Engineering Commons^™

Mathematical Modeling Of Proton‐Exchange‐Membrane Fuel‐Cell Stacks, Dhanwa Thirumalai, Ralph E. White

Faculty Publications

No abstract provided.

Introduction To Simulation/Optimization Modeling For Groundwater Containment Remediation And (B) Ramifications Of Applying S/O Modeling To Groundwater Containment Remediation, With Case Study Examples, Richard C. Peralta

Civil and Environmental Engineering Faculty Publications

Normal use of a simulation model to develop a groundwater extraction/injection strategy employs the following process: (1) specify management goals, (2) assume a pumping strategy, (3) simulate system response to the pumping strategy, (4) evaluate acceptability of the system responses, (5) repeat steps (2-4) as required. This is a trial and error approach that is unlikely to actually yield the best pumping strategy for complicated problems

Design, Modeling, And Characterization Of Fet-Seed Smart Pixel Transceiver Arrays For Optical Backplanes, David V. Plant, Alain Z. Shang, Marcos R. Otazo, David R. Rolston, Brian Robertson, Harvard Scott Hinton

Electrical and Computer Engineering Faculty Publications

The design, modeling, and characterization of FET-SEED smart pixel transceiver arrays fabricated for application in optical backplanes are presented. Results of digital and analog measurements on 4×4 transmitter arrays and 4×4 receiver arrays, packaged at the printed circuit-board level, will be presented. In addition, these results will be compared to device and circuit models developed for these optoelectronics. Finally, the description of the successful application of these optoelectronics to interconnect two printed circuit boards will be described.

A Direct, Approximate Solution To The Modified Green-Ampt Infiltration Equation, Puneet Srivastava, Thomas A. Costello, Dwayne R. Edwards

Biosystems and Agricultural Engineering Faculty Publications

Accurately predicting the rainfall-runoff process is of vital importance for water quality models as well as for correct design of various types of hydraulic structures. This article presents a method of describing the cumulative infiltration process as an explicit function of time using an approximation to the modified Green-Ampt equation given by Mein and Larson (1971). The resulting equation is helpful in predicting cumulative infiltration and therefore infiltration capacity for computer simulation models. The proposed method takes about 50% less time than the usual iterative technique for the same degree of accuracy. The maximum error due to approximation was 1% …

Application Of Simplified Phosphorus Transport Models To Pasture Fields In Northwest Arkansas, Dwayne R. Edwards, C. T. Haan, Andrew N. Sharpley, John F. Murdoch, Tommy C. Daniel, Philip A. Moore Jr.

Biosystems and Agricultural Engineering Faculty Publications

Runoff transport of phosphorus (P) is often predicted from simple equations with parameters determined from data applicable primarily to row-cropped and fallow cover conditions. The applicability, accuracy, and precision of such P transport prediction equations under pasture situations are less well defined. The objectives of this study were to determine parameters of simplified runoff P transport equations for pasture fields and to assess the accuracy and precision of the equations. Runoff, sediment yield, soluble P transport, and particulate P transport data were collected from four pasture fields in northwestern Arkansas. Runoff event enrichment ratios and extraction coefficients were computed, and …

A Multiphase Mathematical Model Of A Nickel/Hydrogen Cell, Pauline De Vidts

Faculty Publications

No abstract provided.

Diagnosing And Modeling Common-Mode Radiation From Printed Circuit Boards With Attached Cables, James L. Drewniak, Fei Sha, Todd H. Hubing, Thomas Van Doren, J. Shaw

Electrical and Computer Engineering Faculty Research & Creative Works

A procedure for diagnosing and modeling radiation from printed circuit boards with attached cables is presented through a case study of a production model electronic control unit. Procedures for determining EMI antennas, IC sources, and mechanisms by which noise is coupled from the IC source to the antenna are suggested.

Modelling For Optimal Conjunctive Water Management: Irrigated Crop Production Versus Nps Pollution Prevention, O. H. Daza, Richard C. Peralta

Civil and Environmental Engineering Faculty Publications

Conjunctive water management{CWM)involves coordinating use of ground and surface water sources. Agricultural (A) and nonagricultural {NA)users compete for available water of adequate quality. A Simulation/Optimization (S/0) conjunctive water management model was developed to aid estimating the effects of water and environmental management decisions on crop yield and water quality. Included subsystems are groundwater, surface water, reservoir, delivery system, drainage, and A and NA water users. The nonlinear model addresses flows described by nonsmooth piecewise-linear functions which have discontinuous derivatives. Embedded constraints describe all significant subsystem flows. For example 1 deep percolation and runoff from surface irrigation are explicitly described as …

Modeling Power Bus Decoupling On Multilayer Printed Circuit Boards, James L. Drewniak, Todd H. Hubing, Thomas Van Doren, P. Baudendistal

Electrical and Computer Engineering Faculty Research & Creative Works

Power bus decoupling designs on multilayer printed circuit boards must adequately account for the power bus interplane capacitance and its consequences for the design. Lumped element models for a power bus on a multilayer printed circuit board where an appreciable or entire portion of a layer is devoted to power and ground have been developed. The models are applicable below the distributed resonances of the board. Analytical, circuit simulation, and experimental studies have been conducted to test the models, investigate the effects of the distributed interplane capacitance of the power bus, and the effect of interconnect inductance associated with surface-mount …

A Check Parameter Method For Use In Designing Relays, H Kadete

Tanzania Journal of Engineering and Technology (TJET)

Low quality magnetic steel available locally has been successfully used as core material for a relay. New design principles as well as construction procedure used in development of a prototype are presented. Then the new approach is assessed and found to deliver acceptable accuracy.

Modeling Technique For Optimal Recovery Of Immiscible Light Hydrocarbons As Free Product From Contaminated Aquifer, Grant S. Cooper Jr., Richard C. Peralta, Jagath J. Kaluarachchi

Civil and Environmental Engineering Faculty Publications

Contamination sites associated with light non-aqueous phase liquids {LNAPL) are numerous and represent difficult cleanup problems. Remediation methods for cleanup of LNAPL fluids in subsurface systems are continuously evolving with the development of various technologies for pump.-and~treat, soil venting, and in-situ bioremediation. Evaluating the effectiveness of remediation techniques as well as attempting to improve their efficiency has been a focus of many researchers, These efforts have included the development of computer simulation models to predict and analyze the fluid movement, entrapment, and mobilization of three~phase systems in porous media. The capability of computer models that not only simulate but optimize …

Practical Optimization Modeling For Contaminant Plume Management, Richard C. Peralta, Alaa H. Aly

Civil and Environmental Engineering Faculty Publications

Simulation/optimization (S/0) models can be used to greatly speed the process of computing desirable groundwater pumping strategies for plume management. They make the process of computing optimal strategies fairly straightforward and can help minimize the labor and cost of groundwater contaminant clean-up.

Ground-Water Policy-Making Support: Usem Optimization Modelling Plus Gis And Graphics, Richard C. Peralta, Christopher M. U. Neale, Ali Gharbi, Mazibur Khan, Oscar Daza, Douglas Ramsey, Kurt Vest

Civil and Environmental Engineering Faculty Publications

A support tool for ground-water management decision making involves integration of a multiobjective optimization model, GIS and graphics software. Two results are improved consideration of spatial data within the optimization model and improved conversion of optimal strategies to real-world application. Another result is improved visualization of the trade-offs involved between conflicting management goals.

Hydrodynamic Stability Of The Breakwater Extension At Rrviksand, Norway, Alfonse Dubi

Tanzania Journal of Engineering and Technology (TJET)

The fishing port of Årviksand in Norway, which is situated on an open coast, is artificially harboured by breakwaters. The northern and southern breakwaters which were built in 1930—ies and 1950—ies respecti vely have been on several occasions damaged by heavy storms. This resul ted in the need for further protection by extending the northern breakwater. This paper describes one of the hydrodynamic tests on the breakwater extension. The breakwater, with a berm breakwater concept design, is subjected to the joint probability of sea level elevation and wave heights (in other 'fatigue" test). words , It is found that cover …

Selected Legal Issues Relating To Application Of American Water Development, Inc., Case No. 86 Cw 46, Water Division No. 3, Colorado, Charles B. White

Uncovering the Hidden Resource: Groundwater Law, Hydrology, and Policy in the 1990s (Summer Conference, June 15-17)

13 pages.

Compact – A Reclamation Soil Compaction Model Part I. Model Development, Ronald L. Bingner, Larry G. Wells

Biosystems and Agricultural Engineering Faculty Publications

A physically based, event oriented soil compaction model, known as COMPACT, was developed as a management or research tool to evaluate the effect of surface mining systems on compaction of soil material during reclamation. Simulation of compaction throughout the soil profile at a surface mining reclamation site requires information describing how equipment moves on the site. The compaction processes that are caused by vehicles throughout the soil profile are described by applying the pressure distribution of the surface contact area of a tire or track to determine stresses in the soil profile. A virgin compression curve is then used to …

Compact – A Reclamation Soil Compaction Model Part Ii. Sensitivity Analysis And Applications, Ronald L. Bingner, Larry G. Wells

Biosystems and Agricultural Engineering Faculty Publications

COMPACT, a physically based, event-oriented compaction model, was developed as a management or research tool to evaluate the influence of a surface mining system on compaction of soil material during reclamation. Two systems of area mining reclamation operations were simulated by COMPACT. The first system involved scrapers and bulldozers and the second also included trucks. Scrapers or trucks were used to pick up and deposit the soil material. Bulldozers were then used to shape the site for reclamation. The simulated results were compared with measured results and show how equipment patterns and soil parameters can affect overall soil compaction. This …

The Hydraulic Performance Of A Vortex Tube Foector, F Mtaro

Tanzania Journal of Engineering and Technology (TJET)

The vorle.r tube silt exrrac/or consists of a pipe, rhe crest of which has a slit and lies flush across lhe canal bed.With minimal warer loss, I.oe bedload is extracted through lhe slil settling canal back ro the river, thus reducing or eliminating the bedload transported in main canal. Ihe resulting swirling flow phenomena is of complex nature and depends on sc conirol paramerers, as a result of which previous empirical design approaches have yielded conflicting guidelines. By means Of a simplified hydraulic system, the flow mechanism and energy in rhe can be determined.

Development Of A Combined Quantity And Quality Model For Optimal Unsteady Groundwater Management, Richard C. Peralta, J. Solaimanian, C. L. Griffis

Civil and Environmental Engineering Faculty Publications

Presented are alternative techniques for including conservative solute transport within computer models for optimizing groundwater extraction rates. Unsteady two-dimensional flow and dispersed conservative solute transport are assumed. Comparisons are made of the practicality of including modified forms of implicit and explicit finite difference solute transport equations within optimization models. These equations can be calibrated and subsequently used within a MODCON procedure. The MODCON modelling procedure consists of an integrated series of five optimization or simulation modules. The procedure is applicable for either an entire aquifer system or for a subsystem of a larger system. The first module, A, computes physically …

Generalized Linear Inversion Using Tau-P Forward Modeling, Stephen Dade Walker

Graduate Theses

The Generalized Linear Inversion (GLI) method is used in conjunction with a tau-p forward model to successfully perform inversions of test and real-data examples. All data examples used are one-dimensional velocity profiles that represent several different cases. The stability of the technique is demonstrated in all the test-data sets. The use of simple models and wel1-control 1ed test data results in a minimum of iterations of the inversion process. Different levels of perturbation of the model and test-data examples are used to reveal insight into the robust nature of the inversion.

Computational Aspects Of Chance‑Constrained Regional Modeling, R. R.A. Cantiller, Richard C. Peralta

Civil and Environmental Engineering Faculty Publications

A methodology that incorporates the stochasticity of an aquifer parameter in a chance-constrained steady-state groundwater management model is presented. Results and computational aspects of the modeling effort are discussed.

A Method Of Modeling Multirate Two-Dimensional Recursive Digital Filters Author, Albert P. Gerheim

Electrical & Computer Engineering Theses & Dissertations

This dissertation presents a method of modeling two dimensional sampled data systems with two sampling rates in each dimension. This methodology is applied to the problem of synthesizing two dimensional velocity filters using one dimensional prototypes and multirate concepts.

The modeling method includes the replacement of scalar z-transforms of signals by vectors of polynomials, and the replacement of scalar z-transforms of impulse responses by matrices of polynomials.

The synthesis of velocity filters is accomplished through the use of coordinate transformations in the z-transform domain which skew the ω₁ -ω₂ axes on the unit bidisc. The filters synthesized using …