Architectural Engineering Commons^™

Measurement Of Volumetric Deformation, Strain Localization, And Shear Band Characterization During Triaxial Testing Using A Photogrammetry-Based Method, Sara Fayek, Xiong Zhang, Xiaolong Xia, Qingqing Fu, Jeffrey D. Cawlfield

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

Triaxial Testing Has Been Routinely Used as a Standard Laboratory Test that Allows Correct Determination of Soil Characteristics. Previously the Volumetric Strain of the Triaxial Specimen Was Considered to Be Uniformly Distributed Along with the Specimen during the Isotropic and Deviatoric Loading. Although This Assumption Might Hold True under Isotropic Loading, the Effects of Restrained Ends and Disturbance during the Procedures of Specimen Installation and Testing Can Cause Nonuniform Strains throughout the Whole Specimen. This Paper Investigates the Effects of Specimen Preparation and Misalignment on the Strain Uniformity Along with the Soil Specimen during Triaxial Testing. a Series of Consolidated …

Point Density For Soil Specimen Volume Measurements In Image-Based Methods During Triaxial Testing, Sara Fayek, Xiong Zhang, Javad Galinmoghadam, Jeffrey D. Cawlfield

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

Discrete Measurement Targets Were Frequently Utilized in Image-Based Methods on the Specimen's Surface to Monitor the Soil Specimen during Triaxial Testing. However, the Required Density of Measurement Targets that Should Be Used in Triaxial Testing to Achieve Highly Accurate Volume Measurement Has Not Been Investigated. to overcome This Limitation, This Paper Presents a Parametric Study to Determine the Optimum Target/point Densities to Be Utilized on the Triaxial Soil Specimen Surface to Achieve the Desired Level of Volume Measurement Accuracy in Image-Based Methods. LiDAR Scanning Was Applied to Establish the "Ground Truth" Volume of the Specimen. the Effects of Deformation and …

Analytical And Numerical Behavior Of Double Composite Steel Bridges, Emad M. Hassan, Hussam Mahmoud

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

Steel plate girders are considered a viable solution for the construction of medium- to long-span bridges. Despite their many advantages, various concerns have been raised regarding their maintenance due to the potential of fatigue crack initiation at welded details, accelerated corrosion in thin webs, and trapped debris around stiffeners. The use of rolled beams, on the other hand, can be very beneficial because they require much less maintenance. However, they are limited in size, which imposes constraints on their use to relatively short-span bridges due to deflection requirements. In this study, the behavior of the double composite superstructure system was …

An Insight Into The Effect Of Sharp And Round Edges On The Flow Field-A Cfd Simulation, Abid Hussain, Gao Puzhen, M. Mustafa Azeem, Muhammad Zubair, Muhammad Aamir, Muhammad Irfan Khaleed

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

This paper presents a numerical investigation of pressure drop and distribution in a channel around a sharp edge and a disc that is connected to the base of a circular rod. We have employed computational fluid dynamics (CFD)-Fluent for the validation of our models. It was found that the edge sharpness of the disc influences the pressure drop., i.e. sharp edge has higher turbulence and pressure drop. We also observed that pressure drops in the case of the circular disc are less than that of the sharp edge. However, pressure drop has essentially the same values for both shapes after …

Dissipated Hysteretic Energy Reconstruction For High-Resolution Seismic Monitoring Of Instrumented Buildings, Milad Roochi, Eric M. Hernández, David V. Rosowsky

Durham School of Architectural Engineering and Construction: Faculty Publications

This paper proposes a high-resolution seismic monitoring framework that employs dissipated energy as a feature for damage detection and localization in instrumented building structures. The the methodology consists of (1) implementing a nonlinear state observer to reconstruct the dynamic response at all degrees of freedom (DoF) of a structural model, (2) employing the reconstructed response to estimate element-by-element forces and displacements, and (3) using estimated displacement, forces, and constitutive laws to estimate elementlevel dissipated energy. The main advantages of the proposed energy-based approach are that i) the proposed feature is physically meaningful and correlates well with the level of cyclic …

Variation Of Moisture Content And Temperature Under The Road Shoulder Improved With Wicking Geotextile, Javad Galinmoghadam, Xiong Zhang

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

Several Pavement Distresses Are Associated with Excess Water in the Pavement System. Hence, Controlling Subsurface Water is Crucial to Pavement's Long-Term Performance. Improving Pavement Drainage is Commonly Used to Control the Water Content in Pavement Layers. Conventional Drainage Systems Can Work under Saturated Conditions but Cannot Effectively Drain Capillary Water. a New Type of Wicking Geotextile Has Been Developed that Can Drain Water under Both Saturated and Unsaturated Conditions. in This Study, the Performance of This New Type of Geotextile in Draining Water from a Paved Road Shoulder is Evaluated. a Full-Scale Test Section Along Interstate 44 Was Constructed and …

Field Reconnaissance And Observations From The February 6, 2023, Turkey Earthquake Sequence, Gulen Ozkula, Robert K. Dowell, Tugce Baser, Jui Liang Lin, Ozgun A. Numanoglu, Okan Ilhan, C. Guney Olgun, Cheng Wei Huang, Tunc Deniz Uludag

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

On February 6, 2023, a sequence of earthquakes hit Kahraman Maras, Turkey, with magnitudes of M w = 7.8 and 7.5, at 4:17 am and 1:24 pm local time, respectively. According to the records, the M w = 7.8 event was the biggest earthquake since the 1939 Erzincan earthquake of the same magnitude and second-strongest recorded after the 1668 North Anatolia Earthquake. However, it was the most devastating earthquake in the history of Turkey in terms of structural and geotechnical damage and fatalities caused by this. The objective of this article is to explore the aftermath of this major seismic …

Nucleotide Detection Mechanism And Comparison Based On Low-Dimensional Materials: A Review, M. Mustafa Azeem, Muhammad Shafa, Muhammad Aamir, Muhammad Zubair, Basma Souayeh, Mir Waqas Alam

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

The recent pandemic has led to the fabrication of new nucleic acid sensors that can detect infinitesimal limits immediately and effectively. Therefore, various techniques have been demonstrated using low-dimensional materials that exhibit ultrahigh detection and accuracy. Numerous detection approaches have been reported, and new methods for impulse sensing are being explored. All ongoing research converges at one unique point, that is, an impetus: the enhanced limit of detection of sensors. There are several reviews on the detection of viruses and other proteins related to disease control point of care; however, to the best of our knowledge, none summarizes the various …

Extending The Nno Ballistic Limit Equation To Foam-Filled Dual-Wall Systems, William P. Schonberg

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

A key component in the quantitative assessment of the risk posed to spacecraft by the micrometeoroid and orbital debris (MMOD) environment is frequently referred to as a ballistic limit equation (BLE). A frequently used BLE for dual-wall configurations (which are commonly used on spacecraft to protect them against the MMOD environment) is the New Non-Optimum, or "NNO", BLE. In design applications where a BLE is needed for a new structural system that has not yet been tested, but resembles to a fair degree a dual-wall system, it is common practice to equivalence the materials, thicknesses, etc., of the new system …

Evaluation Of Thermal And Rheological Properties Of Phase Change Material-Incorporated Asphalt Mastic With Porous Fillers, Farshad Saberi Kerahroudi, Yizhuang David Wang, Jenny Liu

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

Incorporating phase change material (PCM) into paving materials can regulate the pavement temperature, improve the pavement durability, and mitigate the heat-island effects. In this research, porous fillers were used as the PCM carrier, and the thermal and rheological behaviors of the asphalt mastic with the PCM were evaluated. Two different carrier materials (diatomite and expanded perlite) and four types of PCMs were used in the study. The candidate filler, PCM, and proper blending ratios were determined based on the results of scanning electron microscope image analysis, the filter paper test, and the temperature sweep test. The thermal and rheological behaviors …

Economic Impact Of Land Use Planning (Transit-Oriented Development): A Comparative Analysis, Sam M

West Chester University Doctoral Projects

The problem explored in this mixed-method research is that many cities are unprepared for urban growth, which can only increase poverty and crime. The traditional transportation system is inadequate to support the increase of urbanism; it is responsible for polluting the air, increasing greenhouse gases, and losing thousands of lives annually due to car crashes and road-related accidents. The transportation sector is responsible for 28% of the overall greenhouse gas emissions (Environmental Protection Agency, 2018), and the economic costs of vehicle crashes in the United States totaled $340 billion (Department of Transportation, 2019).

This study aimed to measure how Transit …

Integrating Life-Cycle Analysis Into Civil Infrastructure Resilience Decision Making: Illustrative Application To Seismic Resilience Modeling Of Us Communities, Milad Roohi, Jiate Li, W. Van De Lindt

Durham School of Architectural Engineering and Construction: Faculty Publications

This paper aims to integrate life-cycle analysis into civil infrastructure resilience modeling and decision-making in seismic-prone communities. To achieve this aim, the authors present a methodology for modeling seismic life-cycle resilience of interdependent buildings and lifeline systems and subsequently informing resilience decisions directly related to the maintenance and retrofit of interdependent infrastructure to enhance a community’s physical, social, and economic systems. The methodology consists of 1) community data collection, 2) seismic hazard analysis, 3) physical damage analysis, and 4) system-level functionality and restoration analysis, 5) socio-economic impact analysis, 6) life-cycle optimization and retrofit decisionmaking. The methodology begins by developing geospatial …

Higher-Order Effects In Biaxial Flexure Of Gfrp I-Section Beams, Zia Razzaq, Faridoon Z. Razzaq

Civil & Environmental Engineering Faculty Publications

A theoretical study of Glass Fiber Reinforced Polymer (GFRP) beams subjected to biaxial bending moments is presented with a focus on the influence of higher-order effects on maximum normal stresses. It is shown that the biaxial bending type of loading causes a dramatic increase in the maximum normal stress for a GFRP beam when induced torsional effects are included. The study demonstrates that the traditional first-order theory can grossly underestimate the maximum normal stress in a GFRP beam. Based on the numerical results presented using a higher-order theory which also accounts for induced warping normal stresses, the maximum normal stress …

Green Roofs To Treat The Local Dwelling Environment Problems Within Egypt's Vision 2030, Abdullah Badawy Mohammed

Mansoura Engineering Journal

The continuous increase in the building ratio to green areas led to disappearing green spaces, and the vertical and horizontal expansion of dwellings as an urgent demand in cities led to various environmental, social, and economic risks. Hence, the research aims to facilitate the application of green roofs for their positive role in treating these risks and improving the performance of dwelling projects and all buildings according to the climate and local conditions. Therefore, the study addressed the history, concept, and significance of green roofs, besides their benefits on architectural and urban levels, according to the three sustainability pillars and …

Cold-Formed Steel Strength Predictions For Combined Bending And Torsion, Yu Xia, Robert S. Glauz, Benjamin W. Schafer, Michael Seek, Hannah B. Blum

Engineering Technology Faculty Publications

Locally slender cross-section members, such as cold-formed steel Cee and Zee sections, are susceptible to significant twisting and high warping torsion stresses. Torsion considerations are complicated by whether it is derived as a first-order effect from loading or a second-order effect from instability. The current design for combined bending and torsion interaction has some limitations, including only considering the first yield in torsion and ignoring the cross-section slenderness in torsion. Previous work has derived a simple uniform equation to predict the bimoment capacity and two bimoment strength curves for local and distortional buckling under torsion only. This work is extended …

A Review On Sustainable Disposal Of Plastic Waste By Integration In Construction Materials, Yara S. El-Metwally, Iman El-Mahallawi, Khaled M. Dewidar, Mostafa R. Refaat

Architectural Engineering

Over the last decades, plastic waste (PW) has increased exponentially and has become a serious threat to our planet, aquatic system and human health. Recycling or reusing PW in producing ecofriendly materials is an efficient solution to reduce plastic pollution and to minimize the depletion of raw materials as well. Previous studies have shown promising potentials of using PW in the construction sector, such as binder, aggregate, or substitute of cement and sand in concrete, brick or mortar. Laboratory results indicate that implementing plastic waste as aggregates in cement composites obtains higher thermal resistance and acoustical performance. However, a reduction …