Engineering Commons^™

Nozzle Clogging Prevention And Analysis In Cold Spray, Alden Foelsche

Masters Theses

Cold spray is an additive manufacturing method in which powder particles are accelerated through a supersonic nozzle and impinged upon a nearby substrate, provided they reach their so-called critical velocity. True to its name, the cold spray process employs lower particle temperatures than other thermal spray processes while the particle velocities are comparably high. Because bonding occurs mostly in the solid state and at high speeds, cold spray deposits are distinguished for having low porosity and low residual stresses which nearly match those of the bulk material.

One complication with the cold spray process is the tendency for nozzles to …

Numerical Investigation Of Leading-Edge Modifications Of A Naca Airfoil, Anisur Rahman Ikram

Masters Theses

A parametric investigation was carried out to understand the flow characteristics of tubercle airfoils and to determine the best approach and parameters for designing a tubercle airfoil. For this purpose, a straight edge base airfoil (NACA 4414) and several tubercle airfoils, by modifying the leading edge of the base airfoil, were created in SolidWorks and tested with Computational Fluid Dynamics (CFD) application software Star CCM+.

Alternative tubercle airfoil with elliptical bumps demonstrated superior post-stall performance when compared to their straight edge counterparts; their post-stall lift did not decrease drastically. However, their pre-stall lift coefficients were always lower than the base …

Comparison Of Reynolds-Averaged Navier-Stokes Turbulence Models For Simulating Boundary Layers In Hypersonic Flows, Jorge-Valentino Kurose Bretzke

Masters Theses

“This study describes the use of Computational Fluid Dynamics (CFD) codes to simulate hypersonic boundary layers using several different turbulent closure models and comparing Reynolds-Averaged Navier-Stokes (RANS) simulations against Direct Numerical Simulations (DNS) of similar test cases. The test cases in this study consist of a flat plate in a Mach 8 freestream with a zero pressure gradient and wall recovery ratio of 0.48, as well as a Mach 8 axisymmetric nozzle also with a cold wall. The RANS models used in this study are the Spalart-Allmaras model, Baldwin-Lomax model, Menter K-Omega Baseline and Menter K-Omega Shear Stress Transport models. …