Open Access. Powered by Scholars. Published by Universities.®

Biological Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 3 of 3

Full-Text Articles in Biological Engineering

Multiphysics Modeling To Enhance Understanding Of Microwave Heating Of Food In Domestic Ovens, Jiajia Chen Jun 2015

Multiphysics Modeling To Enhance Understanding Of Microwave Heating Of Food In Domestic Ovens, Jiajia Chen

Department of Agricultural and Biological Systems Engineering: Dissertations, Theses, and Student Research

Nonuniform heating is the biggest issue in the microwave heating of prepared meals. Multiphysics based models are promising tools to improve microwave heating uniformity by properly designing the food product. However, limited availability of accurate temperature-dependent material properties, inadequate model prediction accuracy, and high computational power and complexity in model development are three gaps that greatly limited the application of these models in the food industry.

To fill in the gaps, firstly, we developed a multitemperature calibration protocol to measure temperature-dependent dielectric properties (dielectric constant and loss factor). The temperature-dependent dielectric and thermal (thermal conductivity and specific heat capacity) properties …


Identifying Changes In Climatic Trends And The Fingerprints Of Landuse And Landcover Changes In The High Plains Of The Usa, Denis Mutiibwa Jul 2011

Identifying Changes In Climatic Trends And The Fingerprints Of Landuse And Landcover Changes In The High Plains Of The Usa, Denis Mutiibwa

Department of Agricultural and Biological Systems Engineering: Dissertations, Theses, and Student Research

Human activities such as conversion of natural ecosystem to croplands and urban-centers, deforestation and afforestation impact biophysical properties of land surface such as albedo, energy balance, and surface roughness. Alterations in these properties affect the heat and moisture exchanges between the land surface and atmospheric boundary layer. The objectives of this research were; (i) to quantitatively identify the High plains’ regional climate change in temperatures over the period 1895 to 2006, (ii) detect the signatures of anthropogenic forcing of LULC changes on the regional climate change of the High Plains, and (iii) examine the trends in evolving regional latent heat …


Development Of The Mask Scentometer, A Comparison Of Ambient Odor Assessment Methods, And Their Application In Ground Truthing Atmospheric Dispersion Models, Christopher G. Henry Dec 2009

Development Of The Mask Scentometer, A Comparison Of Ambient Odor Assessment Methods, And Their Application In Ground Truthing Atmospheric Dispersion Models, Christopher G. Henry

Department of Agricultural and Biological Systems Engineering: Dissertations, Theses, and Student Research

This dissertation is organized as four stand-alone papers. Paper No. 1 describes the development of the Mask Scentometer and reports dilution ratios measured during use by twelve different people. Dilution ratios at the Mask Scentometer’s five dilution-to-threshold (D/T) settings were found to be 0.35, 1, 2, 4.5 and 18. In Paper No.’s 2 and 4, ambient odor assessment methods were compared in both controlled laboratory conditions and in the field. Laboratory analysis of ambient air samples using dynamic triangular forced-choice olfactometry (DTFCO) did not correlate well with any of the ambient odor assessment methods. Average intensity-predicted D/T was roughly five …