Digital Commons Network^™

A Study Of The Overachievers And Underachievers At Shelbyville High School, Helen Wolf Harless

Masters Theses

No abstract provided.

Teacher Turnover In The Coles County Public Elementary Schools Of Illinois: 1959-60 Through 1963-64, Gary L. Howrey

Masters Theses

No abstract provided by author.

The Improvements Of Brass Instruments From 1800 To 1850 Including Implications For Their Usage, Delmar T. Vollrath

Masters Theses

No abstract provided.

A Method Of Slide-Making For Early Nervous System Study In The Chick Embryo, Roger L. Pscherer

Masters Theses

No abstract provided.

A Piano Recital Analysis, Seunghyun Choi

Masters Theses

No abstract provided.

The Effects Of Word Affectivity And Mode Of Presentation On Retention, Lawrence W. Lezotte

Masters Theses

No abstract provided.

Studies On The Conversion Of Indole Acetic Acid And Oxindole Acetic Acid By Hygrophorous Conicus, Barbara Ruth Patterson

Masters Theses

"The fungus, Hygrophorous conicus, produces the enzyme, indole acetic acid oxidase, when grown in the presence of indole acetic acid (IAA) or tryptamine. The IAA acts both as an inducer and a substrate for this intracellular enzyme. The product of the oxidation catalyzed by the IAA oxidase is oxindole acetic acid (OIAA). Since the IAA and OIAA absorb maximally at two different wavelengths the use of spectrophotometric analysis was possible for assaying for the IAA oxidase activity. Paper chromatography was used for qualitative identification of the IAA and OIAA. The rate of growth and the rate of formation of the …

The Effects Of Sensory Deprivation On Projection, Bryan R. Ellis

Masters Theses

No abstract provided.

Design Of A Photoelectric Transient Torque And Speed Meter, Raojibhai A. Patel

Masters Theses

"There are many situations in which it is desirable to know the speed of the shaft and the torque it is transmitting, when it is equally undesirable to make any mechanical connection to the shaft. This thesis describes the development and design of a device for measuring the torque and speed by photo-electric means. The basic principle is that a light beam parallel to the shaft may be used to pick up the desired information without adding friction to the system. The deflection of a torque tube inserted in the shaft opens or closes a set of apertures arranged in …

Comparison Of Methods To Select A Probability Model, Howard Lyndal Colburn

Masters Theses

"A comparison is made between the estimates of the parameters in a gamma distribution obtained by the method of moments with those obtained by a numerical approximation to the maximum likelihood estimates. The estimates obtained by the numerical approximation had a smaller mean squared error from the true value than the estimates obtained by the method of moments. Modifications to tests of fit are made in order to develop methods to select a distribution from a set of possible distributions for a population with an unknown distribution. These selection methods are compared in their ability to make correct selections. Although …

Determination Of The Temperature Distribution Of The Ionized Portion Of The Jet From A Vortex Stabilized Plasma Generator Operating On Argon, G. Douglas Schellman

Masters Theses

"The interim thesis deals with the determination of the temperature distribution of a plasma jet operating on argon. It is the purpose of this thesis to present in detail the experimental process used and make a correlation of the experimental and theoretical results.

A copper enclosure was placed around the protruding flame, and the embedded thermocouple readings were taken and recorded. A stagnation temperature probe was inserted in the enclosure and moved both axially and transversely toward the flame taking readings at each pre-chosen interval. The exit temperature of the jet was obtained from a total energy balance.

From the …

Turbulence In Journal Bearings, Kashyap R. Mehta

Masters Theses

"In this investigation, an experimental study was performed on a journal bearing under laminar and turbulent flow conditions. Using relationships for friction factor developed previously by other investigators a comparison was made with results of this present investigation. Since the flow changes from laminar to turbulent with a change in speed of rotation, curves for friction factor as a function of speed were plotted. Various attempts to make the recording and measuring systems more sensitive were also made and are discussed in this thesis"--Abstract, page ii.

A Photoelastic Study Of The Effect Of Certain Geometric Variables On The Plane Stress Distribution In An Electrical Insulator Body, Richard L. Pendleton

Masters Theses

"Photoelastic models were used to indicate stress patterns in various geometrically designed shapes. Each model represented a two-dimensional cross-section of the interior portion of an axially symmetrical porcelain electrical insulator. Five different loading pins were combined with three loading heads to produce eleven models. The maximum stress in each model was determined using a photoelastic method of stress analysis. An attempt was made to select the best structural design to be used in an electrical insulator. The test results indicate that the most desirable stress distribution is obtained using a single step loading pin and that the loading head angle …

The Dielectric Properties Of A Synthetic Fluor-Mica Formed By Glass-Ceramic Fabrication Techniques, Ray Fred Schumacher

Masters Theses

"A tetrasilicic fluor-mica, K₂Mg₅Si₈O₂₀F₄, was synthesized, utilizing glass forming techniques and subsequent heat treating of the mica glass. Discs, approximately two inches in diameter, were formed and heat-treated at selected temperatures between 700⁰C. and 1150⁰C. for various time periods. Density change, weight loss, shrinkage, and dielectric properties were measured to determine the characteristics of this material"--Abstract, page ii.

The Effect Of Submerged Jets On The Hydraulic Jump, Harvey E. Jobson

Masters Theses

"Tests were performed in order to determine the effects of forcing submerged jets of water into the base of a hydraulic jump. The specific energy of the water leaving the hydraulic jump, the length and the wave formation properties of the jump which had been modified by the introduction of submerged jets were determined and compared with the same characteristics of a normal hydraulic jump and a hydraulic jump which had been modified by the use of baffle piers.

Test results indicate: (a) the quantity of water flowing through the submerged jets is a primary factor in determining the specific …

Transient Temperature Distribution In A Finite Cylinder And An Infinite Cylinder Subjected To Some Boundary Conditions, Harng-Sen Huang

Masters Theses

"This thesis is concerned with the theoretical heat transfer analysis of solid cylinders. The first problem considered is the transient temperature distribution in a finite cylinder. This cylinder has a uniform initial temperature and a uniform constant surrounding temperature. This case is solved by the separation of variables. Combining the charts for the infinite cylinder and the charts for the infinite plate one can determine the solution to this case easily. If a uniform constant surface temperature is prescribed instead of a surrounding temperature, the solution can be obtained from the previous one by charging the Nusselt number to infinity. …

The Development And Evaluation Of An Experimental Technique To Determine Stress Distribution In Uniformly Loaded Flat Plates, James William Walker

Masters Theses

"This thesis reports and evaluates an experimental technique that was developed to determine and monitor the stresses in a simply supported, uniformly loaded circular plate. Deflections are less than half the thickness of the plate. The application of the developed technique to plates whose integrity has been compromised with holes in various locations is discussed.

Resistance strain gages were used to determine experimentally the stresses in a simply supported, uniformly loaded circular plate with and without a concentric hole. The accuracy of the experimental results was established to be within approximately six percent of theoretical.

Proper application of the experimental …

Cylinder-Head Surface Temperature And Maximum Pressure In A Diesel Engine, Jayant M. Patel

Masters Theses

"This report presents the result of an experimental investigation on the effect of 1) fuel consumption in a diesel engine on the mean cylinder-head surface temperature 2) engine speed and load on the maximum cylinder pressure.

A fast-response thermocouple was fixed in the cylinder head and temperatures were measured for various load and speed conditions. An attempt was made to record a transient surface temperature versus crank-angle diagram. Some doubt as to the reliability of this recording may arise because of the very small amount of time lag in the thermocouple action. This is immaterial to the subject of this …

A Study Of Certain Conservative Sets For Parameters In The Linear Statistical Model, Roger Alan Chapin

Masters Theses

"In the case of the linear statistical model, it has been shown that under certain conditions the confidence intervals obtained by considering the parameters one at a time are conservative when used as a joint confidence region, using the product of confidences as the confidence. However, nothing had been known of how conservative they are. This research provides accurate estimates of the true confidence for these cases.

Also, it has not yet been proved that they are indeed conservative for all cases. It is thought that they are, and the results of this research support this conjecture"--Abstract, page ii.

The Construction Of A Single Crystal Neutron Diffraction Unit And Measurement Of Effective Neutron Temperature, Larry Dean Thompson

Masters Theses

"The continued expansion of the nuclear reactor facility and the nuclear engineering program makes it desirable that a neutron spectrometer be available at the reactor facility. This unit would be available for use in graduate and undergraduate laboratories and for graduate research.

A single crystal, white radiation spectrometer including collimator, automatic controls, and shielding was designed and constructed.

The performance of the unit was checked using LiF and Cu crystals. A rocking crystal curve and a θ - 2θ curve was obtained with each crystal. The effective neutron temperature was then determined from the LiF crystal θ - 2θ curve"--Abstract, …

The Elastic And Anelastic Constants Of A Synthetic Fluor-Mica Formed By Glass-Ceramic Fabrication Techniques, John H. Ainsworth

Masters Theses

"A tetrasilicic fluor mica, K₂Mg₅Si₈O₂₀F₄, was synthesized using glass forming techniques. Density changes, weight losses, and shrinkage, as well as elastic and anelastic properties, were measured on bars heat-treated at selected temperatures between 500°C and 1150°C to determine the characteristics of this material. Phase changes were followed by determining thermal expansion, logarithmic decrement, and modulus of elasticity from room temperature to 800°C.

It was found that the elastic and anelastic constants decreased gradually with heat treatments from 600°C to 1000°C. This indicated progressively increased structural ordering. Heat treatments above 1000°C …

The Transmission Of Loads To Point Bearing Piles In Sand Beneath Retaining Walls, Alan Albert Kamp

Masters Theses

"An experimental investigation was made of the way in which loads were transmitted to point bearing H-piles in sand under a retaining wall. Using a plastic model, the moments and axial loads were determined along the length of the pile by measuring the strains with electric strain gages. A comparison was made of the experimental results at the top of the pile and the analytical results at this point; the latter obtained from the common practice used in design. The comparison was very poor because the excessive horizontal load (that part of the horizontal load which could not be carried …

Analysis Of Continuous Folded Plate Roofs, Yung-Ping Wang

Masters Theses

"This work presents an analysis of continuous folded plate roofs considering the effects of relative joint displacements. For this analysis the normal modes of the lateral beam vibration were used as the form of the deflection curve and the loading was sinusoidal. By using symmetry and anti-symmetry, a possible method of analyzing prismatic folded plate roofs comprising one bay transversely but continuous over two or more spans longitudinally is suggested"--Abstract, page ii.

Thermal Degradation Of Poly (Methyl Methacrylate) In Solutions In A Closed System, Vikram Pranjivandas Parikh

Masters Theses

"A study has been made of the thermal degradation of poly (methyl methacrylate) of two different molecular weights, 2,303,000 and 43,000, in 1,2-dichloroethane in a closed system. The results indicated that the polymer having a molecular weight of 2,303,000 undergoes degradation while the low molecular weight polymer 43,000 undergoes reverse polymerization, and the molecular weight remains constant. The molecular weight of high molecular weight samples after 48 hours decreased from 2,303,000 to 2,232,000 and 1,690,400 at 50⁰C and at 98.5⁰C, respectively"--Abstract, page [i].

Model Study Of A Folded Plate Roof, Graham G. Sutherland

Masters Theses

"The purpose of this study was to conduct a model study of a folded plate roof in order to determine the feasability [sic] of using model studies as a method of design. Dimensional analysis was used to derive prediction equations for determining the stresses in two prototype structures, when the stresses in the model were known. One model and two prototype folded plate roofs were constructed of plexiglas [sic]. SR-4 strain gages were attached to the structures and strain readings taken as a uniform vertical load was applied in increments. From the strains the stresses at various points in the …

Optimum Finite Memory Nonlinear Filter, Ching-Chyoun Yang

Masters Theses

"This thesis investigates the possibility of using the Zadah theory and a machine type computer to design an optimum finite memory nonlinear filter for extraction of Poisson distributed signal pulses from a background of Gaussian noise. Basically the procedure involves the technique of solving simultaneous equations by the computer. We demonstrate that it is possible to find the limitation of the filter of class N₁ in terms of an absolute minimum mean square error. However, due to the capacity of the computer we do not actually determine the absolute minimum. Nevertheless we do show that the mean square error decreases …

An Instrument For The Measurement Of Anelastic Properties Of Glass, Thomas Frederick Miller

Masters Theses

"An inverted torsion pendulum for measuring the internal friction and dynamic shear modulus of glass fibers over an extended temperature range has been constructed and calibrated. The calibration consists of the determination of the moment of inertia. Extraneous damping losses were investigated and primary sources were found to be (1) the suspension thread, (2) the method of securing the fiber and (3) air damping. Anelastic measurements were made on an annealed vitreous silica fiber and a soda-lime-silica fiber"--Abstract, page ii.

Discharge Characteristics Of Side Weirs, Edgar Snowden

Masters Theses

"The purpose of this study is to investigate the division of flow of water in a flume of rectangular cross-section when the flume is provided with a side weir. An equation has been derived so that the quantity of water flowing over the side weir compared to the quantity of water flowing in the main channel can be predicted. This ratio is acceptable only within the ranges of heads, velocities, and weir lengths imposed by the geometry of the system tested"--Abstract, page ii.

Time Effects Of Subthreshold Stimuli Upon Supraliminal Stimuli, Martin Resnick

Masters Theses

No abstract provided.

A Study Of The Preparation Of Student Teachers For The Use Of The Instructional Materials Center In The Buzzard Laboratory School, Virginia Hagebush

Masters Theses

No abstract provided by author.