Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 5 of 5

Full-Text Articles in Engineering

The Impact Of Growth Conditions On Cubic Znmgo Ultraviolet Sensors, Ryan Boutwell Jan 2013

The Impact Of Growth Conditions On Cubic Znmgo Ultraviolet Sensors, Ryan Boutwell

Electronic Theses and Dissertations

Cubic Zn1-xMgxO (c-Zn1-xMgxO) thin films have opened the deep ultraviolet (DUV) spectrum to exploration by oxide optoelectronic devices. These extraordinary films are readily wet-etch-able, have inversion symmetric lattices, and are made of common and safe constituents. They also host a number of new exciting experimental and theoretical challenges. Here, the relation between growth conditions of the c-Zn1-xMgxO film and performance of fabricated ultraviolet (UV) sensors is investigated. Plasma-Enhanced Molecular Beam Epitaxy was used to grow Zn1-xMgxO thin films and formation conditions were explored by varying the growth temperature, Mg source flux, oxygen flow rate, and radio-frequency (RF) power coupled into …


Structure And Properties Of Polymer-Derived Sibcn Ceramics, Yaohan Chen Jan 2012

Structure And Properties Of Polymer-Derived Sibcn Ceramics, Yaohan Chen

Electronic Theses and Dissertations

Polymer-derived ceramics (PDCs) are a unique class of multifunctional materials synthesized by thermal decomposition of polymeric precursors. Due to their unique and excellent properties and flexible manufacturing capability, PDC is a promising technology to prepare ceramic fibers, coatings, composites and micro-sensors for high-temperature applications. However, the structure-property relationships of PDCs have not been well understood. The lack of such understandings drastically limited the further developments and applications of the materials. In this dissertation, the structure and properties of amorphous polymer-derived silicon carbonitride (SiCN) and silicoboron carbonitride (SiBCN) have been studied. The SiCN was obtained using commercially available polysilazane as pre-ceramic …


Saw Reflective Transducers And Antennas For Orthogonal Frequency Coded Saw Sensors, Bianca Maria Santos Jan 2009

Saw Reflective Transducers And Antennas For Orthogonal Frequency Coded Saw Sensors, Bianca Maria Santos

Electronic Theses and Dissertations

Passive sensors that vary its impedance per measured parameter may be used with surface acoustic wave (SAW) reflective transducers (SRT) for wireless acquisition of the measurand. The device is composed of two transducers, where one, which may be attached to an antenna, is used to launch the wave within the device substrate, and the other is where the sensor load is attached to. The latter is able to reflect the incident wave. How much power is reflected is determined by the attached sensor load. Amplitude variations as well as peak frequency variations of the SRT reflectivity response are explored in …


Novel Conceptual Design And Anlysis Of Polymer Derived Ceramic Mems Sensors For Gas Turbine Environment, Narasimha Nagaiah Jan 2006

Novel Conceptual Design And Anlysis Of Polymer Derived Ceramic Mems Sensors For Gas Turbine Environment, Narasimha Nagaiah

Electronic Theses and Dissertations

Technical challenges for developing micro sensors for Ultra High Temperature and turbine applications lie in that the sensors have to survive extremely harsh working conditions that exist when converting fuel to energy. These conditions include high temperatures (500-1500°C), elevated pressures (200-400 psi), pressure oscillations, corrosive environments (oxidizing conditions, gaseous alkali, and water vapors), surface coating or fouling, and high particulate loading. Several technologies are currently underdeveloped for measuring these parameters in turbine engines. One of them is an optical-based non-contact technology. However, these nondirective measuring technologies lack the necessary accuracy, at least at present state. An alternative way to measure …


Intrusion Detection In Wireless Sensor Networks, Hong Nhung Nguyen Jan 2006

Intrusion Detection In Wireless Sensor Networks, Hong Nhung Nguyen

Electronic Theses and Dissertations

There are several applications that use sensor motes and researchers continue to explore additional applications. For this particular application of detecting the movement of humans through the sensor field, a set of Berkley mica2 motes on TinyOS operating system is used. Different sensors such as pressure, light, and so on can be used to identify the presence of an intruder in the field. In our case, the light sensor is chosen for the detection. When an intruder crosses the monitored environment, the system detects the changes of the light values, and any significant change meaning that a change greater than …