchrophasor has been becoming the foundational element of power grid wide-area measurement system (WAMS) since first developed in 1980s. By utilizing global positioning system (GPS) time synchronization technique, synchrophasors offer highly accurate time-synchronized phasor measurements that can provide system operators with real-time information of operation status.

Frequency disturbance recorders (FDRs) are installed on the distribution level to measure power system dynamics and considered as a type of single-phase synchrophasors. In this dissertation, a detailed procedure for the FDRs’ calibration is summarized and a preliminary test of their dynamic performance is carried out. Moreover, this dissertation investigates the impact of GPS …

All-Sic Three-Phase Converters For High Efficiency Applications, Fan Xu

Doctoral Dissertations

The dissertation aims to improve the efficiency of three-phase converters using SiC power devices.The methodology to design a high efficiency all-SiC three-phase converter is presented. Four aspects are included: SiC power device evaluation, power loop parasitics analysis, high efficiency current source rectifier, and paralleled current source rectifier system.

The SiC JFET and MOSFET are tested based on voltage source and current source structures respectively. The dissertation proposes a device switching test circuit based on current source topology to simulate current commutation processes. The circuit can evaluate the switching performance and calculate switching loss of a power device used in a …

Arm Inductance And Sub-Module Capacitance Selection In Modular Multilevel Converter, Yalong Li

Masters Theses

Arm inductor and sub-module (SM) capacitor are two key components in the modular multilevel converter (MMC). Optimizing the selection of arm inductance and sub-module capacitance is thus critical for the converter design. This report aims at developing a selection principle for arm inductance and sub-module capacitance in MMC.

Arm inductors in MMC are used to limit the circulating current which flows within the converter. The switching frequency harmonic is found to be the dominant component in the circulating current when an active circulating current suppressing controller is implemented. The analytical relationship between the arm inductance and switching frequency circulating current …

An Occupant-Based Dynamic Simulation Tool For Predicting Residential Power Demand And Quantifying The Impact Of Residential Demand Response, Brandon Jeffrey Johnson

Masters Theses

With their large impact on the power system and widespread distribution, residential loads provide vast resources that if utilized correctly have the potential to help reduce both electricity cost and demand throughout the day. Previous research in this area has been primarily focused on building more energy efficient homes and improving the efficiencies of appliances and lighting technologies. Far less attention has been given to the ability of residential loads to provide various demand response services. Residential loads with demand response capabilities have the potential to be very useful in both peak shifting and regulation applications, and could be utilized …

Optimal Distribution Reconfiguration And Demand Management Within Practical Operational Constraints, Benyamin Moradzadeh

Doctoral Dissertations

This dissertation focuses on specific aspects of the technical design and operation of a `smart' distribution system incorporating new technology in the design process. The main purpose of this dissertation is to propose new algorithms in order to achieve a more reliable and economic distribution system.

First, a general approach based on Mixed Integer Programming (MIP) is proposed to formulate the reconfiguration problem for a radial/weakly meshed distribution network or restoration following a fault. Two objectives considered in this study are to minimize the active power loss, and to minimize the number of switching operations with respect to operational constraints, …

Control Studies Of Dfig Based Wind Power Systems, Zhiqiang Jin

Doctoral Dissertations

Wind energy as an outstanding and competitive form of renewable energy, has been growing fast worldwide in recent years because of its importance to reduce the pollutant emission generated by conventional thermal power plants and the rising prices and the unstable supplies of fossil-fuel. However, in the development of wind energy, there are still many ongoing challenges.

An important challenge is the need of voltage control to maintain the terminal voltage of a wind plant to make it a PV bus like conventional generators with excitation control. In the literature with PI controllers used, the parameters of PI controllers need …

Novel Applications For Phasor Measurement Units And Synchrophasor Data, Bradley Kerwin Greene

Masters Theses

The last decade has seen an intensified effort towards an improved, technologically advanced electric grid. This effort is largely in part to the need for cleaner and renewable sources of energy. Another motivator for this “smarter grid” is the need for a more reliable and efficiently operated of the wide scale electric infrastructure. The impact of these changes can expect to be seen at both the transmission and distribution level. At the transmission level phasor measurement units and synchrophasor data has emerged as one of the most enabling technologies for the smart grid movement. These devices measure and time synchronize, …

Short-Term Electrical Load Forecasting For An Institutional/Industrial Power System Using An Artificial Neural Network, Eric Lynn Taylor

Masters Theses

For optimal power system operation, electrical generation must follow electrical load demand. The generation, transmission, and distribution utilities require some means to forecast the electrical load so they can utilize their electrical infrastructure efficiently, securely, and economically. The short-term load forecast (STLF) represents the electric load forecast for a time interval of a few hours to a few days. This thesis will define STLF as a 24-hour-ahead load forecast whose results will provide an hourly electric load forecast in kilowatts (kW) for the future 24 hours (a 24-hour load profile).

This thesis will use the method of Artificial Neural Networks …

Control Of Solar Photovoltaic (Phv) Power Generation In Grid-Connected And Islanded Microgrids, Sarina Adhikari

Doctoral Dissertations

With the ever increasing electricity demand, fast depletion of fossil fuel and the growing trend towards renewable energy resources, the integration of green distributed energy resources (DERs) such as solar photovoltaic (PhV) generation and wind power in the utility grid is gaining high popularity in the present years. The capability of these modular generators needs to be harnessed properly in order to achieve the maximum benefit out of such integrated systems. Most DERs are connected to the utility grid or microgrids with the help of power electronics interface. They are capable of producing both active and reactive power with the …

Vehicle-To-Grid (V2g) Reactive Power Operation Analysis Of The Ev/Phev Bidirectional Battery Charger, Mithat Can Kisacikoglu

Doctoral Dissertations

More battery powered electric vehicles (EVs) and plug-in hybrid electric vehicles (PHEVs) will be introduced to the market in 2013 and beyond. Since these vehicles have large batteries that need to be charged from an external power source or directly from the grid, their charging circuits and grid interconnection issues are garnering more attention.

It is possible to incorporate more than one operation mode in a charger by allowing the power to flow bidirectionally. Usually, the bidirectional power transfer stands for two-way transfer of active power between the charger and the grid. The general term of sending active power from …