Engineering Commons^™

Frp Rebar (Afrp, Cfrp, Gfrp), Purdue Ect Team

ECT Fact Sheets Archive

Insufficient concrete cover, poor design or workmanship, and presence of large amounts of aggressive agents including environmental factors all can lead to cracking of the concrete and corrosion of the steel rebar. The problems of steel corrosion are avoided with the use of FRPs because FRP materials are nonmetallic and noncorrosive. In addition, FRP materials exhibit several properties including high tensile strength, that make them suitable for the use as structural reinforcement. Furthermore, codes and design guide provisions have been recently prepared for the use of FRP bars in concrete structures for bridges and buildings.

Electrochemical Chloride Extraction, Purdue Ect Team

ECT Fact Sheets Archive

Conventional methods to deal with chloride-contaminated concrete require the removal of the contaminated concrete and replacement with uncontaminated concrete. These methods are noisy, dirty, time consuming, costly, and in some cases structurally detrimental. The Norcure system is a rehabilitation method developed to remove salt (chloride ions) from salt contaminated concrete structures without damaging the concrete. The removal of chloride ions stops the corrosion of embedded reinforcing steel and greatly extends the service life of salt contaminated structures.

Dis Seismic Isolater, Purdue Ect Team

ECT Fact Sheets Archive

Seismic isolation bearings isolate a structure from the ground motion produced by an earthquake. The energy absorption devices are designed to absorb the energy associated with an earthquake. This seismic (Base) Isolator consists of alternate layers of rubber and steel bonded together, with a cylinder of pure lead tightly inserted through a hole in the middle. The rubber layers allow the isolator to easily displace sideways, reducing the earthquake loads felt by the building and its occupants. They also act as a spring, ensuring that the structure returns to its original position after the shaking has stopped.

Dynamic Construction Visualizer, Purdue Ect Team

ECT Fact Sheets Archive

The Dynamic Construction Visualizer (DCV) is general-purpose 3D visualization system that allows simulation model developers to animate modeled operations with chronological and spatial accuracy in 3D virtual space. The system is independent of any particular simulation-modeling program or CAD modeling software.

Superpave System, Purdue Ect Team

ECT Fact Sheets Archive

The Superpave is the acronym for 'SUperior PERforming Asphalt PAVEments' system. It was developed by Strategic Highway Research Program (SHRP) to give highway engineers and contractors the tools they need to design asphalt pavements that will perform better under extremes of temperature and heavy traffic loads.

Prosidyc: Simulation Program For Construction Operations, Purdue Ect Team

ECT Fact Sheets Archive

PROSIDYC is a system for simulating construction operations jointly developed by the Planning and Methods Unit of Dragados y Construcciones, Madrid, Spain and the Division of Construction Engineering & Management at Purdue University. PROject SImulation Dragados Y Construcciones (PROSIDYC) is a computer based system for analyzing construction job site production processes. It is used to improve productivity in the field by studying resource utilization and cycle times and identifying opportunities for production improvement. PROSIDYC uses the CYCLic Operations NEtwork (CYCLONE) modeling format originally developed by Daniel W. Halpin

Stroboscope, Purdue Ect Team

ECT Fact Sheets Archive

STROBOSCOPE is an acronym for STate and Resource Based Simulation of COnstructionProcEsses. It is a general-purpose simulation programming language that has been designed for the simulation of very complex construction processes that involve many different types of resources. STROBOSCOPE models are based on a network of interconnected modeling elements and on a series of programming statements that give the elements unique behavior and control the simulation.

3d Laser Scanning & Modeling System, Purdue Ect Team

ECT Fact Sheets Archive

Traditional methods of measuring and modeling the surface geometry of large, complex structures or sites that require engineering or survey-grade accuracy are often inaccurate, incomplete or expensive. Inaccurate or incomplete drawings and models often lead to costly construction errors or delays. A portable, auto-scanning laser and PC system that lets users economically obtain accurate, complete, and timely as-built geometry information for large structures and sites. The system can remotely measure natural surfaces up to 100m away at the speed of 800 points per second. With spacing between adjacent points as fine as 1mm, users can capture an extremely high level …

Extraction Of Contaminated Soil Using High Pressure Jet Grouting, Purdue Ect Team

ECT Fact Sheets Archive

Removal of contaminated soil underneath existing structures causes settlement. There is a need for a remediation technology that eliminates this problem. The jet grouting by the triple rod system can be combined with an on site remediation technology (e.g., soil washing). Jet grouting was developed primarily for underpinning and/or excavation support. The benefits of this technology lie in the future reduction of structural settlement, and site access flexibility.

Bs News

Building Services Engineering

No abstract provided.

Semantic 3d Cad And Its Applications In Construction Industry — An Outlook Of Construction Data Visualization, Zhigang Shen, Raja R. A. Issa, Linxia Gu

Department of Construction Engineering and Management: Faculty Publications

In response to the need of using electronic design data directly in construction management applications, many CAD developers have started implementing semantic data models in their CAD products using industry foundation classes (IFCs). While helpful, these semantic CAD applications have limitations when used in actual construction practices. The case studies in the thesis indicated that: 1) the semantics of the current data model (IFC as an example) is not rich enough to cover the richer details of the real trade practices; 2) the current implementation of the semantic data model lacks the mechanism to provide multiple trades views at various …

Increasing Effectiveness Of Public Private Partnerships In The Irish Construction Industry, Louis Gunnigan

Doctoral

By 2003 the first Irish Public Private Partnership (PPP) projects had reached the operational stage. Media reports were emerging of significant differences in the effectiveness of these projects.

This research set out to find a means by which effectiveness of PPPs could be increased and to develop a model that would assist PPP practitioners with this task in the future. Through a literature review, the Irish PPP process was mapped, the changes encountered in the introduction of PPP were investigated and a conceptual model – based on a traditional process model - was proposed. The model was tested by examining …

Realising Electronic Tendering In The Irish Construction Industry, Alan V. Hore

Conference papers

No abstract provided.

Efficiency Gains To Be Won Through The Introduction Of Electronic Tendering In The Construction Industry, Alan V. Hore, Roger West

Conference papers

The tendering process predominantly adopted in the Irish construction industry is largely paper-dependent. However, the increase in the availability of high speed Information Communications Technology (ICT) has meant that construction consultants can disseminate this information more cost effectively in an electronic format. The aim of this paper is to present a status report on an industry-led network project currently being undertaken by the Construction Information Technology Alliance (CITA) in Ireland. This project aims to demonstrate how greater effectiveness and efficiency can be applied to the tendering process by the application of ICT already used widely in other industries. The status …

Bs News

Building Services Engineering

No abstract provided.

Bs News

Building Services Engineering

No abstract provided.

Bs News

Building Services Engineering

No abstract provided.

Bs News

Building Services Engineering

No abstract provided.

An Analysis Of The Direct And Indirect Costs Of Utility And Right-Of-Way Conflicts On Construction Roadway Projects, Paul M. Goodrum, Fady Kari, Adam Smith, Ben Slaughter, Chris N. Jones

Kentucky Transportation Center Research Report

Utility conflicts are unfortunately a common occurrence on many roadway projects. This report examines the frequency and severity of utility conflicts both within and outside of Kentucky. Understanding which type of utility conflicts most likely occur and the potential magnitude of their costs when will help the Cabinet better understand the risk of utility conflicts on future projects. The report details a series of five case studies that quantified the direct and indirect costs of utility conflicts on previous projects. The report also reports on the result a national survey of 45 state utility directors (out of a possible of …

Contractor Variability In Construction Of Cement Treated Base Layers, Maile Anne Rogers

Theses and Dissertations

The primary purposes of this research were to identify construction factors most correlated to specific mechanical properties of cement-treated base (CTB) layers and to determine which construction factors exhibit comparatively high variability within individual construction sections of the two pavement reconstruction projects included in this study. In addition, differences between construction sections tested in this research were evaluated. The research focused on the construction of CTB layers in two pavement reconstruction projects in northern Utah, one along Interstate 84 (I-84) near Morgan and one along U.S. Highway 91 (US-91) near Richmond. The significant predictor variables associated with California bearing ratio …

Bs News

Building Services Engineering

No abstract provided.

Payback Information: It's Effect On Home Buyers Regarding Energy Efficiency, Steven E. Sparti

Theses and Dissertations

This study was conducted to find out how payback analysis would affect consumer decision making with regards to home energy efficient upgrade packages. Three different home plans were obtained from a local builder and seven different energy efficient packages were created. Using Hot2000 the heating and cooling loads were calculated for each building, with each energy efficient package, in each of the four major cardinal directions. The averages were taken and the payback information was calculated. The payback information included the increased cost of the package, the increase in the mortgage payment, the annual savings from heating and cooling bills, …

Bs News

Building Services Engineering

No abstract provided.

Bs News

Building Services Engineering

No abstract provided.

Bs News

Building Services Engineering

No abstract provided.

Bs News

Building Services Engineering

No abstract provided.

Bs News

Building Services Engineering

No abstract provided.

Correlating Factors Between Student Participation And Student Learning Via A Service Learning Project In Secondary Education: A Case Study, Shawn V. Jensen

Theses and Dissertations

In this study a service-learning project was conducted with secondary students in a construction technology based course. Three research questions were considered; (1) does service learning projects help to engage student participation, (2) can students learn the course curriculum while participating in a service learning project, and (3) is there a correlation between student participation and student learning as it pertains to service learning projects? The data was collected through surveys, observations, interviews, and evaluations. The researcher concluded the following from the study; 92% of the students were actively participating in the two week service project, 76% of the students …

Bs News

Building Services Engineering

No abstract provided.

An Investigation Of Employee Satisfaction And Employee Empowerment Specific To On-Site Supervisors In The Residential Construction Industry, David Lars Halvorsen

Theses and Dissertations

Employee satisfaction and empowerment are vital elements to businesses in most industries. The construction industry has various types of employees, ranging from managers and executives to on-site supervisors and laborers. This study was conducted to obtain a greater understanding about the elements and levels of satisfaction and empowerment of on-site supervisors in the residential construction industry. An on-site supervisor in the residential construction industry is responsible for coordinating and managing employees, materials, equipment, budgets, schedules, contracts, and the safety of employees and the general public. They are also the employees most frequently perceived as accountable for the success or failure …