Engineering Commons^™

Interaction Between Micro-Cracking, Cracking, And Reduced Durability Of Concrete: Developing Methods For Considering Cumulative Damage In Life-Cycle Modeling, Zhifu Yang, W. Jason Weiss, J. Olek

JTRP Technical Reports

It is becoming increasingly popular to utilize numerical simulation models to predict the long-term performance of concrete pavements and structures. The majority of these models have been developed using laboratory test data that considers concrete in an uncracked state. While uncracked concrete exists as the best case scenario, frequent cracking occurs in real structures that could have a profound impact on life cycle performance. Cracks from several sources may accumulate and interact thereby accelerating the deterioration of concrete. For example, the distributed cracking caused by freeze/thaw damage can substantially increases the rate of water absorption and reduces the load carrying …

Initial Study For Cost-Effectiveness Of Joint/Crack Sealing, Chuanxin Fang, Khaled A. Galal, David R. Ward, John E. Haddock

JTRP Technical Reports

The sealing and resealing of joints and cracks in PCC, HMA, and composite pavements is assumed to be an important component of pavement maintenance. Recently this practice has been challenged by research indicating that sealing may not be cost-effective. The Indiana Department of Transportation currently spends approximately four million dollars annually to perform joint/crack sealing. The primary objective of the research presented in this report is to investigate the costeffectiveness of joint/crack sealing in relation to pavement performance. The results of a mail survey showed that most states, including Indiana, do not have quantitative justification for sealing policies, nor do …

Design Of Durable Concrete Railroad Crossings, Anthony J. Lamanna, Charles F. Scholer

JTRP Technical Reports

Existing precast concrete railroad crossings in the state of Indiana are experiencing too short a life expectancy. This study proposes methods that can be used to produce durable concrete railroad crossings with satisfactory rideability, durability, and longevity. Thirty-two precast concrete railroad crossings were visited in central and northern Indiana. Failures were determined to belong to three major categories: structural capacity causes, environmental causes, and material property causes. A concrete mix was evaluated at three different polyolefin fiber contents and without fibers. Beams were tested in flexure, and modulus of rupture and first crack deflection were recorded for each beam. Cylinders …

Influence Of Curing Conditions On Strength Properties And Maturity Development Of Concrete, Scott Andrew Newbolds, Jan Olek

JTRP Technical Reports

In this study, the results of both laboratory studies and a field study, conducted to evaluate the effects of different curing conditions on the strength properties and maturity development of pavement concrete, are presented. Further, a laboratory study was performed to evaluate the maturity concept in relation to the degree of hydration of cement. Concrete specimens, beams and cylinders, were prepared in the field study. The specimens in the field were cured in one of four curing conditions: lime bath, sandpit, air, or by temperature match curing. Specimens were tested for flexural strength and compressive strength, respectively. The temperature of …

Mid-Panel Cracking Of Portland Cement Concrete Pavements In Indiana, Hung-Ming Chen, Yunus Dere, Elisa D. Sotelino, Graham C. Archer

JTRP Technical Reports

Portland cement concrete slabs are a common form of highway pavements in Indiana. As a result of their widespread use, the economic impact of their maintenance and life span is therefore tremendous. In Indiana, these types of pavements have been experiencing premature random transverse mid-panel cracking. This phenomenon has been observed under a variety of environmental and traffic conditions. Also, it has been found that the cracking occurs in conjunction with the opening of the lanes to traffic, within months of construction. In this project, a research synthesis was carried out to determine exactly what the current state of knowledge …

Development And Evaluation Of Cement-Based Materials For Repair Of Corrosion-Damaged Reinforced Concrete Slabs, Rongtang Liu, J. Olek

JTRP Technical Reports

In this study, the results of an extensive laboratory investigation conducted to evaluate the properties of concrete mixes used as patching materials to repair reinforced concrete slabs damaged by corrosion are reported. Seven special concrete mixes containing various combinations of chemical or mineral admixtures were developed and used as a patching material to improve the durability of the repaired slabs. Physical and mechanical properties of these mixes, such as compressive strength, static modulus of elasticity, dynamic modulus of elasticity, and shrinkage were evaluated. Durability-related parameters investigated included resistance of concrete to penetration of chloride ions and freeze-thaw resistance. The results …

Performance Of Bridge Decks And Girders With Lightweight Aggregate Concrete, V. 2 Of 2, J. A. Ramirez, J. Olek, Eric Joseph Rolle, Brian Joseph Malone

JTRP Technical Reports

Structural lightweight concrete is a very versatile material and Haydite and Minergy lightweight aggregates can be utilized in the mixture development of concrete for use in girders and decks in bridges. More widespread use of lightweight aggregates (LWA) would result in savings in construction cost due to considerable dead load reduction.

The materials phase of this research study evaluated the fresh concrete properties (slump, unit weight, and air content), the mechanical properties of hardened concrete (compressive strength, tensile strength, flexural strength, static and dynamic modulus of elasticity, Poisson’s Ratio, and temperature development), and durability related parameters (air void distribution, freeze-that …

Performance Of Bridge Decks And Girders With Lightweight Aggregate Concrete, J. A. Ramirez, J. Olek, Eric Joseph Rolle, Brian J. Manlone

JTRP Technical Reports

Structural lightweight concrete is a very versatile material and Haydite and Minergy lightweight aggregates can be utilized in the mixture development of concrete for use in girders and decks in bridges. More widespread use of lightweight aggregates (LWA) would result in savings in construction cost due to considerable dead load reduction. The materials phase of this research study evaluated the fresh concrete properties (slump, unit weight, and air content), the mechanical properties of hardened concrete (compressive strength, tensile strength, flexural strength, static and dynamic modulus of elasticity, Poisson’s Ratio, and temperature development), and durability related parameters (air void distribution, freeze-thaw …

Testing Of Multi-Span Bridges With Full Span Precast Prestressed Concrete Panels (Phase 1), Robert J. Peterman, J. A. Ramirez

JTRP Technical Reports

The purpose of this study was to assess the behavior and durability of multi-span bridges constructed with full-span prestressed concrete form panels. The use of full-span prestressed concrete form panels for bridges with spans of 40 ft. or less is an economical method of construction due to the reduction of on-site formwork and labor required by alternate cast-in-place systems. In this research, a pair of two-span bridges utilizing full-span prestressed concrete form panels were fabricated and tested in the Karl H. Kettelhut Structural Engineering Laboratory at Purdue University. Time-dependent effects were monitored during the cast-in-place (CIP) concrete cure period of …

Behavior Of Biaxially Loaded Concrete-Encased Composite Columns, Pedro Ricardo Munoz

Dissertations

The theory of nonlinear behavior of biaxially loaded short and slender composite columns is used to study the load-deformation and moment-curvature of four pin-ended composite column specimens tested under axial compressive load and biaxial bending moments in a single curvature. The accuracy of the test results is verified by comparison with analytical results obtained by a method of analysis that includes the nonlinear material properties of concrete and steel and covers the ascending and descending branches of the linear segmented column specimen. A computational method is presented to model the analytical behavior of the biaxially loaded composite column. Its validity …

Softening Response Of Concrete In Direct Tension, Teresa Cintora

Theses

Due to the increased attention in nonlinear fracture mechanics and numerical methods of cementitious material, it has become necessary to have a reliable investigation of the post-peak softening response of concrete under direct uniaxial loading. But due to the brittleness of the material previous researchers have encountered great difficulty in obtaining complete data regarding the load-deformation behavior. This study uses a strain-controlled testing method and therefore the post-peak curve can be more easily obtained. Based on these results a unique formula for the normalized load vs. deformation curve has been proposed to be applied in fracture analysis applications.