Engineering Commons^™

Synthesis And Characterization Of Thermoresponsive Hydrogels Based On N-Isopropylacrylamide Crosslinked With 4,4′-Dihydroxybiphenyl Diacrylate, Shuo Tang, Martha Floy, Rohit Bhandari, Manjula Sunkara, Andrew J. Morris, Thomas D. Dziubla, J. Zach Hilt

Chemical and Materials Engineering Faculty Publications

A novel crosslinker [4,4′-dihydroxybiphenyl diacrylate (44BDA)] was developed, and a series of temperature-responsive hydrogels were synthesized through free radical polymerization of N-isopropylacrylamide (NIPAAm) with 44BDA. The temperature-responsive behavior of the resulting gels was characterized by swelling studies, and the lower critical solution temperature (LCST) of the hydrogels was characterized through differential scanning calorimetry. Increased content of 44BDA led to a decreased swelling ratio and shifted the LCST to lower temperatures. These novel hydrogels also displayed resiliency through multiple swelling–deswelling cycles, and their temperature responsiveness was reversible. The successful synthesis of NIPAAm-based hydrogels crosslinked with 44BDA has led to a …

Superconductivity At Т≈200 K In Bismuth Cuprates Synthesized Using Solar Energy, J. Chigvinadze, Juana Acrivos, S. Ashimov, D. Gulamova, G. Donadze

Faculty Publications, Chemistry

When investigating low-frequency (0.1 Hz) oscillations of multiphase high-temperature cuprate superconductors (HTCS) Bi1,7Pb0,3Sr2Ca(n-1)CunOy (n=2-30), a wide attenuation peak (ΔT~100 К) with a maximum at Т≈200 К was detected. This peak was particularly pronounced in field cooling (FC) experiments, i.e. after abrupt cooling of the sample in the external magnetic field at the temperature Т<Тс with subsequent slow warming up to room temperature with invariance of the applied field. The attenuation peak height depended on the preliminaryorientation (before cooling) of the samples θ in the measured permanent magnetic field Н. On the one hand, it is well known that, after the FC procedure and subsequent slow warming up, at the temperatures close to the critical temperature Тс, the attenuation peak associated with “melting” of the Abrikosov frozen vortex structure and its disappearance at Т >Тс is detected in monophase samples. At the same time, in most multiphase bismuth HTCS samples, synthesized using solar energy and superfast quenching of the melt, the attenuation peak with the maximum at Т≈200 К was observed.Depending on the conditions of synthesis, the attenuation peak could …

Responsive Nanogel Probe For Ratiometric Fluorescent Sensing Of Ph And Strain In Hydrogels, Mingning Zhu, Dongdong Lu, Shanglin Wu, Qing Lian, Wenkai Wang, Amir H. Milani, Zhengxing Cui, Nam T. Nguyen, Mu Chen, L. Andrew Lyon, Daman J. Adlam, Anthony J. Freemont, Judith A. Hoyland, Brian R. Saunders

Engineering Faculty Articles and Research

In this study a new pH-responsive nanogel probe containing a complementary nonradiative resonance energy transfer (NRET) fluorophore pair is investigated and its ability to act as a versatile probe of network-related changes in three hydrogels demonstrated. Fluorescent sensing using NRET is a powerful method for studying relationships between Angstrom length-scale structure and macroscopic properties of soft matter. Unfortunately, inclusion of NRET fluorophores into such materials requires material-specific chemistry. Here, low concentrations of preformed nanogel probes were included into hydrogel hosts. Ratiometric photoluminescence (PL) data for the gels labeled with the nanogel probes enabled pH-triggered swelling and deswelling to be studied …

Hybrid Polymer Electrolyte For Lithium-Oxygen Battery Application, Amir Chamaani

FIU Electronic Theses and Dissertations

The transition from fossil fuels to renewable resources has created more demand for energy storage devices. Lithium-oxygen (Li-O₂) batteries have attracted much attention due to their high theoretical energy densities. They, however, are still in their infancy and several fundamental challenges remain to be addressed. Advanced analytical techniques have revealed that all components of a Li-O₂ battery undergo undesirable degradation during discharge/charge cycling, contributing to reduced cyclability. Despite many attempts to minimize the anode and cathode degradation, the electrolyte remains as the leading cause for rapid capacity fading and poor cyclability in Li-O₂ batteries. In this …

Nano/Submicro-Structured Iron Cobalt Oxides Based Materials For Energy Storage Application, Hongyan Gao

Masters Theses & Specialist Projects

Supercapacitors, as promising energy storage devices, have been of interest for their long lifespan compared to secondary batteries, high capacitance and excellent reliability compared to conventional dielectric capacitors. Transition metal oxides can be applied as the electrode materials for pseudocapacitors and offer a much higher specific capacitance. Co3O4 is one of the most investigated transition metal oxides for supercapacitor. Besides simple monometallic oxides, bimetallic transition oxides have recently drawn growing attention in electrochemical energy storage. They present many unique properties such as achievable oxidation states, high electrical conductivities because of the coexistence of two different cations in a single crystal …

Usage Of Fomblin Y To Improve Water Repellence Of Surface Coatings, Shawn Pj Kirby, Jeffrey Alston, Andrew Guenthner

STAR Program Research Presentations

Fluoro-Decyl POSS (FDP) has shown strong potential as a water repellant surface coating. Additionally, Fomblin is a solvent believed to have the ability to control the crystallization of POSS compounds on surfaces. Controlling the crystallization is key to improving water repelling abilities of surfaces. Thus, dip coating FDP and Fomblin onto surfaces is being investigated for water repulsion, mechanical stability, and deposition feasibility. First, temperature dependence of solubility of Fluoro-Decyl POSS in Fomblin was tested using Dynamic Light Scattering. Relative water repelling abilities of different coatings were determined by measuring contact angle of surfaces with water. Coatings with and without …

Comparative Solubility Of Poss Compounds In Fomblin Y, Shawn Pj Kirby, Jeffrey Alston, Andrew Guenthner

STAR Program Research Presentations

Fluoro-Decyl POSS (FDP) has shown strong potential as a water repellant surface coating. Additionally, Fomblin is a solvent believed to have the ability to control the crystallization of POSS compounds on surfaces. Controlling the crystallization is key to improving water repelling abilities of surfaces. Thus, dip coating FDP and Fomblin onto surfaces is being investigated for water repulsion, mechanical stability, and deposition feasibility. However, in order for this to be successful, POSS must be soluble in Fomblin. Temperature dependence of solubility of Fluoro-Hexyl, Fluoro-Octyl, Fluoro-Decyl POSS in Fomblin was tested using Dynamic Light Scattering. The values were compared, and it …

Synthesis,Structure And Properties Of Ruthenium Polypyridyl Metalloligand Based Metal-Organic Frameworks, Mamatha Polapally

Masters Theses & Specialist Projects

Metal-organic frameworks (MOFs) have been extensively studied because of their amazing applications in gas storage, purification, photocatalysis, chemical sensing, and imaging techniques. Ruthenium polypyridyl complexes have been broadly considered as photosensitizers for the conversion of solar energy and photoelectronic materials. With this aspect, we have synthesized three new ruthenium polypyridyl based MOFs ([Ru(H2bpc)Cu(bpc)(Hbpc)2(H2O)]·5H2O (1), [Ru(H2bpc)(Fe(bpc)(Hbpc)2(H2O)2]·6H2O (2) and [Ru(H2bpc)Ni(bpc)(Hbpc)2(H2O)2]·6H2O (3)) from ruthenium(III) chloride, bpc (2,2’- bipyridine-4,4’-dicarboxylic acid) ligand, and 3d M(II) metal ions (M(II)= Cu(II), Fe(II), Ni(II)). These MOFs were synthesized under hydro or solvothermal conditions by using water, ethanol or methanol as solvents. The crystal structures of the new compounds …

Ionic Thermoelectric Paper, Fei Jiao, Ali Naderi, Dan Zhao, Joshua Schlueter, Maryam Shahi, Jonas Sundström, Hjalmar Granberg, Jesper Edberg, Ujwala Ail, Joseph W. Brill, Tom Lindström, Magnus Berggren, Xavier Crispin

Physics and Astronomy Faculty Publications

Ionic thermoelectric materials, for example, polyelectrolytes such as polystyrene sulfonate sodium (PSSNa), constitute a new class of materials which are attracting interest because of their large Seebeck coefficient and the possibility that they could be used in ionic thermoelectric SCs (ITESCs) and field effect transistors. However, pure polyelectrolyte membranes are not robust or flexible. In this paper, the preparation of ionic thermoelectric paper using a simple, scalable and cost-effective method is described. After a composite was fabricated with nanofibrillated cellulose (NFC), the resulting NFC–PSSNa paper is flexible and mechanically robust, which is desirable if it is to be used in …

Catalyzed Synthesis Of Zinc Clays By Prebiotic Central Metabolites, Marcelo I. Guzman, Ruixin Zhou, Kaustuv Basu, Hyman Hartman, Christopher J. Matocha, S. Kelly Sears, Hajatollah Vali

Chemistry Faculty Publications

How primordial metabolic networks such as the reverse tricarboxylic acid (rTCA) cycle and clay mineral catalysts coevolved remains a mystery in the puzzle to understand the origin of life. While prebiotic reactions from the rTCA cycle were accomplished via photochemistry on semiconductor minerals, the synthesis of clays was demonstrated at low temperature and ambient pressure catalyzed by oxalate. Herein, the crystallization of clay minerals is catalyzed by succinate, an example of a photoproduced intermediate from central metabolism. The experiments connect the synthesis of sauconite, a model for clay minerals, to prebiotic photochemistry. We report the temperature, pH, and concentration dependence …

Synthesis, Characterization, And Properties Of Graphene-Based Hybrids With Cobalt Oxides For Electrochemical Energy Storage And Electrocatalytic Glucose Sensing, Sara C. Botero Carrizosa

Masters Theses & Specialist Projects

A library of graphene-based hybrid materials was synthesized as novel hybrid electrochemical electrodes for electrochemical energy conversion and storage devices and electrocatalytical sensing namely enzymeless glucose sensing. The materials used were supercapacitive graphene-family nanomaterials (multilayer graphene-MLG; graphene oxide-GO, chemically reduced GO-rGO and electrochemical reduced GOErGO) and pseudocapacitive nanostructured transition metal oxides including cobalt oxide polymorphs (CoO and Co3O4) and cobalt nanoparticles (CoNP). These were combined through physisorption, electrodeposition, and hydrothermal syntheses approaches. This project was carried out to enhance electrochemical performance and to develop electrocatalytic platforms by tailoring structural properties and desired interfaces. Particularly, electrodeposition and hydrothermal synthesis facilitate chemically-bridged …

Environmentally Friendly Synthesis Of Transition Metalorganic Hybrid Nanocomposites, Aubrey N. Penn

Masters Theses & Specialist Projects

Research on metal nanoparticles (MNPs) synthesis and their applications for optoelectronic devices has been a recent interest in the fields of nanoscience and nanotechnology Photovoltaics are one of such systems in which MNPs have shown to be quite useful, due to unique physical, optical, magnetic, and electronic properties, including the metal nanoparticles synthesized in this research.

Owing to the challenges with the most common physical and chemical methods of preparing MNPs, including the use of high temperatures, toxic reducing agents, and environmentally hazardous organic solvents, there is a critical need for a benign synthesis procedure for MNPs. In this work, …

Development Of Magnetorheological Elastomers (Mres) For Strength And Fatigue Resistance, J. Mcintyre, Stephen Jerrams

Books/Book Chapters

Natural rubber (NR)-based magnetorheological elastomers (MREs) exhibiting a reasonable switching effect were fabricated and tested. They were strong enough for use in automotive applications but still needed protection against ageing. Ethylene–propylene–diene rubber (EPDM) is a cost-effective material that is frequently used in the automotive industry because of its advantageous range of properties. With these applications in mind, it was a logical progression to the development of EPDM-based MREs. Unlike strain-crystallising NR, EPDM requires reinforcement to render its tensile and fatigue strength suitable for use in most applications. While small amounts of carbon black were sufficient for the NR-based MREs, a …

A Fast Linear Electro-Optical Effect In A Non-Chiral Bent-Core Liquid Crystal, Yuri Panarin, S.P. Sreenilayam, J.K. Vij, A. Lehmann, C. Tschierske

Articles

We report the observation of an electro-optical effect for a linear rotation of the optical axis as function of the electric field in an achiral tilted bent-core liquid crystalline compound, in which 4-cyanoresorcinol bisbenzoate core is symmetrically terminated by long linear alkyl chains (n =16) on both ends. The linear electro-optic effect observed in this material is similar to the deformed helical ferroelectric liquid crystal (DHFLC) effect reported previously in a FLC material except that dimensions of the helical pitch differ by two orders of magnitude. In the chiral systems, the helical pitch usually lies on the scale of sub-optical …