Open Access. Powered by Scholars. Published by Universities.®
- Keyword
- Publication Type
Articles 1 - 4 of 4
Full-Text Articles in Engineering
Method Of Making Temperature-Immune Self-Referencing Fabry–Pérot Cavity Sensors, Hengky Chandrahalim, Jonathan W. Smith
Method Of Making Temperature-Immune Self-Referencing Fabry–Pérot Cavity Sensors, Hengky Chandrahalim, Jonathan W. Smith
AFIT Patents
A method of making passive microscopic Fabry-Pérot Interferometer (FPI) sensor includes forming a three-dimensional microscopic optical structure on a cleaved tip of an optical fiber that reflects a light signal back through the optical fiber. The reflected light is altered by refractive index changes in the three-dimensional structure that is subject to at least one of: (i) thermal radiation; and (ii) volatile organic compounds.
Evaluation Of Additively Manufactured Lattices Under High Strain Rate Impact, Derek G. Spear
Evaluation Of Additively Manufactured Lattices Under High Strain Rate Impact, Derek G. Spear
Theses and Dissertations
Several additively manufactured lattice designs and configurations were evaluated under compression loads under various strain rates from quasi-static to highly dynamic. These experiments examined how the mechanical behavior of the lattice changed based on the lattice design properties and the applied strain rates. The modulus of elasticity, yield strength, plateau stress, and toughness were observed to decrease with an increase in strain rate, revealing that the lattice designs exhibit a negative strain rate sensitivity. A new lattice flow stress model was developed to account for the mechanical response of the lattice and was incorporated into a computational model for simulation. …
Investigation And Statistical Modeling Of The Mechanical Properties Of Additively Manufactured Lattices, Derek G. Spear, Anthony N. Palazotto
Investigation And Statistical Modeling Of The Mechanical Properties Of Additively Manufactured Lattices, Derek G. Spear, Anthony N. Palazotto
Faculty Publications
This paper describes the background, test methodology, and experimental results associated with the testing and analysis of quasi-static compression testing of additively manufactured open-cell lattice structures. The study aims to examine the effect of lattice topology, cell size, cell density, and surface thickness on the mechanical properties of lattice structures. Three lattice designs were chosen, the Diamond, I-WP, and Primitive Triply Periodic Minimal Surfaces (TPMSs). Uniaxial compression tests were conducted for every combination of the three lattice designs, three cell sizes, three cell densities, and three surface thicknesses. In order to perform an efficient experiment and gain the most information …
Shock Migration On An Oscillating Straked Delta Wing Using An Unsteady Euler Solver, Alexander J. Brown
Shock Migration On An Oscillating Straked Delta Wing Using An Unsteady Euler Solver, Alexander J. Brown
Theses and Dissertations
This research contributes to the understanding of Shock Induced Trailing Edge Separation (SITES) as a driver of Limit Cycle Oscillation (LCO) by performing a computational investigation of nonlinear aerodynamic phenomena on a straked delta wing in transonic flow, oscillating in pitch. ZEUS, an Euler-based aeroelastic solver with a boundary layer coupling scheme meant to capture viscous flow effects within the boundary layer, was used to analyze aerodynamic flow around the wing for various mean incidence angles, oscillation amplitudes, and Mach numbers within the transonic region. The dynamic characteristics of the airflow around the wing were investigated in order to characterize …