Open Access. Powered by Scholars. Published by Universities.®

Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 9 of 9

Full-Text Articles in Engineering

Spontaneous Emission In Microcavity Lasers, Dustin Philip Ziegler Dec 1997

Spontaneous Emission In Microcavity Lasers, Dustin Philip Ziegler

Theses and Dissertations

An understanding of spontaneous emission processes within microcavities is crucial in addressing the need to make tomorrow's microlasers more efficient. One approach to improving the device efficiency is to reduce the threshold input energy at which lasing begins to occur. It has been suggested that the threshold in a microcavity laser can be decreased by increasing the fraction of spontaneous emission into the lasing mode, this can be accomplished by preferentially coupling the gain medium of the laser to the electromagnetic cavity mode of interest. It therefore becomes necessary to understand the mechanism by which this coupling takes place. This …


Microelectromechanical Optical Beam Steering Systems, David M. Burns Dec 1997

Microelectromechanical Optical Beam Steering Systems, David M. Burns

Theses and Dissertations

The development of microelectromechanical systems (MEMS) has matured to the point where the fabrication of micron sized devices is feasible. State of the art MEMS construction processes now support the fabrication of novel optical devices that could not previously be built. This dissertation reports on the development of innovative micro optical devices such as Variable Blaze Gratings (VBGs) using state of the art MEMS construction processes. The principle application of the micro optical devices described in this dissertation is steering optical beams; however other applications such as spectral analysis are identified. Specific optical beam steering systems developed and characterized in …


Shock Waves In Nonequilibrium Gases And Plasmas, William M. Hilbun Oct 1997

Shock Waves In Nonequilibrium Gases And Plasmas, William M. Hilbun

Theses and Dissertations

An analysis and assessment of three mechanisms describing plasma/shock wave interactions was conducted under conditions typically encountered in a weakly ionized glow discharge. The mechanisms of ion-acoustic wave damping, post-shock energy addition and thermal inhomogeneities were examined by numerically solving the Euler equations with appropriate source terms adapted for each mechanism. Ion-acoustic wave damping was examined by modeling the partially ionized plasma as two fluids in one spatial dimension using the Riemann problem as a basis. Post-shock energy addition in the form of nonequilibrium vibrational energy relaxation was also examined in one spatial dimension using the Riemann problem as a …


Experimental Investigation Of Nonlinear Dynamics In Single Mode Semiconductor Laser Diodes With Phase Conjugate Feedback, Gordon T. Hengst Aug 1997

Experimental Investigation Of Nonlinear Dynamics In Single Mode Semiconductor Laser Diodes With Phase Conjugate Feedback, Gordon T. Hengst

Theses and Dissertations

The semiconductor laser diode offers a unique system to investigate nonlinear dynamics when optical feedback is applied. Although there is extensive research of laser diodes with optical feedback from normal dielectric mirrors, very little has been done experimentally to analyze the effects of degenerate phase conjugate feedback from a BaTiO3 crystal. This research experimentally investigated the dynamics of a single-mode laser diode with weak phase conjugate feedback using both the self-pumped and double phase conjugate geometries. The experimental results validated a mathematical model which numerically evaluates the Lang-Kobayahsi coupled differential equations. The model simulated the nonlinear behavior of a …


Optimization Considerations For Adaptive Optics Digital Imagery Systems, Robert T. Brigantic Jun 1997

Optimization Considerations For Adaptive Optics Digital Imagery Systems, Robert T. Brigantic

Theses and Dissertations

This dissertation had three objectives. The first objective was to develop image quality metrics that characterize Adaptive Optics System (AOS) performance. The second objective was to delineate control settings that maximize AOS performance. The third objective was to identify and characterize trade-offs between fully and partially compensated adaptive. For the first objective, three candidate image quality metrics were considered: the Strehl ratio, a novel metric that modifies the Strehl ratio by integrating the modulus of the average system optical transfer function to a 'noise-effective-cutoff' frequency at which some specified image spectrum signal-to-noise-ratio level is attained, and the noise-effective-cutoff frequency. It …


Propagation Of Rayleigh Waves In Thin Films, Agus A. Ananda Jan 1997

Propagation Of Rayleigh Waves In Thin Films, Agus A. Ananda

Dissertations, Theses, and Masters Projects

With the advent of thin film technology and more recently its applications in microelectronics and control of surface properties, the interest in mechanical properties of thin films has grown tremendously. Mechanical defects such as creep, fracture and adhesion loss, play a very important role in physical instabilities of thin film materials. An acoustic microscope has been built to study mechanical properties of thin-films. The microscope operates at a nominal frequency of 50 MHz. Rayleigh surface waves velocities on the surface of film-substrate systems were measured from V(z) curves generated by the acoustic microscope. V(z) curves are produced from interference between …


Characterization Of Iron Oxides And Atmospheric Corrosion Of Steel, Sei Jin Oh Jan 1997

Characterization Of Iron Oxides And Atmospheric Corrosion Of Steel, Sei Jin Oh

Physics Theses & Dissertations

The study of corrosion behavior was performed using three different analytical techniques, which provided information on the formation, development and layering of iron oxides on the corrosion products as a function of atmospheric conditions, exposure time and type of steel. In particular, the protective layer formed on weathering steel was investigated as a function of different amounts of alloying elements in the steel, atmospheric conditions and exposure times. Combined together, the results provided a better understanding of the atmospheric corrosion behavior of steel, and formed a part of database of the atmospheric corrosion characteristics.

Accurate characterization of the iron oxides …


Investigation Of The Optical Properties Of Ordered Semiconductor Materials, Jack E. Mccrae Jr. Jan 1997

Investigation Of The Optical Properties Of Ordered Semiconductor Materials, Jack E. Mccrae Jr.

Theses and Dissertations

Optical studies have been conducted upon CdGeAs2 and ZnGeP2, two of the most promising semiconductors being developed for mid-infrared non-linear optics applications. These experiments included photoluminescence (PL) studies of both compounds as well as photoreflectance (PR) measurements upon CdGeAs2. In addition, Hall effect measurements were carried out upon CdGeAs2, to aid in interpretation of the optical data. PL was measured as a function of laser power, sample temperature, and crystal orientation for CdGeAs2. One broad weak peak near 0.38 eV, and another somewhat narrower and often far brighter peak near 0.57 …


On-Line System Identification For Control System Applications In Particle Accelerators, Mahesh Chowdhary Jan 1997

On-Line System Identification For Control System Applications In Particle Accelerators, Mahesh Chowdhary

Dissertations, Theses, and Masters Projects

Particle accelerators require a number of feedback systems in order to stabilize a variety of parameters. The Continuous Electron Beam Accelerator at Thomas Jefferson National Accelerator Facility presents a unique set of control and identification problems. This accelerator produces a continuous electron beam with energies between 0.5 and 4.0 GeV to be delivered to the experimental halls. In order to meet stringent beam quality requirements specified by the experimental halls, the position and the energy of the electron beam needs to stabilized at various locations in the accelerator.;A number of noise measurement tests were conducted at various locations in the …