Engineering Commons^™

Management Of A University Satellite Program With Focus On A Refrigerant-Based Propulsion System, Shawn W. Miller

Masters Theses

"The Missouri University of Science and Technology Satellite (M-SAT) design team has established a satellite program to develop a pair of satellites to perform an autonomous formation flight mission. The resulting configuration was assembled for the Air Force Research Lab University Nanosat Program. This document, written by the Program Manager and former member of the Propulsion subsystem, is a description of the management process used by the team to develop a satellite configuration. Included in the document is a discussion of team organization, techniques for managing a program, and lessons learned during the 2007 to 2008 timeframe. The managing techniques …

Low-Thrust Control Of Orbital Elements, Nathan Harl

Doctoral Dissertations

"This dissertation presents a method for controlling the orbital elements of a spacecraft using continuous low-thrust systems. The method involves the use of a general performance index, which is designed to minimize the difference between the instantaneous orbital elements of a spacecraft and some desired set of orbital elements. Due to the generality of the controller design, the resultant controller can be applied to a wide variety of scenarios about various bodies in space. To minimize the designed performance index, a shooting method and a Sequential Quadratic Programming algorithm are utilized and compared.

The primary application of the general controller …

Analysis Of The Theta-D Filter As Applied To Hit-To-Kill Interceptors And Satellite Orbit Determination, Michael W. Dancer

Masters Theses

"When designing feedback control systems, there is often a need for estimation methods that provide system information that is not readily available via sensors placed within the system. In many cases a sensor that measures a particular system state either does not exist or is prohibitively expensive. In addition, all realistic systems contain some degree of nonlinearity. This thesis focuses on two such cases: missile guidance with bearings-only measurements and GPS satellite orbit determination. In each case, a new nonlinear filter, the [theta]-D method, is used and evaluated for its performance in providing the necessary estimation. To aid the filter …

A Numerical Investigation Of Flowfield Modification In High-Speed Airbreathing Inlets Using Energy Deposition, Matthew Flynn Rohweder

Masters Theses

"Energy deposition in front of dual-mode ram/scramjet engines is numerically investigated utilizing two-dimensional CFD for its potential to modify inlet/isolator flow-fields for engine start/unstart control and for its general potential for generating large-scale flow-field modification in such flows. A simplified (high Mach number) constant-area duct geometry is initially defined in order to test the feasibility of the concept; the results from this initial investigation demonstrates possible beneficial effects of depositing energy upstream of a thermally choked duct in terms of causing massive changes in flow patterns, including the reestablishment of supersonic flow throughout the duct. This study is followed by …

Integration And Test Of A Refrigerant-Based Cold-Gas Propulsion System For Small Satellites, Ryan Alan Pahl

Masters Theses

"Due to the launch safety constraints placed on university-built small satellites, designing a low-cost propulsion system to meet mission requirements presents a significant challenge to aspiring student engineers. The Missouri University of Science and Technology is currently developing a low-cost, two-phase propulsion system using the refrigerant R-134a as the propellant that can be stored at low pressures while still providing sufficient performance to meet mission goals. The purpose of this study is to present the testing results of a refrigerant-based cold gas system utilizing R-134a as a saturated liquid propellant and the ability to design this system to be portable …

Quantification Of Uncertainty In Aerodynamic Heating Of A Reentry Vehicle Due To Uncertain Wall And Freestream Conditions, Benjamin R. Bettis

Masters Theses

"The primary focus of this study is to demonstrate an efficient approach for uncertainty quantification of surface heat flux to the spherical non-ablating heatshield of a generic reentry vehicle due to epistemic and aleatory uncertainties that may exist in various parameters used in the numerical solution of hypersonic, viscous, laminar blunt-body flows with thermo-chemical non-equilibrium. Two main uncertainty sources were treated in the computational fluid dynamics (CFD) simulations: (1) aleatory uncertainty in the freestream velocity and (2) epistemic uncertainty in the recombination efficiency for a partially catalytic wall boundary condition. The Second-Order Probability utilizing a stochastic response surface obtained with …

Thrust Measurement Of Dielectric Barrier Discharge Plasma Actuators And Power Requirements For Aerodynamic Control, Joseph William Ferry

Masters Theses

"Plasma-based aerodynamic actuators are of interest to researchers because they do not require moving control surfaces or a source of pressurized air to modify a flow field. Dielectric barrier discharge (DBD) plasma actuators have the added advantages of simple installation and low power consumption.

DBD plasma actuators are AC devices. This work measured actuator power consumption and thrust production for driving frequencies between 1 and 18 kHz, and for driving voltages of 6 and 9 kV peak to peak. The actuator consumed between 3 and 22 W of power and produced thrust levels between 0.05 and 0.2 mN per meter …