Power and Energy Commons^™

Analysis And Optimization Of The Two-Phase Series Capacitor Buck Dc-Dc Converter, Salahaldein Ali Aboajila Ahmed

Graduate Theses and Dissertations

Current sharing schemes for conventional multi-phase converters are based on sensing each phase current to deliver the current information to their controllers. In conventional buck converters, this fact may require a preset current sharing ratio at the expense of efficiency, which eventually requires a larger sensing circuit to achieve the sensing accuracy of each phase. Introducing the concept of automatic current sharing is one of the solutions to tackle this issue. Automatic current sharing (Current Sharing Mechanism CSM) is an advanced way to distribute heat generation in multi-phase switching topologies at full load. A two-phase series capacitor buck converter (2-pscB) …

Design And Control Of High Power Density Motor Drive, Dong Jiang

Doctoral Dissertations

This dissertation aims at developing techniques to achieve high power density in motor drives under the performance requirements for transportation system. Four main factors influencing the power density are the main objects of the dissertation: devices, passive components, pulse width modulation (PWM) methods and motor control methods.

Firstly, the application of SiC devices could improve the power density of the motor drive. This dissertation developed a method of characterizing the SiC device performance in phase-leg with loss estimation, and claimed that with SiC Schottky Barrier Diode the advantage of SiC JFET could benefit the motor drive especially at high temperature. …

Pulse Density Modulated Soft Switching Cycloconverter, Jesse Timothy Adamson

Master's Theses

Single stage cycloconverters generally incorporate hard switching at turn on and soft switching at turn off. This hard switching at turn on combined with the slow switching speeds of thyristors (the switch of choice for standard cycloconverters) limits their use to lower frequency applications.

This thesis explores the analysis and design of a pulse density modulated (PDM), soft switching cycloconverter. Unlike standard cycloconverters, the controller in this converter does not adjust thyristor firing angles. It lets only complete half cycles of the input waveform through to the output. This allows and requires a much greater frequency step down from the …