Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Environmental Engineering
Development And Validation Of A Tractor Drawbar Force Measurement And Data Acquisition System (Daq), James Roeber, Santosh Pitla, Roger M. Hoy, Joe D. Luck, Michael F. Kocher
Development And Validation Of A Tractor Drawbar Force Measurement And Data Acquisition System (Daq), James Roeber, Santosh Pitla, Roger M. Hoy, Joe D. Luck, Michael F. Kocher
Biological Systems Engineering: Papers and Publications
Matching agricultural tractors to implements towed by the drawbar is one of the important aspects of machinery management for ensuring optimum performance and fuel cost savings. A field deployable tractor draft force measurement and data acquisition system was developed and evaluated as part of this research project. A drawbar instrumented to measure draft force in field operating conditions was developed and statically calibrated. The drawbar was calibrated by applying loads from 4.45 to 134 kN using a hydraulic cylinder connected to a 444.8 kN load cell. Testing was conducted with the drawbar installed on a tractor on a concrete track. …
Tractor Hydraulic Power Data Acquisition System, J. B.W. Roeber, Santosh Pitla, Michael F. Kocher, Joe D. Luck, Roger M. Hoy
Tractor Hydraulic Power Data Acquisition System, J. B.W. Roeber, Santosh Pitla, Michael F. Kocher, Joe D. Luck, Roger M. Hoy
Biological Systems Engineering: Papers and Publications
Tractor hydraulic power is used on a wide range of agricultural implements; however, the availability of operational hydraulic data at points other than full engine throttle position is limited. Operators could utilize this hydraulic data to maximize field efficiency and minimize machinery costs when determining suitable machinery for field operations. A field usable hydraulic test apparatus capable of measuring tractor hydraulic pressure and flow rate data was developed. The goal of this study was to determine if a hydraulic flow and pressure measurement device could be installed on the rear of a tractor to provide implement hydraulic power consumption at …
Comparing Various Hardware/Software Solutions And Conversion Methods For Controller Area Network (Can) Bus Data Collection, Samuel E. Marx, Joe D. Luck, Santosh Pitla, Roger M. Hoy
Comparing Various Hardware/Software Solutions And Conversion Methods For Controller Area Network (Can) Bus Data Collection, Samuel E. Marx, Joe D. Luck, Santosh Pitla, Roger M. Hoy
Biological Systems Engineering: Papers and Publications
Various hardware and software solutions exist for collecting Controller Area Network (CAN) bus data. Digital data accuracy could vary based upon different data logging methods (e.g., hardware/software timing, processor timing, etc.). CAN bus data were collected from agricultural tractors using multiple data acquisition solutions to quantify differences among collection methods and demonstrate potential data accumulation rates. Two types of data were observed for this study. The first, CAN bus frame data, represents data collected for each line of hex data sent from an ECU. One issue with frame data is the resulting large file sizes, therefore a second logging format …