Digital Commons Network^™

Shock Wave Dispersion In Weakly Ionized Gas, Prasong Kessaratikoon

Physics Theses & Dissertations

Electrodeless microwave (MW) discharge in two straight, circular cylindrical resonant cavities in TE_1,1,1 and TM_0,1,2 modes were introduced to perform additional experimental studies on shock wave modification in non-equilibrium weakly ionized gases and to clarify the physical mechanisms of the shock wave modification process. The discharge was generated in 99.99% Ar at a gas pressure between 20 and 100 Torr and at a discharge power density less than 10.0 Watts/cm³. Power density used for operating the discharge was rather low in the present work, which was determined by evaluating the power loss inside the resonant cavity. …

Development Of An Aggregation Methodology For Risk Analysis In Aerospace Conceptual Vehicle Design, Trina Marsh Chytka

Engineering Management & Systems Engineering Theses & Dissertations

The growing complexity of technical systems has emphasized a need to gather as much information as possible regarding specific systems of interest in order to make robust, sound decisions about their design and deployment. Acquiring as much data as possible requires the use of empirical statistics, historical information and expert opinion. In much of the aerospace conceptual design environment, the lack of historical information and infeasibility of gathering empirical data relegates the data collection to expert opinion.

The conceptual design of a space vehicle requires input from several disciplines (weights and sizing, operations, trajectory, etc.). In this multidisciplinary environment, the …

Modeling Fracture In Laminated Automotive Glazing Impacted By Spherical Featureless Headform, Lokeswarappa R. Dharani, S. R. Mettu, S. Zhao, S. D. Barbat, L. Chai

Mechanical and Aerospace Engineering Faculty Research & Creative Works

Laminated glass consisting of two soda lime glass plies adhered by a polyvinyl butyral interlayer (PVB) is used for automotive glazing. This paper describes the application of a dynamic, nonlinear finite element method to investigate the failure modes of a laminated glass subjected to low-velocity impact with a spherical head form. Crack type, crack location and crack initiation time are evaluated using the maximum principal stress and J-integral criterion. Failure occurred due to flexural stresses and not bearing stresses. the first crack always initiated at the center of the outer impacted ply and PVB interface, and later on the exterior …

Multidimensional, Time-Accurate Cfd Simulation Of Adsorption/Desorption In A Carbon Canister, Xingyan Bai, Kakkattukuzhy M. Isaac, D. Klein, R. Banerjee, J. Edson, W. Breig, L. Oliver

Mechanical and Aerospace Engineering Faculty Research & Creative Works

Computational fluid dynamics simulations of fixed-bed adiabatic adsorption/desorption processes are presented in this paper. Linear driving force model is used for heat and mass transfer rates. a two-dimensional cylindrical canister and three-dimensional automotive production canister geometry are used to study the adsorption/desorption processes of carbon dioxide in helium carrier gas on Norit B4 activated carbon. the two-dimensional results compare well with the results of Hwang et al. [1]. Computational results as breakthrough curve, adsorption amount and temperature profiles are provided. Results show that non-adiabatic model should be used to fully utilize the activated carbon bed capacity prior to breakthrough. Copyright …