Engineering Commons^™

3d Printing Of Earthen Materials: Toward The Carbon-Zero Construction, Shiva Bhusal

Civil Engineering ETDs

In recent years, digital manufacturing techniques in the architecture and construction industry have rapidly gained attention, especially with 3D printing, also called additive manufacturing. The use of cement has been common in modern construction and is now being explored for 3D printing. However, due to cement's contribution to approximately 7 percent of global carbon emissions and its high cost, research on sustainable and greener materials has gained attention. Previous studies on alternative construction have examined the mechanical and rheological properties of soil mixes, but not much attention has been given to printability evaluation, shrinkage, and cracking, which can affect the …

Science, Technology, Engineering, And Mathematics (Stem) Project-Based Learning (Pbl) Education: A New Mexico Case Study For Equity And Inclusion, Kimberly A. Scheerer

Teacher Education, Educational Leadership & Policy ETDs

This research addresses how student participation in Science, Technology, Engineering, and Mathematics (STEM) project-based learning (PBL) education activities encourages underrepresented minority student achievement in STEM career field trajectories. Seven New Mexico high school counselors and 12 STEM organization personnel were interviewed during this study. Their responses represent the nuanced professional voices where New Mexico public education intersects with STEM student interest and cultural influence.

For students, STEM PBL can foster deep integration across educational disciplines and enhance STEM career trajectory interest and readiness. STEM education converged with PBL methodologies has the ability to leverage community support while broadening student networks. …

Evaluation Of Ozone Trends In Southern Doña Ana County, New Mexico Thru Wind Rose Analysis And Use Of Noaa Hysplit Model, Maria Aurelia Sisneros

Open Access Theses & Dissertations

The objective of this study was to determine whether increasing ozone concentrations in 2012 and 2013 at the Santa Teresa air quality monitor in Doña Ana County, New Mexico were due to a local point source impacting this monitor only or part of a regional phenomenon that affects all the monitors within the Paso del Norte Region. In addition, the study focused on identifying local and regional/long-range source areas contributing transport ozone to the study area (southern Doña Ana County).

The study showed that increasing ozone levels were not unique to the Santa Teresa monitor due to the fact that …

A Plane Coordinate System For Bernalillo County, Karl V. Morin

Civil Engineering ETDs

The first purpose of this thesis is to frame an enabling act that could be submitted to legislature for adoption. Such an act would authorize the use of plane coordinate system, but not make it mandatory. Twenty-four states have passed laws establishing state coordinate systems.

A second purpose of this thesis is to provide practicing engineers with all the necessary information and explanatory material in one manuscript to permit them to apply the system to their work. An example is worked out in detail using local points known to local men and fully explained step by step.

In addition to …

A Study Of The Concentration Of A Copper-Zinc Ore., Kenneth L. M. Dodd

Bachelors Theses and Reports, 1928 - 1970

The ore under investigation in this thesis is a copper-zinc ore which came from the state of New Mexico. The exact location is unobtainable. The purpose of the investigation was to determine the most effective means of concentration of the valuable min­erals present in the ore.