Digital Commons Network^™

Grain Boundary Diffusion In Ionic Crystals, Kulwant Singh Sabharwal

Doctoral Dissertations

"The diffusion of ¹³¹I in single crystals and along the tilt grain boundaries of pure and calcium chloride doped (142±5 ppm) bicrystals of sodium chloride, grown by Czochralski technique, was investigated using a microtome sectioning technique. Results on bulk diffusion in pure NaCl agree well with the results of earlier investigators and are represented by the D=(504 cm²/sec)exp (-2.27 ev/kT). Enhanced diffusion of ¹³¹I is observed along the grain boundaries and the presence of the dopant lowers the grain boundary diffusivity over the entire temperature range of 430ºC - 570ºC studied in the present investigation. Thermal activation and electrical polarization …

Nonrandom Characteristics Of Common Stock Prices, Donald Leroy Gaitros

Doctoral Dissertations

"This study presents an application of operations research techniques to the development of stock price generation and simulation models to aid in the understanding of price movement. Relationships between stock price and volume and stock price and market averages which follow descernible trends and patterns are discovered. Technical trading rules are developed based on these relationships which empirically have shed doubt on the random walk hypothesis of price movement. This in turn gives evidences that technical analysis can be an aid to price forecasting"--Abstract, page ii.

Computer Assisted Teaching Of Steel Design, Wendelin Henry Mueller Iii

Doctoral Dissertations

"A method for use in creating a university level course is presented. The specifics of each of the steps is given in general terms to allow its application to as many different topics as possible. This method is then specifically applied in the formation of a fundamental steel design course using the American Institute of Steel Construction Specification. The reasoning utilized in each phase of development is documented. A lecture style presentation complemented by a series of student oriented computer programs was chosen for use. The details of the course material in outline form is given along with the computer …

Trend Surface Analysis As An Aid In Exploration For Mississippi Valley Type Ore Deposits, John Siegfried Trapp

Doctoral Dissertations

"The conditions necessary for emplacement of Mississippi Valley-type mineral deposits can be expressed using mathematical symbols as a function of the pre-depositional topography of the host formation and post-depositional structure. These conditions can be observed and analyzed in the Missouri region from residual maps of trend surface analysis of the Precambrian surface. In areas where the topography prior to deposition of the ore bearing horizon has been strongly altered by the deposition of the basal Paleozoic formation the Lamotte Formation residual maps from trend surface analysis of the top of the Lamotte better illustrate these conditions. The Lamotte Formation in …

Hydro-Thermal Generation Unit Commitment And Dispatch Using A Dynamic Programming Approach, Warren Dean Graham

Doctoral Dissertations

"The problem of thermal unit commitment is solved with dynamic programming. A practical example is given which solves the problem for a six generator system over a one year time span. This long range solution is used with a hydro optimization procedure to give an optimized hydro-thermal unit commitment solution. From this, a worth of hydro value is computed for each month, which may be used in the daily dispatching of thermal units and hydro. Applications of the program are also shown for aiding in generator maintenance scheduling and evaluating purchase power contracts with neighboring utilities. Error analysis is made …

Effects Of Cr-Plating And Environment On The Cracking Of Low Alloy Steels At High Temperatures, Robert C. Tooke

Doctoral Dissertations

"The cracking of low alloy Cr-Mo-V steels under cyclic stress at 1000-1100°C. was studied using a specially designed test apparatus. The results obtained from specimens plated with hard chromium are compared to those of unplated specimens. Tests conducted in gas mixtures of carbon monoxide and carbon dioxide showed that a high CO/CO₂ ratio retards cracking in both plated and unplated specimens. Both external and internal oxidation are used to explain these results. Inherent microcracks in the hard chromium plating promoted cracking in all CO/CO₂ environments. It was also found that these steels are severely embrittled in the presence …

An Experimental Investigation Of The Effects Of Ambient And Heated Steady Flow And Intense Sound Levels On The Response Of Acoustic Filter Elements, Raymond H. Schaffart

Doctoral Dissertations

"The primary purpose of this research was to investigate the effects of flow and finite amplitude waves on the response of acoustic elements. A further purpose was to evaluate the effects of elevated temperatures and cross-sectional dimensions on element performance. As an integral part of this work various laboratory techniques were explored for their suitability.

Empirical models for the acoustic impedance of side branch resonators were developed for the two operational modes, i.e., flow past the resonator and finite amplitude wave inputs. A description of the complex variation of the acoustic resistance of the resonator with flow past and variable …

A Monte Carlo Calculation Of Neutron Reflection From Various Curved Surfaces, Charles Jack Kalter

Doctoral Dissertations

"Plane parallel neutron beams normally incident upon the curved surface of a solid reflector are studied with the Monte Carlo method. The geometries studied are cylindrical, parabolic, and hemispherical. It is shown that when the curved surface is cylindrical, a small "focusing effect" occurs in the reflected neutron beam. Parabolic and hemispherical surfaces do not show "focusing". A study of the factors which determine the spatial dependence of the reflected flux shows that the probability of emergence of a neutron, traveling a fixed distance from a point inside the reflector, depends upon the curvature of the surface. It is only …

The Missouri Miner, December 08, 1971

The Missouri Miner Newspaper

No abstract provided.

Current Mechanical Fastener Specifications And Test Procedure, John Fraczek

American Iron and Steel Institute (AISI) Specifications, Standards, Manuals and Research Reports (1946 - present)

No abstract provided.

Missouri S&T Magazine, December 1971, Miner Alumni Association

Missouri S&T Magazine

No abstract provided.

The Missouri Miner, December 01, 1971

The Missouri Miner Newspaper

No abstract provided.

Thermal Expansion Of Tungsten At Low Temperatures, Jayant S. Shah, Martin E. Straumanis

Materials Science and Engineering Faculty Research & Creative Works

Lattice parameters, thermal expansion coefficients, and Grüneisen parameters of tungsten are determined by an x-ray method in the temperature range of 180-40 K without the use of liquid gases. Lattice parameters are expressed as a function of temperature. Thermal-expansion coefficients decrease with temperature and show no anomaly in contrast to a hypothesis proposed by Featherston and Neighbours. Grüneisen parameters γ are decreasing with temperature in accordance with the theoretical predictions. © 1971 The American Institute of Physics.

The Missouri Miner, November 17, 1971

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, November 10, 1971

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, November 03, 1971

The Missouri Miner Newspaper

No abstract provided.

Mössbauer-Effect Studies Of The Phase Transitions In Antiferroelectric Pbzro₃ And Ferroelectric Pbti₀.₀₂Zr₀.₈O₃, James P. Canner, C. M. Yagnik, Robert Gerson, William Joseph James

Physics Faculty Research & Creative Works

The Mössbauer spectra were studied for the antiferroelectric compound PbZrO₃ and for the closely related ferroelectric PbTi_0.2Zr_0.8O₃. In both cases, a substitution of 5-mol% BiFeO₃ was made to permit the Mössbauer measurements. Little difference was found in the isomer shift in these compounds, whether they were in the ferroelectric, antiferroelectric, or cubic state, indicating that the bonding character is not affected by the transitions among the states. There was a pronounced and approximately equivalent dip in the recoil-free fraction at the Curie points of both the antiferroelectric and ferroelectric materials, associated with …

The Missouri Miner, October 20, 1971

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, October 13, 1971

The Missouri Miner Newspaper

No abstract provided.

Front Matter, University Of Missouri--Rolla

Symposia on Turbulence in Liquids

No abstract provided.

Turbulent Interface Detector Using A Multiple Array Of Single Hot Wires, W. H. Schwarz

Symposia on Turbulence in Liquids

Intermittency circuits can be used to experimentally determine some of the properties of the turbulent interface that occur in turbulent shear flows. The signal I(x,t) is unity if turbulence is present at x and zero otherwise. Using the signals obtained from detectors at one or more points, certain statistical measures of the interface position Y(x,t) can be determined. Also using a linear array of conventional single hot-wire probes, the position of the interface can be detected continuously to within some small error. The intent of this h-detector is similar to the wave-height detector used in studies of sea surfaces. The …

Experiments In Magneto-Fluid-Mechanic Natural And Forced Heat Transfer From Horizontal Hot-Film Probes, P. F. Dunn, P. S. Lykoudis

Symposia on Turbulence in Liquids

Experiments investigating magneto-fluid-mechanic effects on the heat transfer of quartz-coated hot-film probes are described. A standard heat transfer-velocity calibration curve is obtained by traversing a probe, whose axis is aligned horizontally, in the presence of a magnetic field parallel to the probe's axis. The working medium is mercury. Results indicate a significant reduction of the probe1s heat transfer in both the free and forced convection regimes.

Turbulence Measurements With The Split-Film Anemometer Probe, B. W. Spencer, B. G. Jones

Symposia on Turbulence in Liquids

The newly developed split-film anemometer probe, manufactured by Thermo- Systems, Inc. of St. Paul, Minnesota, has been applied to the measurement of two-dimensional turbulence characteristics, including turbulent shear stress, in mixing layer and boundary layer shear flows. Probes of both 6-mil and 2- mil diameters were used which had the same physical dimensions as ordinary hot-film anemometer probes. The film on this sensor is split into two 170° elements resulting in two independent sensors. This enables the probe to detect vertical as well as axial components of the instantaneous velocity vector. It therefore serves the same purpose as an x-probe, …

The Unpolarized Electrode In A Pulsating Poiseuille Pipe Flow, B. M. Bergmann, T. H. Hodgson

Symposia on Turbulence in Liquids

In recent years three workers have described methods of measurement of unsteady flow quantities in water using unpolarized electrodes. Both Binder and Chuang have attempted measurements of turbulent velocity fluctuations, whereas Dumargue described a method of fluctuating pressure measurement.

In this paper, analysis and experiment were used to critically compare the previous workers' experiments. From measurements in an oscillating Poiseuille pipe flow it is concluded that an electrode positioned in the wall detects a signal with a phase angle of π/4 ahead of the fluctuating velocity as measured by a hot-film probe in the pipe center. This is exactly the …

Current Investigations Of Turbulent Shear, S. J. Kline, G. R. Offen, W. C. Reynolds

Symposia on Turbulence in Liquids

The paper covers first a short review of the history of research on turbulent shear and second a description of current experiments which may lead to further understanding.

The first portion categorizes the kinds of data which have been taken and discusses what can be learned from each. It then summarizes what is firmly established concerning the nature of turbulent shear, mostly from work of the past decade. A description of the several interpretations of these data under theoretic study by current leading researchers is then given.

The second portion of the paper discusses the extraordinarily difficult problem of identifying …

Interpretation Of Hot-Film Anemometer Response In A Non-Isothermal Field, W. E. Burchill, B. G. Jones

Symposia on Turbulence in Liquids

A new technique for interpretation of hot-film anemometer sensor response is described. This technique has been applied to simultaneous measurement of profiles of mean velocity, the three components of velocity vector fluctuation, and temperature fluctuation in non-isothermal pipe flow of water using multiple sensors. Sensors operated in the constant temperature mode (CTA) respond to both mean and fluctuating velocity and temperature. The influence of mean temperature gradient on CTA sensor response was eliminated by appropriate adjustment of the sensors' operating resistances as the temperature gradient was traversed. The adjustments were derived from analysis of linearized CTA sensor response. A sensor …

On Velocity Measurements In Non-Isothermal Turbulent Flows, R. Chevray, N. K. Tutu

Symposia on Turbulence in Liquids

Turbulent velocity measurements in non-isothermal flows are conventionally performed by constant current hot-wire anemometry. The procedure involved however is cumbersome, the output signals are nonlinear and more critically a continuous signal of velocity fluctuations is not provided. The method described here utilizes two orthogonal wires situated a fraction of a millimeter apart. The upstream wire is operated in a low overheat, constant-current compensated mode thus providing a signal proportional to temperature while the down-stream wire, practically unaffected by the thermal wake of the first wire is operated in the constant temperature mode. Compensation for the effects of local temperature on …

Near Wall Visual Measurements In Drag Reducing Flow, H. C. Hershey

Symposia on Turbulence in Liquids

A review of several explanations for the mechanisms of drag reduction is presented. Visual studies of ordinary liquids are reviewed briefly, and visual studies in drag reducing flow are discussed. Finally, current work at Ohio State University is described where high speed motion pictures will be taken of drag reducing flow using the technique of Brodkey and Corino.

Wavevector/Frequency Spectrum Of Turbulent-Boundary-Layer Pressure, D. M. Chase

Symposia on Turbulence in Liquids

Knowledge of the wavevector/frequency spectrum of wall pressure, P(K,ω) [K = (k₁,k₃)], for a normal turbulent boundary layer has been largely confined to properties depending on the mean-convective ridge (k₁=ω/u_c). Recent theoretical work yields the wavevector dependence of P(K,ω), for flow at low Mach numbers, also in the acoustic wave number domain where K ≤ ω/c, except for undetermined functions of ωδ/U_∞. In the nonconvective but incompressive domain of wavevectors (important in underwater acoustics), apart from the proportionality to K² where ω/c ≤ K ≤ δ^-1, the …

Measurements To Elucidate The Mechanism Of Drag Reduction, R. J. Hansen

Symposia on Turbulence in Liquids

A number of investigators have attributed the reduced turbulent flow drag exhibited by polymer solutions to their high elongational viscosity. The results of a recent theoretical study of drag reduction are summarized, which show that it may instead be a consequence of the non-Newtonian behavior of polymer solutions in time-varying shear fields. Experiments are proposed to ascertain the relative importance of these transient shear effects and elongational effects in reducing drag.