Open Access. Powered by Scholars. Published by Universities.®

Environmental Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Master's Theses

Bioaugmentation

Articles 1 - 3 of 3

Full-Text Articles in Environmental Engineering

Biodegradation Of Methyl Tert-Butyl Ether And Tert-Butyl Alcohol Using Bioaugmentation With Biowish® Aqua, Elizabeth Villanueva Dec 2022

Biodegradation Of Methyl Tert-Butyl Ether And Tert-Butyl Alcohol Using Bioaugmentation With Biowish® Aqua, Elizabeth Villanueva

Master's Theses

Aqua, a commercial product manufactured by BiOWiSH® Technologies, was utilized in this research to study its effectiveness to biodegrade methyl tert-butyl ether (MTBE) and tert-butyl alcohol (TBA). Microcosms containing varying concentrations of MTBE and TBA as well as a growth media and mineral salt solution were examined. Analytical instrumentation used in this study included the use of a gas chromatograph-mass spectrometer (GC/MS) to determine concentrations of MTBE and TBA and a spectrophotometer to extrapolate approximate active biomass concentrations in each experiment. Four different environmental conditions were tested for both MTBE and TBA. The environmental conditions tested for each contaminant included: …


Effect Of Bioaugmentation Product Biowish® Aqua™ On Nitrogen Removal In Wastewater, Patrick Cassidy Kalvass Jun 2018

Effect Of Bioaugmentation Product Biowish® Aqua™ On Nitrogen Removal In Wastewater, Patrick Cassidy Kalvass

Master's Theses

Biological nutrient removal (BNR) from wastewater, and specifically nitrogen removal, is a growing concern to wastewater dischargers such as municipalities. Excess nutrients in effluent can create problems such as eutrophication, toxicity to aquatic life, and dissolved oxygen depletion in receiving waters. BNR systems have been installed in many locations with success, but their operation presents operational and financial demands greater than conventional biological treatment. Nitrogen removal is typically performed in sequential autotrophic nitrification and denitrification, which increases needed energy input, operational complexity, and therefore cost. Simultaneous nitrification-denitrification (SNdN) achieved in a single system has also been successfully implemented, however operational …


Treatment Of Petroleum Hydrocarbons In Oil-Based Drill Cutting Mud Using Biowish Bioaugmentation Products, Diego Jose Cardenas Zepeda Jun 2015

Treatment Of Petroleum Hydrocarbons In Oil-Based Drill Cutting Mud Using Biowish Bioaugmentation Products, Diego Jose Cardenas Zepeda

Master's Theses

The efficacy of BiOWiSHTM-Thai Aqua, a commercially discontinued microbial product, in remediating oil based drill-cutting mud (DCM) was researched in this study. Experimentation was performed directly on DCM and on sand contaminated with oil extracted from DCM. A gas chromatograph-mass spectrometrer and a respirometer were used for analysis of total petroleum hydrocarbons (TPH) and CO2 production respectively. Five experiments were analyzed by TPH extraction and analysis; four experiments were analyzed by respirometric analysis. The specific microcosm conditions tested in the experiments were control, nutrient-only control, and bioaugmentation product.

This study concluded that there might be potential for bioaugmentation of TPH …