Engineering Commons^™

Development Of Spray Cooling For High Heat Flux Electronics, Jeremy Scott Junghans

Graduate Theses and Dissertations

The thermal demands of modern day electronic systems require innovative thermal solutions. Spray cooling has proven to be able to cool heat fluxes orders of magnitude higher than traditional cooling methodologies. This work includes a comparison of spray cooling to standard thermal management methodologies. Key system parameters and considerations are discussed. The properties of available packaging materials and their effect on the reliability of a spray cooled system are presented. Parameters such as fluid temperature, droplet size, fluid velocity and flow rate all directly impact performance and are detailed in this work. Finally, results from of a wide range of …

Design And Implementation Of Metamaterial Based Strain Sensor Using Aperture Coupled Antenna, Michael Brandon Buscher

Graduate Theses and Dissertations

Strain sensors are used to convert the physical measured quantity of strain into an electrical signal suitable for processing by electronic equipment. Traditional strain sensors are comprised of a thin flexible film with a resistive pattern traced on the surface. As the sensor is deformed, the electrical resistance changes proportionally, giving a direct measure of the strain incurred. Metamaterials, particularly split ring resonators (SRR), lend themselves as a valuable tool for sensing applications due to their highly resonant nature and their very narrow bandwidth (high Q-factor). Due to very high field localization effects, they are extremely sensitive to both the …

Modeling And Characterization Of P-Type Silicon Carbide Gate Turn Off Thyristors, Osama Shihadeh Saadeh

Graduate Theses and Dissertations

Silicon carbide (SiC) power semiconductor devices have emerged in the past decade as the most promising technology for next generation power electronic applications ranging for electric vehicles to grid-connected power routing and conversion interfaces. Several devices have been developed, and even some have been released commercially, including diodes, MOSFETs, JFETs, thyristors, gate turn-off thyristors, and IGBTs. The model development, characterization and experimental validation of SiC p-type Gate Turn-off Thyristors (GTO) is presented in this work. The GTO device in this work is being used as part of a SiC-based solid-state fault current limiter under development at the University of Arkansas' …

Laboratory Evaluation Of Dynamic Characterization Methods For Rapid Condition Assessment Of Bridges, Jason Kyle Herrman

Graduate Theses and Dissertations

The objective of this thesis was to devise and refine Structural Health Monitoring methods and the associated quantitative characterization methods with the specific goal of enabling rapid and reliable safety evaluations of bridges following natural or manmade hazards. Presently, the safety and serviceability of these transportation infrastructure assets for use in emergency response and recovery operations are evaluated through on-site visual inspections of individual structures by teams of specially trained engineers or technicians; a process that is manpower-intensive, subjective, and slow. Specifically, the researcher was able to identify and evaluate strategies and procedures for using dynamic testing methods to rapidly …

Understanding The Role Of A Bio-Inspired Surface Modification For Delayed Icing, Clayton Schenk

Graduate Theses and Dissertations

Atmospheric icing event is problematic for outdoor structures because it can damage, slow, impede, and danger general routine. For a wind turbine blade, it can damage, disrupt movement, and cause potentially dangerous ice throw. Anti-icing based on a surface texture is advantageous due to the low cost of maintenance and there is no additional requirement of energy output for preventing the icing problem. This work is based on the biomimicry of the superhydrophobic nature of the lotus leaf, whereas the limited wettability supports the water to flow freely from the surface structure. The phenomenon is based on a morphology and …

A Solid State Nitrogen Gas Generating Chip And Applications For Picosatellites, Kyle Godin

Graduate Theses and Dissertations

A microscale gas generating chip has many applications; in this study, applications relating to picosatellites have been considered. Cube satellites, a type of picosatellite, are of mass around one kilogram and side length 10cm x 10cm x 10cm. Their launches are becoming more numerous since their debut ten years ago. Their low cost and deployment system makes space accessible to agencies hitherto barred from it, such as universities and small governments. However, their power, mass, and volume budget is extremely tight. A microscale gas chip could compete with other designs for attitude control devices, most not flown yet as cube …

On The Complexity Of Grid Coloring, Daniel Christopher Apon

Graduate Theses and Dissertations

This thesis studies problems at the intersection of Ramsey-theoretic mathematics, computational complexity, and communication complexity. The prototypical example of such a problem is Monochromatic-Rectangle-Free Grid Coloring. In an instance of Monochromatic-Rectangle-Free Grid Coloring, we are given a chessboard-like grid graph of dimensions n and m, where the vertices of the graph correspond to squares in the chessboard, and a number of allowed colors, c. The goal is to assign one of the allowed colors to each vertex of the grid graph so that no four vertices arranged in an axis-parallel rectangle are colored monochromatically. Our results include: 1. A conditional, …

File System Simulation: Hierarchical Performance Measurement And Modeling, Hai Quang Nguyen

Graduate Theses and Dissertations

File systems are very important components in a computer system. File system simulation can help to predict the performance of new system designs. It offers the advantages of the flexibility of modeling and the cost and time savings of utilizing simulation instead of full implementation. Being able to predict end-to-end file system performance against a pre-defined workload can help system designers to make decisions that could affect their entire product line, involving several million dollars of investment. This dissertation presents detailed simulation-based performance models of the Linux ext3 file system and the PVFS parallel file system. The models are developed …

Applying Inventory Control Practices Within The Sisters Of Mercy Health Care Supply Chain, Server Apras

Graduate Theses and Dissertations

This research lays a foundation for the better understanding of the application and acceptance of more advanced inventory control practices within the health care supply chain. The demand characteristics and optimal control policies for pharmaceutical items within a multi-echelon provider network are examined within the framework of a case study. Demand forecasting algorithms were applied to forecast demand for inventory control procedures. A spreadsheet-based inventory planning tool was used to minimize the inventory holding and ordering costs subject to fill rate constraints. The costs of inventory control models are compared to the current ordering and inventory control strategies to document …

Evaluating The Capacity Of A Proton Therapy Facility, Ridvan Gedik

Graduate Theses and Dissertations

A relatively new consideration in proton therapy planning is the requirement that the mix of patients treated satisfy desired percentages. Since it is very dicult to satisfy an integer number of patients in light of these requirements, deviations from patient mix preferences and their impacts on operational capabilities are of particular interest to healthcare planners. Therefore, we propose a bicriteria mathematical programming model that determines an outpatient schedule maximizing the number of fractions and minimizing the deviations from the patient mix ratios over the planning horizon. The tradeos between the two objectives are identied through analysis of ecient frontiers. Our …

An Empirical Investigation Of Supply Chain Excellence In Healthcare, Brian Keith Smith

Graduate Theses and Dissertations

This research is motivated by opportunities to improve the cost and quality of healthcare delivery through improved supply chain processes. This research assesses the quality of the healthcare supply chain and identifies factors that are driving supply chain excellence among organizations in the healthcare industry. The first objective of this research is to assess the state of quality measurement in the healthcare supply chain. The achievement of this first objective is presented in Chapter 3 of this dissertation in the form of a manuscript accepted for publication in The Quality Management Journal. The second research objective is to develop …

New Interfacial Nanochemistry On Sensory Bioscaffold-Membranes Of Nanobelts, Feng Chen

Graduate Theses and Dissertations

Nanostructured bioscaffolds and biosensors are evolving as popular and powerful tools in life science and biotechnology, due to the possible control of their surface and structural properties at the nm-scale. Being seldom discussed in literature and long-underexploited in materials and biomedical sciences, development of nanofiber-based sensory bioscaffolds has great promises and grand challenges in finding an ideal platform for low-cost quantifications of biological and chemical species in real-time, label-free, and ultrasensitive fashion. In this study, titanate nanobelts were first of all synthesized, from hydrothermal reactions of a NaOH (or KOH solution) with TiO2 powder, to possess underexploited structure and surface …

A Methodology For Implementing Rf Bists In Production Testing To Replace Rf Conventional Tests, Deepa Mannath

Graduate Theses and Dissertations

Production testing of Radio Frequency (RF) devices is challenging due to the complex nature of the tests that have to be performed to verify functionality. In this dissertation a methodology to replace the complex and expensive RF functional tests with defect-oriented Built-in Self Tests (BiSTs) is detailed. If a design has sufficient margin to RF specifications then RF tests can be replaced with structural tests using a new data analysis technique called quadrant analysis, which is presented. Data from the analysis of over one million production units of said System on Chip (SoC) is presented along with the results of …

Multi-Threshold Cmos Circuit Design Methodology From 2d To 3d, Ross Josiah Thian

Graduate Theses and Dissertations

A new and exciting approach in digital IC design in order to accommodate the Moore's law is 3D chip stacking. Chip stacking offers more transistors per chip, reduced wire lengths, and increased memory access bandwidths. This thesis demonstrates that traditional 2D design flow can be adapted for 3D chip stacking. 3D chip stacking has a serious drawback: heat generation. Die-on-die architecture reduces exposed surface area for heat dissipation. In order to reduce heat generation, a low power technique named Multi-Threshold CMOS (MTCMOS) was incorporated in this work. MTCMOS required designing a power management unit (to control when and which gates …

Hardware Microkernels - A Novel Method For Constructing Operating Systems For Heterogeneous Multi-Core Platforms, Jason M. Agron

Graduate Theses and Dissertations

Today's standard operating systems (OSes) do not have the proper structure, nor support for executing on heterogeneous multi- and many-core platforms. These deficiencies manifest in symptomatic issues that range from relatively low-level application binary interface (ABI) compatibility problems, to higher-level concerns such as application programmer interface (API) compatibility, synchronization, and caching issues. These issues in turn reflect back up to the programmer through a lack of a standard set of OS services. Non-uniformities in the hardware architecture are also reflected back into the programming model. In total these issues combined break down the most fundamental benefit of modern operating systems; …

Morphology Of Ingaas Multilayer Nanostructure On Gaas High-Index Surfaces, Yanze Xie

Graduate Theses and Dissertations

This work aimed to explore nanostructure configuration by growing multiple layers of strained InGaAs on GaAs high index surface. The knowledge learned would help to achieve a comprehensive picture of strain-driven nanostructure evolution. Ordered arrays of InGaAs quantum dots were demonstrated on GaAs(311)B. The ordering patterns depended on the thickness of GaAs interlayer between InGaAs Quantum Dots (QDs). With an increased interfacial thickness, a transition from two dimensional (2D) lateral ordering to 1D dot chains was observed. InGaAs growth on GaAs(311)A and GaAs(331)A ended up with 1D quantum wires (QWRs). Straight InGaAs QWRs were uniformly distributed across the surfaces owing …

Factors Affecting Redox Magnetohydrodynamics For Flow In Small Volumes, Matthew D. Gerner

Graduate Theses and Dissertations

Lab-on-a-chip technologies offer the possibility of developing analytical devices that are low-cost, portable, disposable, fast, and operable by non-technical personnel. Such devices require automated methods to manipulate ultra-small volumes (picoliters) of samples and solution, including pumping, stirring, and positioning. Current methods for ultra-small volume microfluidics have limitations that restrict their use including high voltage requirements, disadvantageous flow profiles or rates, and relatively complicated fabrication due to mechanical parts. Redox magnetohydrodyanmics (RMHD) that utilizes permanent magnets for portability shows promise as a micropump with ease of switching flow direction, no moving parts, compatibility with both aqueous and non-aqueous solutions, low voltages …

Proton Irradiation Effects On Semiconductor Cdse/Zns Core/Shell Nanocrystals, Stephen Graham Charter

Graduate Theses and Dissertations

The absorbance and photoluminescence measurement of semiconductor CdSe/ZnS core shell nanocrystals were reviewed and investigated after they were exposed to proton irradiation. The CdSe/ZnS core shell nanocrystals of 3.2nm and 4.4nm were commercially purchased and investigated. These nanocrystals were embedded in UV resin. Proton irradiation of energy 2MeV was applied at doses from 3 x 1013 protons cm-2 to 1.47 x 1015 protons cm-2 for both nanocrystal sizes. Absorbance measurements were conducted at 300K. Results from absorbance measurements showed slight broadening of the first exciton peak of both samples but was most noticeable in the 3.2nm nanocrystal sample. UV resin …

Droplet Assisted Self-Assembly Of Semiconductor Nanostructures, Kimberly Annosha Sablon

Graduate Theses and Dissertations

There is increasing interest in quantum dot (QD) structures for a plethora of applications, including optoelectronic devices, quantum computing and energy harvesting. While strain driven surface diffusion via stranski-krastanow (SK) method has been commonly used to fabricate these structures, a more recent technique, droplet epitaxy (DE) does not require mismatch strain and is therefore much more flexible in the combination of materials utilized for the formation of QDs.

As reported in this work, a hybrid approach that combines DE and SK techniques for realizing lateral ordering of QDs was explored. First, the droplet formation of various materials was discussed and …