Digital Commons Network^™

Halogenated Epoxide-Phenol Reactions A Mechanism Study, Richard L. Rowton

Masters Theses

"The object of this investigation was to study the reactions of two other halogenated epoxides--namely, 3-bromo-1,2-epoxybutane and l-bromo-2,3-epoxybutane--with the phenolate ion, with the hope that the results obtained would shed additional light upon the mechanisms of such reactions. At the present time, no direct practical applications of the results can be forseen. However, the information gained will be a worthwhile addition to the vast existing store of knowledge already at our disposal, and might be of some help to future investigators"--Introduction, page 2.

The Application And Utilization Of Mining Models For Instruction And Display, William M. Shepard

Masters Theses

"The subject of the utilization of mine models for instruction and display at institutions offering courses in mining engineering has not been widely discussed in the literature. The value of models as visual aids in teaching has long been recognized, and they have been extensively employed by some institutions and by some instructors. However, the writer believes that a wider range of types of models are suitable for instruction purposes than have been employed in the past, and that mining models, properly arranged and adequately labelled, may be used in displays to give both the layman and the beginning student …

Porosity-Permeability Relationships Of Unconsolidated Sands, Robert Marchel Ponder

Masters Theses

"Unconsolidated sand reservoirs containing oil and gas present difficult problems to the petroleum engineer. Among these problems is that of the determination of the reservoir porosity to facilitate oil and gas reserve and evaluation calculations.

This problem is especially difficult because, to the author's knowledge, no method has been devised to obtain a core sample of the unconsolidated sand that retains the same porosity and permeability characteristics in the laboratory as it had underground. As a result, the petroleum engineer must rely upon empirical methods of calculating the reservoir porosity when the sand is not consolidated.

Many investigators have attempted …

An Experimental Study Of The Effect Upon The Current Distribution And Radiation Pattern Of Crossbars On Yagi Receiving Antennas, Gerald F. Sinnamon

Masters Theses

"The development and widespread use of radar systems in World War 11, and the post-war television boom, has brought about a large amount of investigation in antenna arrays. One of the types of antennas commonly used on radar systems during the early part of the war, and one which finds wide usage today as a television receiving antenna, is the well known Yagi antenna...

Since television antennas are usually mounted out of doors, the antenna must be made mechanically strong to prevent whipping or twisting due to wind, and to prevent sagging due to icing or to its own weight. …

A Study Of The Effect Of Jointing On The Blasting Of Granite, Graniteville, Missouri, Avery Ala Drake

Masters Theses

"Purpose of investigation: The purpose of this investigation is to attempt to determine the influence that joints exert upon the blasting of granite and if joints are induced by blasting. The problem grew out of an explosive evaluation project that was conducted by the Mining Department, Missouri School of Mines. In late May 1950, the project was moved into the granite area near Graniteville, Missouri. It became apparent upon study of this area that the jointing would have certain effects upon the results obtained. Dr. J. D. Forrester, Chairman, Department of Mining Engineering, Missouri School of Mines, Rolla, Missouri, suggested …

The Partition Function Of Silver, Ralph H. Lilienkamp

Masters Theses

"The study of the thermodynamic properties of solids at low temperatures has shown that most theories either break down or become too cumbersome.

A theory based upon a crystal lattice of atoms gives the best physical picture of a solid. Fisher has developed partition functions from this theory for the simple cubic, body-centered cubic, and the face-centered cubic lattices. In his paper Fisher gave three partition functions of increasing complexity and accuracy for each of the three lattices. In this paper the three partition functions for a face-centered cubic lattice shall be applied to silver and compared.

The Helmholtz free …

A Study Of Size Of Diamonds In Diamond Drilling, Robert J. M. Miller

Masters Theses

" ''A Study of Size of Diamonds in Diamond Drilling' is the research problem which will be discussed in this treatise.

The author's interest in the effect of size of diamonds was created by Mr. R. D. Longyear of the E. J. Longyear Company of Minneapolis, Minnesota. Mr. Longyear, when asked for suggestions for a research problem concerning diamond drilling suggested, among other things, that there was a need for further work on the factor of size of stones. After extensive reading and reviewing, the author learned that many investigators had recognized changes in results attributable to changes in size …

An Investigation As To The Uses Of The Topographic Map And Improvements Desired By The General Public, George O. Boeckman

Masters Theses

"The demand for topographic maps from hunters, fishermen, vacationers, professional engineers etc, has been increasing with each passing year. In 1940 people bought some 700,000 copies of topographic maps. In 1946 sales had jumped to well over 2,000,000 copies. Civilian use of these maps by veterans has contributed substantially to the tremendous expansion of demand for maps since World War II. In recent years, the quality of topographic maps has been greatly improved by refinements in methods and by the use of aerial photography in map compilation. This advancement, and an ever-increasing demand from engineers, geologists, and many others for …

Autographic Determination Of Thermally-Induced Linear Changes In Ceramic Bodies, William Dean Mckee Jr.

Masters Theses

"The determination of changes in length of ceramic compositions as a function of temperature is frequently required in ceramic research and testing. With the use of an observer, excellent means are available for determination of changes in length over moderate ranges of temperature. However, the extended period required for some tests makes desirable the automatic recording of length change as a function of temperature.

There has been in use in the Ceramic Engineering Department a furnace arranged for determination of length changes; this furnace, shown in Figure 1, is so arranged that change in sample length causes linear displacement of …

An Economic Study Of The "C" Factor, David Hunter Robinson

Masters Theses

"After due consideration of the facts and hypothetical conditions enumerated herein, it was decided that this work would be devoted to developing a means of determining the most economical “C” factor to be used; one that will be consistent with ease of operating the plotting machine, the required accuracy of the finished compilation and economy. In other words, the highest value of the "C" factor that will produce results within the accuracy requirements under normal operating procedures.

As a secondary project, it was decided to plot a curve using points determined by analyzing a series of spot readings made at …

Hydrology Of Small Drainage Areas, James Kinchen Searcy

Masters Theses

"Realizing the need for data on small drainage areas the Missouri Highway Commission in 1947 began a cooperative project with the Water Resources Division of the United States Geological Survey which includes the establishment of small area gaging stations and recording rain gages.

The purpose of this investigation is to study some of the data collected in the few years of operation of these small area stations with the aim of testing some of the hydrologic tools useful in the study of larger drainage basins to determine their applicability on small drainage basins. The relationship between the runoff of large …

An Investigation Of End-Anchorage And Performance Of Sr-4 Strain Gages On A Prestressed Concrete Beam, Howard W. Nunez Jr.

Masters Theses

"In recent years there has been brought to the attention of engineers and architects a new medium of construction---prestressed concrete. Reinforced concrete has long been recognized as a satisfactory material for use in the construction of buildings, bridges, highways, tanks and other structures. However, most concrete designers will concede that this material has many drawbacks. For instance, in a simple beam of rectangular cross-section, roughly only one half or the concrete is relied on to resist compressive forces. The tensile strength of the concrete is considered to be zero, and steel bars or rods must be inserted to carry the …

The Effect Of Grain Size On Shearing Strength Of Sand, Keyhan Samimi

Masters Theses

"The object of this study is to determine experimentally the effect of definite grain size on the shearing characteristics of sandy soils. As it will be discussed in detail under the article - The Mechanics of Shear, the shearing characteristics of sandy soils depends on many factors such as grain size and shape, soil structure and relative density, the water content of soil. An attempt is made throughout the entire investigation to determine the effect of definite grain size on the shearing value and the angle of internal friction under the dry and saturated conditions. Furthermore, the results of shear …

Design Of A Galvanometer To Be Placed Within A Tubular Antenna For The Purpose Of Measuring Antenna Current Distribution, Ferdinand Henry Mullersman

Masters Theses

"The object of this paper is to design such a galvanometer for application to cylindrical UHF antennas and to discuss the procedure involving its use. The galvanometer will then be placed inside a completely isolated parasitic antenna and the distribution of current along the antenna will be measured"--Introduction, page 5.

4-Benzoyl-4-Methyl-1, 2-Epoxypentane, An Attempted Synthesis, Robert L. Snell

Masters Theses

"The object of this research was to prepare first the simplest homologue of the epoxy-ketone considered by Russell to have been his product. If this homologue, 4-benzoyl-4-methyl-1,2-epoxypentane, could be prepared and caused to form a cyclic derivative of the type given by 1,4-diketones with 2,4-dinitrophenylhydrazone, the organic chemist would be given a new approach to substituted 1,2-diazines as well as a previously unreported reaction of the epoxide grouping. If this reaction could be made to occur, other epoxides of this series would be prepared and treated in the same manner.

It was decided that the shortest route to 4-benzoyl-4-methyl-1,2-epoxypentane would …

A Comparison Of The Real Price And Market Price Of Some Common Metals, Kon-Hock Khaw

Masters Theses

"A number of complex factors influence the fluctuation of the price of a metal. In this investigation, the writer is concerned with the influence of the purchasing power of the dollar and, therefore the difference between the value (real price) and market price of nine metals. That is, this is a study of metal prices and their corresponding values. No attempt is made to analyze the supply and demand of the past or the future, except as they are expressed by their function -- price.

To aid in the comparison, a set of index numbers for metals is compiled and …

A Study Of The Dissolution Of Titanium In Acids With Ammonium Fluoride Added, Charles Burroughs Gill

Doctoral Dissertations

"Titanium can no longer be considered a rare metal, even though the modern era of its production came into being only a few years ago. The first discovery of titanium was in 1791 by an English clergyman, the Reverend William Gregor, and the name titanium became universally adopted when so called by a German mineralogist, Martin Klaproth, who rediscovered titanium three years later. Not until 1887 was the relatively pure, 75 percent, metal prepared by L. F. Nilson and O. Pettersson, whose experiments were repeated in 1910 by M. A. Hunter. Hunter is given credit for producing the first metallic …

Determination Of Progressive Corrosion Of Clay Flux Blocks, Ved Prakash Maheshwary

Doctoral Dissertations

"The Problem. Corrosion of refractories by molten corrosive liquids like molten slags and glasses is of general occurrence in those parts of the furnaces where they come in contact with the liquids. The life of a furnace generally depends upon the progressive rate of corrosion of the refractories by the slags and glasses. There have been various methods used by the investigators to ascertain the useful life of a refractory product before its use in the furnaces, but the problem is so complex that even after decades of research work by the research engineers and technologists a satisfactory and easy …

Shaped Charges: Their Mechanism And Applications In Mining, Pranlal Girdharlal Sheth

Doctoral Dissertations

"A shaped charge, confined or unconfined, is a unit of explosive material with a cavity or hollow at the base. It behaves differently than an ordinary charge, and, when detonated, has been found to produce curious effects of concentrating the force of the explosive on an area opposite the cavity"--Introduction, page 1.

Geochemical Prospecting Applied To The Illinois-Kentucky Fluorspar Area, Matthew Peter Nackowski

Doctoral Dissertations

"This study was completed to determine whether geochemical methods of prospecting could be applied to the search for fluorspar deposits in the Illinois-Kentucky fluorspar district.

During the course of the study, aspects of the geochemical cycle of fluorine under the climatic environment encountered were noted in the zone of weathering.

The Illinois-Kentucky fluorspar district supplies a large portion of the fluorite consumed in the United States. The producing deposits are of two geologic types. The vein deposits occur as nearly vertical tabular lenses or pods which occupy fractures. These deposits may reach the bedrock surface, but in any case, the …

The Missouri Miner, December 14, 1951

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, December 07, 1951

The Missouri Miner Newspaper

No abstract provided.

Direct Reduction Of Zinc Sulfide Under Vacuum -- Course Work, Merritt E. Langston

Missouri School of Mines and Metallurgy Reports

A study of the reduction of zinc sulfide under vacuum by such reducing agents as iron, calcium oxide and carbon, graphite, and iron and carbon.

An attempt to refine the impure zinc metal condensates obtained from the above reductions under under by the mechanism of a differential displacement of the volatile constituents.

The Missouri Miner, November 30, 1951

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, November 16, 1951

The Missouri Miner Newspaper

No abstract provided.

Missouri S&T Magazine, November-December 1951, Miner Alumni Association

Missouri S&T Magazine

No abstract provided.

The Missouri Miner, November 09, 1951

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, November 02, 1951

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, October 26, 1951

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, October 19, 1951

The Missouri Miner Newspaper

No abstract provided.