Engineering Commons^™

Dc To Dc Usb-C Charger, Nikki Gmerek, Kenneth Nguyen, Uriel Serna

Electrical Engineering

The DC House USB-C Charger will convert the 48V input from the DC house, found on the Cal Poly campus, to 3 USB-C outputs: 5V, 12V, and 24 volts. The converter will deliver a total of 185 Watts out across all 3 outputs, with an efficiency greater than 82% at full load. The USB-C ports will be used to connect to compatible phones, laptops or any other device for charging/powering purposes. The goal of this project is to develop the most efficient and safe converter to deliver power to multiple outputs using USB-C, for items as small as a cell …

Passive Balancing Battery Management System For Cal Poly Racing's Formula Sae Electric Vehicle, Alvin Joseph Ha

Electrical Engineering

This senior project aims to replace the current battery management system (BMS) on Cal Poly’s Formula SAE electric vehicle with a more versatile, advanced, and reliable system. A BMS manages a rechargeable battery by ensuring the battery device operator’s safety, protecting battery cell integrity, prolonging battery lifetime, maintaining functional design requirements, and sending optimal usage information to the application controller. Passive balancing maximizes a battery pack’s capacity by dissipating excess energy through heat to regulate cell state of charge.

Dc House Energy Management System, Zachary L. Eldredge, Zoe M. Hay

Electrical Engineering

In this work, a previously completed proof of concept for an Energy Management System (EMS) for the DC House project has been revised and re-implemented. The implemented design changes will improve the performance and reproducibility of the system. This new design of the EMS replaces the two-separate buck and boost DC-DC converters with a single bidirectional DC-DC converter to reduce components and improve efficiency. Analysis of the bidirectional DC-DC converter shows high efficiency especially at larger load currents. The code of the previous work was updated for smoother operation as well as to accommodate an LCD capable of displaying more …

Modular Electronic Load, Jason March

Electrical Engineering

This project entails the design and development of a modular electronic load. The cost and simplicity of the design are considered such that it can be reproduced in-house to replace whenever possible resistor box for load testing of any analog circuits but more specifically power electronic circuits.

The design process as well as the hardware development is explained in details in this report. Results from hardware testing are also provided.