Digital Commons Network^™

Lattice Constants, Thermal Expansion Coefficients, Densities, And Imperfections In Gold And The Alpha-Phase Of The Gold-Indium System, Vinayak Keshavlal Patel

Masters Theses

"An investigation of structure insensitive properties (lattice parameters, thermal expansion coefficients, densities, and imperfection) of gold and the alpha-phase of the gold-indium system was made. The gold-indium alloys were prepared from high purity (99.999%) gold and indium by melting both metals inside sealed quartz glass tubes which were first evacuated and then filled with helium gas. The solidified alloys were annealed and then examined by x-ray for homogeneity. The lattice constant of 99.999% pure gold at 25⁰C was found to be 4.07894 ł 0.00005 (corrected for refraction) Å. The coefficient of thermal expansion was 13.4 x 10⁻⁶⁰C⁻¹ between 15 and …

Negative Resistance In Cadmium Sulfide., John William Mohr

Masters Theses

"A light-sensitive, negative-resistance phenomenon has been observed in a special two-terminal CdS device fabricated from selected single crystals. The device differs from those used in previous investigations in that one end of the device was masked to keep out visible light and that the phenomenon was observed at room temperature. A method is described which enables the phenomenon to be observed on a reproducible basis. It was found that the CdS single crystal must have a relatively high density of traps. Possible mechanisms which may contribute to the phenomenon are discussed"--Abstract, page ii.

A Kinetic Study Of Ti⁺³ Oxidation To Ti⁺⁴ In Hydrofluoric Acid Solutions, Kuo-Shein Shen

Masters Theses

"The purpose of this investigation was to study the oxidation rate of Ti⁺³ to Ti⁺⁴ in hydrofluoric acid solutions in the absence of air. The concentration of hydrofluoric acid was varied from 0.25 to 2.00 M and the concentration of titanium from 0.05 to 0.50 M. The temperature was controlled at 25⁰C. The reaction rate was relatively slow. In most instances, less than 50 percent of the Ti⁺³ was oxidized during a period of 100 hours"--Abstract, page vii.

The Realization And Application Of Parallel Linear Feedback Shift Registers, Ross K. Heitzmann

Masters Theses

"Two methods for serial-to-parallel transformation of linear feedback shift registers are briefly discussed. A third method for transformation is rigorously developed using a next-state and output equation representation of the linear feedback shift register. An algorithm is developed for simplifying the parallel machine resulting from serial-to-parallel transformation, where simplification is defined as reduction in the required number of modulo 2 adders. A computer program incorporating serial-to-parallel transformation and the simplification algorithm is provided "--Abstract, page ii.

Infrared Spectra And Magnetic Properties Of Fluorine Substituted Copper (Ii) Alkanoates, Jose G. Rodriguez

Masters Theses

"The purpose of this study was to prepare some selected copper(II) fluorcalkanoates, investigate their magnetic susceptibilities, study the infrared spectra of these salts and compare these properties to those of the unfluorinated copper(II) alkanoates….

The experimental data obtained indicate that the copper(II) trifluoroacetate, perfluoropropanoate and perfluorosuccinate does not form a binuclear cage structure. Copper(II) 3-(trifluoromethyl) butanoate with a magnetic moment of 1.4 should possess a binuclear case structure similar to copper( II) acetate monohydrate. The structure for copper( II) perfluoroglutarate monohydrate with a magnetic moment of 1.63 B.M. should have a structure somewhere between the two aforementioned structures"--Abstract, page ii.

A Transmission Electron Microscopy Study Of Some High Strength Plain Carbon Steels, George Joseph Vytanovych

Masters Theses

"Methods of preparing foils of high strength, heat treated, plain carbon steels for examination in the electron microscope by the transmission technique were perfected and are described. Two processes for the initial thinning of a bulk sample were successful. A chemical process was found to be more rapid but not satisfactory for small samples. A mechanical process was slower, but was applicable to the smaller specimens. Electro-polishing the thinned material yielded acceptable foils from which photomicrographs of good quality were obtained. The microstructure of the high strength steel samples showed typical tempered martensite. No reasons for the differences in ductility …

A Multiple-Input Chemical 'Memistor' For Adaptive Circuits, Richard Franklin Crall

Masters Theses

"A modification of Widrow’s "memistor" is made in a form suitable for extension to multiple-input devices. This modified form is extensively investigated using analog field maps, and through experimental testing. The multiple-input device presented exhibits good adaptive characteristics and reduces the number of interconnections required in the external circuitry"--Abstract, page ii.

A Comparison Of Strength Properties Of Heat Treated Aisi 1065 Steels At High Strength Levels, Robert Lowell Hollenbeck

Masters Theses

"Six AISI C 1065 steels were heat treated and tensile tested in order to evaluate their ductility at high strength levels. Heat treating and tensile testing procedures were developed for use working with these steels at tensile strengths of 300,000 psi and higher. The austenitizing procedure in the hardening operation was found to affect the strength and ductility of the high strength samples. Rapidly heating to the austenitizing temperature followed by an immediate quench produced better properties than slow heating followed by a soaking period before the quench. However, it was concluded that the carbon contents of the steels studied …

Continuous Countercurrent Evaporation Through Porous Water-Repellent Membrane With Pressure Above Atmospheric, Yung C. Hsu

Masters Theses

"An experimental method for measuring mass transfer rates at pressures above atmospheric has been developed for the case of continuous countercurrent evaporation through porous water-repellent membranes. The final developed equipment is suitable for operation under pressures up to 50 psig and at temperatures near the boiling point of 7% salt water when high flow rates are reached. Rates of evaporation of water through the membrane were measured, and the data and results were used to examine the effects of operating conditions on the over-all mass transfer resistance. Least squares equations for fitting the data were also obtained. Over-all mass transfer …

The Tragic Possibilities Of William Faulkner's Absalom, Absalom!, Carol R. Gray

Masters Theses

No abstract provided.

Administrative Appraisal Of Industrial Arts Education Graduates Of Eastern Illinois University In Graduating Classes 1960-1965 Inclusive, Sam G. James

Masters Theses

No abstract provided by author.

Partial Internship In The Unit Superintendent, High School And Junior High School Principals Offices In Community Unit School District #1, Charleston, Illinois, Paul W. Foreman

Masters Theses

No abstract provided.

Predicting College Success For Five Area Schools, Kenneth Martin Davis

Masters Theses

No abstract provided.

The Political Education Of Alexander Spotswood: The Legislative Sessions Of 1710-1712, Joseph Eugene Orndorff

Masters Theses

No abstract provided.

The Interrelationship Between Pop Art And Advertising, John Edward Pajkos

Masters Theses

No abstract provided.

A Transcription Of Maurice Ravel's Orchestral Suite, Ma MèRe L'Oye (Mother Goose), Anthony Mazzara

Masters Theses

No abstract provided.

Characteristics Of Students Entering Eastern Illinois University Fall, 1965, Leo William Fever

Masters Theses

No abstract provided.

A History Of Vincennes, Indiana, During World War I With Special Emphasis On The German-American Population, John D. Balgenorth

Masters Theses

No abstract provided.

A Study Of Selected Data In Predicting Success In Ninth Grade Mathematics At Jefferson Junior High School, Mattoon, Illinois, Larry K. Stilgebauer

Masters Theses

No abstract provided.

Hamlet The Existentialist: A Comparison Of Hamlet And Kierkegaard, June B. Stark

Masters Theses

No abstract provided.

Effect Of Overload On The Accuracy Of Throwing A Football, Richard Hopek

Masters Theses

No abstract provided.

The History Of Intercollegiate Track And Field At Eastern Illinois University From 1912 Through 1966, Joel A. Justis

Masters Theses

No abstract provided.

Similarities Between Lazarillo De Tormes And Early English Novels, Emily M. Marsland

Masters Theses

No abstract provided.

A Rhetorical Analysis Of Franklin Delano Roosevelt's "First Inaugural Address" - March 4, 1933, Carol Jean Martin

Masters Theses

No abstract provided.

God's Spies: A Study Of The Theological Concepts Of Evil And Grace In Spy Novels, Joan S. Raymer

Masters Theses

No abstract provided.

Student Religious Organizations At Eastern Illinois University, Louis V. Hencken

Masters Theses

No abstract provided by author.

Kindergarten Entrance Age In Relation To School Achievement, Floyd Henson

Masters Theses

No abstract provided.

Implementing A Gifted Program In An Elementary School Of Three Hundred Students, Milburn B. Wardell

Masters Theses

No abstract provided.

Design Of A Nonparametric Detector For Fm Signals, James Charles Fowler

Masters Theses

"The communication engineer has in the past treated the detection problem from a parametric point of view. That is, the signal has been assumed to be of a known deterministic form and the noise of a known statistical form. This approach has proved valuable in many cases, but it is subject to severe limitations, e.g., if either the noise or signal change form, a new detector must be designed. Because of these limitations there is a need to find a more general form of detector.

This study looks at a specific statistic (the Cramér-von Mises statistic) and designs a detector …

Gap-Graded Gravel For Asphaltic Paving Mixtures, Ernest Harrington Martin

Masters Theses

"The objective of this investigation was to determine if naturally occurring gap-graded gravel can produce asphaltic mixtures meeting minimum requirements for satisfactory pavement behavior.

Ten gap-graded mixes were blended by eliminating certain intermediate sized fractions or combination of fractions from the gradation of a control mix. The weight of the fractions eliminated was distributed to either the coarser or finer aggregate fractions.

All specimens were prepared and tested in strict accordance with procedures set forth in ASTM Designation D1559, "Resistance to Plastic Flow of Bituminous Mixtures Using Marshall Apparatus."

The physical properties compared and analyzed were (1) unit weight, (2) …