Digital Commons Network^™

Investigation Of Economic Design Procedure For A Rigid Frame, Richard S. Groner

Masters Theses

"This work presents an analysis of various arrangements of component parts of a rigid frame. From this analysis a procedure is indicated for a logical choice of member sizes for a first trial selection of a frame for given loading conditions. The first trial solution yields a frame which is in the range of an economical design"--Abstract, page 2.

The Conducting Sheet Analogy For Laplace And Poisson Equations, Ronald Edward Volker

Masters Theses

"This investigation determined the accuracy to be expected with conducting sheet analogy solutions for Laplace and Poisson equations using simple and relatively inexpensive instrumentation. Several problems were solved experimentally and compared to known theoretical solutions to check variables in the technique and the accuracy of the experimental solution. It was found that if proper procedures are followed, solutions can be obtained rather rapidly and with an error of less than 5% which compares favorably with accuracy obtained by other investigators with more complex, precise equipment"--Abstract, page 2.

Imperfections In A Silicon Crystal Studied By The X-Ray And Density Method, Pierre Borgeaud

Masters Theses

"The study of imperfections in several crystals of silicon was conducted by the x-ray and density method"--Abstract, page 2.

The Determination Of The Heat Transfer Film Coefficients Of Internally Heated And Twisted Strips, Karpurapu Venkata Apparao

Masters Theses

"As the demand for power supply is increasing, the power from nuclear fission is assuming an important role in the field of power production. The enormous quantity of heat generated during the fission process can be utilized for the generation of power. To get maximum advantage out of the fission process, the fission material must be fabricated into a unit of proper shape to permit the control of the process and safe removal of heat generated. This unit, composed of fuel elements is known as the reactor core and is one of the major concerns in nuclear power development.

The …

Analysis And Simulation Of A Cross-Correlation Communication System, Dennis Jay Gooding

Masters Theses

"Statement of the problem. The purpose of this study was (1) to calculate the probability of error as a function of receiver input signal-to-noise ratio for a typical communication system employing cross-correlation detection; (2) to design and construct an experimental model of such a communication system for the purposes of demonstrating the operation of the system and verifying the theoretical calculations"--Introduction, page 1.

Electrical Model Investigations Using The Horizontal Profiling Technique, Alan H. Kwentus

Masters Theses

"Electrical exploration methods have been used for many years as a means of determining subsurface structures and in the search for mineral deposits. Vertical profiling techniques can be used to determine rather accurately the resistivity and thichness of horizontal or gently dipping beds for cases up to four layers. Mathematical calculations have been made for multiple layers and theoretical curves have been computed and published for four and more layers. The vertical profiling method is not particularly well suited to the problem of locating lateral changes in resistivity produced by such features as ore bodies, sinks and channels. These features …

Critical Load For A Rectangular Plate Simply Supported On Three Edges, Built In On The Fourth Edge, And Compressed On Two Opposite Simply Supported Edges By A Load In The Plane Of The Plate, Bert Louis Smith

Masters Theses

"There are many engineering structures in which thin plates are used extensively, some examples of which can be found in ship and airplane structures, bridges, etc. The problem contained in this thesis is the analysis of a thin rectangular plate simply supported on three edges, built in on the fourth edge, and compressed on two opposite simply supported edges by a load in the plane or the plate. This problem becomes one of stability, and the object of the solution is to find the smallest load that will cause the plate to buckle"--Introduction, page vi.

Some Physical, Chemical, And Thermohydrodynamic Parameters Of Explosive Ammonium Nitrate-Fuel Oil Mixtures, Joseph J. Yancik

Doctoral Dissertations

"The explosive properties of ammonium nitrate-fuel blasting agents were investigated by measuring their detonation velocity and sensitivity. Detonation velocity was measured by a pin oscillograph method with a modified pin technique. Five types of tests were used to evaluate the explosive sensitivity of AN-fuel mixtures under varied environmental conditions. These tests measured the confined and unconfined critical diameter, minimum primer for a three inch diameter iron pipe confined charge, for an unconfined charge at the critical diameter, and minimum primacord primer under special conditions.

Properties of ammonium nitrate-fuel blasting agents were evaluated by considering the effects which each component of …

Comparative Petrographic, Petrochemical And Spectrographic Analyses Of The Precambrian Granitic Rocks Of Southeastern Missouri, Eva B. Kisvarsanyi

Masters Theses

"Petrographic, petrochemical and spectrographic studies were completed on selected Precambrian granitic rock samples from Southeastern Missouri. This investigation contributes to a more detailed knowledge of the Precambrian granitic rocks of this part of the state.

Petrographic analysis of forty-four thin sections of granitic rocks from the St. Francois Mountains area revealed six different granite types. These have been named the Fredericktown, Knoblick, Doerun, Graniteville, Klondike and Silvermine granites. These rocks form a large part of a composite batholith. More than one period of granitic intrusion is represented, but differentiation also contributed to the formation of this diversity of the rocks. …

Methods For Calculating The Minimum Amortization Tonnage And Maximum Present Value For An Ore Body, Garrett M. Sainsbury

Masters Theses

"The discussion is divided into three parts. Part I describes a procedure for determining the mining rate that gives the minimum amortization tonnage required of an ore body, and the amount of that tonnage. The basic idea is that amortization tonnage is equivalent to the estimated capital costs, including interest, divided by the estimated operating profit per ton. Both capital costs and operating profit per ton can be expressed as functions of mining rate by making use of empirical equations. Therefore, amortization tonnage can be expressed as a function of mining rate. The amortization tonnage is calculated for a series …

The Dielectric Strength Of Some Anti-Corrosive Paints, John Harvey Gustafson

Masters Theses

"Metals undergo chemical reaction with nonmetallic elements of their surroundings to produce compounds which are either oxides or salts. These corrosion products, as they are called, may accelerate, impede, or have no influence on the course of further corrosion. It is unfortunate that iron, the metal of greatest use to man, receives very little protection from its corrosion products. There are no easy or inexpensive means of prevention of this corrosion and at best the reactions can only be controlled. One method of control is the use of anti-corrosive paints. Their protection is produced by placing an inert, continuous, and …

Determination Of Vapor-Liquid Equilibrium Data By Continuous Distillation, David William Bunch

Masters Theses

"The procuring of experimental vapor-liquid equilibrium data has been a problem of considerable importance to chemical engineers for a number of years. Modern distillation theory and practice have made accurate vapor-liquid equilibrium data practically a necessity.

Using conventional methods for determining vapor-liquid equilibrium data, an experimenter can obtain only a single vapor-liquid equilibrium composition per trial. Ramalho working with Tiller has developed a new method which makes possible the determination of all values of the vapor and liquid concentrations in a single experiment.

The work done by Ramalho indicated that the necessity for very precise temperature measurements presented a serious …

Oxygen Permeability Of Free Paint Films, Janice I. Kellerman

Masters Theses

"As early as the mid 1800’s investigations were performed on the gas passage through rubber, but it is only comparatively recently that plastic polymeric materials have come into prominence. One interesting aspect of much experimentation begun was that of permeability, and it was soon evident that, in general, polymeric materials have extremely low permeability of gases. This is, in essence, the basis for use of plastics as packaging materials, balloons, and in many other designs and fabrications where it is desirous and/or necessary to exclude air.

There are several variables which must be taken into consideration in the evaluation of …

Water Resources Development -- An Analysis Of Economic Justification Practices Of The Corps Of Engineers, Kerwood W. Barrand

Masters Theses

"Presented herein is a brief analysis of the economic justification practices of the Corps of Engineers as commonly implemented in proposals concerning water resources projects. Where applicable, recommended methods are compared to similar methods advocated for, and accepted by, private engineering firms in similar situations.

The major problem exists in the lack of a profit motive in programs undertaken with the use of public funds. However, a profit can be said to have been realized in public works programs if the total benefits of the programs to all the people exceed the costs of these programs and, further, if the …

An Experimental Investigation Of Receiver System Sensitivity, James Henry Johnson

Masters Theses

"A method of determining the minimum detectable power density incident at the receiving antenna of a UHF receiver is proposed. The minimum detectable power density is the power density required to produce a signal-to-noise ratio of unity in the output of the receiver. The proposed method includes the receiving antenna impedance, the necessary connecting transmission lines, and the receiver impedance.

It is shown that an error in the antenna directivity will produce a significant error in the overall sensitivity of a receiving system. Since the directivity is the most difficult system variable to determine experimentally, it is probably the limiting …

Stress Distribution In Splined Shafts In Torsion By The Membrane Analogy, Charles L. Edwards

Masters Theses

"The purpose of this investigation is to determine torsional shearing stress distribution in various shapes of shafts. The project will include shafts with circular boundaries. No attempt will be made to show the relation between stress and applied torque"--Preface, page iii.

Construction Of A Pulsed Perforated-Plate Extraction Unit, Clarence James Vetter Jr.

Masters Theses

"Liquid-liquid extraction is an important operation in the production and reprocessing of nuclear fuels. In the purification of uranium by liquid-liquid extraction, uranyl nitrate is separated from impurities by extraction into an organic solvent, followed by re-extraction into an aqueous phase. Further processing of the aqueous uranyl nitrate solution is tailored to yield uranium metal or any desired uranium compound.

In order that students in nuclear and chemical engineering may have an understanding of the practical as well as theoretical aspects of liquid-liquid extraction, a model of a uranium purification plant was designed and built in the Unit Operations Laboratory …

The Missouri Miner, December 18, 1959

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, December 11, 1959

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, December 04, 1959

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, November 20, 1959

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, November 13, 1959

The Missouri Miner Newspaper

No abstract provided.

Missouri S&T Magazine, November-December 1959, Miner Alumni Association

Missouri S&T Magazine

No abstract provided.

The Missouri Miner, October 23, 1959

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, October 16, 1959

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, October 09, 1959

The Missouri Miner Newspaper

No abstract provided.

The Missouri Miner, October 02, 1959

The Missouri Miner Newspaper

No abstract provided.

Missouri S&T Magazine, September-October 1959, Miner Alumni Association

Missouri S&T Magazine

No abstract provided.

Missouri S&T Magazine, July-August 1959, Miner Alumni Association

Missouri S&T Magazine

No abstract provided.

The Missouri Miner, May 22, 1959

The Missouri Miner Newspaper

No abstract provided.