Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Environmental Engineering
Application Of 3d Printing Technology In Porous Anode Fabrication For Enhanced Power Output Of Microbial Fuel Cells, Bin Bian
Electronic Thesis and Dissertation Repository
Microbial fuel cells (MFCs) are widely researched for application in wastewater treatment. However, the current anodes used in MFCs often suffer from high fabrication cost and uncontrollable pore sizes. In this thesis, three-dimensional printing technique was utilized to fabricate anodes with different micro pore sizes for MFCs. Copper coating and carbonization were applied to the printed polymer anodes to increase the conductivity and specific surface area. Voltages of MFCs with various anodes were measured as well as other electrochemical tests such as linear sweep voltammetry and electrochemical impedance spectroscopy. 3D copper porous anode produced higher maximum voltages and power densities …
Modeling Water Quality For Switchgrass Crop Production: Implications For Bioenergy Sustainability In East Tennessee, Zachariah Tzvi Seiden
Modeling Water Quality For Switchgrass Crop Production: Implications For Bioenergy Sustainability In East Tennessee, Zachariah Tzvi Seiden
Masters Theses
With passing of the US Energy Independence and Security Act (EISA) of 2007, there has been considerable research conducted on the sustainability of bioenergy crop production in the United States; switchgrass has shown particular potential for bioenergy production in East Tennessee. Many studies evaluating the environmental impact switchgrass has on runoff and water quality use the Soil and Water Assessment Tool (SWAT) for watershed modeling. Because SWAT is a lumped watershed model, it evaluates the result of hydrological processes for each hydrologic response unit (HRU), without accounting for the physical interactions between these HRUs. The Water Erosion Prediction Project (WEPP) …