Digital Commons Network^™

The Relative Merits Of The Electrolytic Deposit And The Galvanic Nickel Deposit When Used To Produce Enamel Adherence, Marvin Edward Pingel

Bachelors Theses

"The purpose of this paper is to determin sic if nickel deposited electrolytically from a nickel bath at 100ʻF. or less gives the same adherence qualities to enameling steel that nickel deposited galvanically at 160-180ʻF. produces"--Purpose of This Paper, page 1.

Dry Pressing Refractory Insulating Brick, Frank Clarence Steimke

Bachelors Theses

"The expensive process of grinding the insulating brick and the slow production methods of hand forming led to the possibilities of dry pressing the brick. The use of the dry press would increase production, give greater uniformity to the brick and materially reduce grinding if not eliminating it entirely. Since present day combustives were either impractical or else impossible to use, some new material must be found. Three materials presented themselves, napthalene, sulfur, and petroleum coke. The former for its low melting temperature and the latter two for their complete volatility at high temperatures and low if not negligible resiliency. …

Firing Behavior Of Missouri Plastic Fire Clay, William E. Crockett

Bachelors Theses

"There are two districts in Missouri in which plastic fire clay occurs. The oldest and least significant of these deposits is the "Cheltenham", in the St. Louis area. The most prominent area in which plastic fire clay occurs is generally termed the "east central" district. Included in this district are Calloway, Montgomery, Audrain, Warren, Boone, Monroe, Pike and Lincoln Counties. The clay as tested in this report occurs in Boone County, near Columbia. A plastic fire clay does not have as high a P.C.E. (pyrometric cone equivalent) as the ordinary flint and semi-flint clays, but its high plasticity warrants its …

Solubility Of Glass Tank Refractories Using A Small Electrically Heated Furnace, James Vincent Heddell

Bachelors Theses

"This investigation was undertaken to study the refractory blocks used in glass furnaces - their relation with the molten glass. It was decided to employ for this examination a model glass tank, heated by electrical carborundum resistors known as Globars. Experimental glass tanks have been constructed using fuel oil or gas to obtain the required heat to perform melting. These fuels were used mainly to simulate commercial practice and thus to obtain results which could be easily applied to industrial furnaces. The design of a model electric tank is included as part of this investigation"--Purpose of the Investigation, page 4-5.

Test 375: Oliver Row Crop 60 Hc, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

A Study Of A Carbonaceous Gold Ore, James S. Huckaba

Bachelors Theses and Reports, 1928 - 1970

The presence of graphite in the ore of the Missouri-McKee Mine has made its treatment by the methods now used quite unsatisfactory. The study was undertaken to de­velop a new flow sheet which would give a high recovery and yet be economical enough to handle low grade material.

Test 373: John Deere La, Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT: John Deere LA

TEST A: The manufacturer's representative operates the tractor for a minimum of 12 hours using light to heavy drawbar loads in each gear.

This serves as a period for limber up, general observation and adjustments. Adjustments that are permissible include valve tappet clearance, breaker ,point gap, spark plug gaps, clutch and others of a similar nature. No new parts or accessories can be installed without having mention made of it in the report. No data' are recorded during this preliminary run except the time that the engine is operated.

BELT HORSEPOWER TESTS

TEST …

Test 367: Case Model Sc (Distillate), Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Test 371: Mccormick-Deering Model W-9 (Distillate), Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Test 372: International Tractractor Model T-9 (Gasoline) (Wide Tread), Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 376: Massey-Harris Model 81-R, Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Test 374: Caterpiller Model D-6 (Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Test 377: Massey-Harris Model 101-R, Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Test 378: John Deere Ar, Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT: John Deere AR

TEST A: The manufacturer's representative operates the tractor for a minimum of 12 hours using light to heavy drawbar loads in each gear.

This serves as a period for limber up, general observation and adjustments. Adjustments that are permissible include valve tappet clearance, breaker ,point gap, spark plug gaps, clutch and others of a similar nature. No new parts or accessories can be installed without having mention made of it in the report. No data' are recorded during this preliminary run except the time that the engine is operated.

BELT HORSEPOWER TESTS

TEST …

Advertising Brochure: Case Sc, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 370: Mccormick-Deering Model Wd-9 (Diesel), Nebraska Tractor Test Lab

Nebraska Tractor Tests

All tractors tested at the Nebraska Tractor Test Laboratory were certified by their manufacturers as being stock model machines, conforming to specifications filed with the application for test. No special or high-test fuels were used except as recommended by the manufacturer as necessary.

All results within the official tractor test report were actually attained in tests and are without correction or allowances for friction, temperature, altitude, etc. The results were initially accomplished with the tractor in charge of skilled operators employed by the University.

Unless otherwise noted, each tractor was apparently in good condition at the end of the testing …

Test 366: John Deere B, Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT: John Deere B

TEST A: The manufacturer's representative operates the tractor for a minimum of 12 hours using light to heavy drawbar loads in each gear.

This serves as a period for limber up, general observation and adjustments. Adjustments that are permissible include valve tappet clearance, breaker ,point gap, spark plug gaps, clutch and others of a similar nature. No new parts or accessories can be installed without having mention made of it in the report. No data' are recorded during this preliminary run except the time that the engine is operated.

BELT HORSEPOWER TESTS

TEST …

A Study Of Base Exchange And Attendant Disintegration In Carthage Marble, Elmond Lowell Claridge

Masters Theses

"The purpose of this investigation was to study the base exchange reaction occurring in Carthage marble as a possible cause of unusually rapid disintegration of Carthage marble which has been widely observed in various localities and under certain conditions. If this were found to be the principal cause of such disintegration the groundwork would be laid for research on a means of preventing it. According to Mr. R. E. Mayes, president of the Carthage Marble Corporation, forty to fifty percent of the stone quarried by this company is discarded because of large stylolitic veins. This represents a loss of many …

Manufacture Of Salt Cake By The Hargraeves Process, Philip Hall Delano

Masters Theses

"The Hargraeves process of manufacturing salt cake has not lived up to the great expectations that were held for the process at the time of its development...The inventors, Hargreaves and Robinson, do not pretend to have been the first to make salt cake by the action of sulfur dioxide upon common salt in the presence of air and steam; they claim only to have made the process practicable by a large number of patents. Numerous earlier patents for this reaction were taken out by others but none of these former proposals was successful; it was the details of the process …

Electrodeposition Of Copper-Lead Alloys From A 7.2 Per Cent Amine Solution Saturated With Respect To Copper And Lead. Study Of The Production Of Cupric Oxide To Be Used As Solute, Edmund Simon Roszkowski

Masters Theses

"The purpose of this work is to deposit electrolytically a copper-lead alloy from an amine solution for use specifically as a bearing metal. Generally speaking there are four classes of bearing metals: tin base alloys or the babbitts; the cadmium base alloys or the white metals; the silver alloys; and the copper-lead alloys. Additions of other metals may be employed to produce alloys with certain desirable properties"--Introduction, page 1.

The Mineral Association In Manganese Ores, With Particular Reference To The Phosphorus-Bearing Minerals And Their Removal By Leaching Methods, Daniel Chalmers Mclean

Masters Theses

"The United States Bureau of Mines Experimental Station at Rolla has recently been conducting an intensive investigation of the amenability of Arkansas red ores to enrichment by standard ore dressing methods. These Arkansas ores are low grade with the estimated reserves running into several million tons. They can be concentrated to meet all Grade B ferromanganese specifications - with the exception of that of the phosphorus content, but in all cases the phosphorus is so high as to make the ore worthless under present conditions. This condition suggested the problem of trying to discover a method by which the phosphorus …

The Decolorization Of Wood Rosin., Bernard Samuel Pressburg

LSU Historical Dissertations and Theses

No abstract provided.

The Effect Of Varying Surface Tension On The Rate Of Carbon Dioxide Absorption In Water., Sheldon Hutchison Butt 1919-1994

Electronic Theses and Dissertations

No abstract provided.

Sewer System And Treatment Plant For Middlesboro, Kentucky., Robert E. Martin

Electronic Theses and Dissertations

No abstract provided.

Ethylcellulose Reaction In A Varnish : Ii. Ethylcellulose Traffic Paint Formulation., Virgil H. Hulette 1919-1997

Electronic Theses and Dissertations

No abstract provided.

The Use Of Sulfonated Alcohols In Modifying Alkyd Resins., Harold S. Sell 1919-2002

Electronic Theses and Dissertations

No abstract provided.

The System Benzene-Methyl Alcohol : ǂB Densities, Refractive Indices, Boiling Points, And Specific Heats., Samuel Rosenberg 1918-

Electronic Theses and Dissertations

No abstract provided.

Ua12/2/1 College Heights Herald, Vol. 17, No. 6, Wku Student Affairs

WKU Administration Documents

WKU campus newspaper reporting campus, athletic and Bowling Green, Kentucky news. Regular features include:

• Alumni Flashes
• Athletics
• Club - Notes
• Engagements – Weddings
• Faculty Notes
• Hilltopics
• Looking Backward
• Society – Personals
• Sports Spotlight

This issue contains articles:

• College Heights Herald Selected as Best College Paper in State
• William Terry Gives 27 Varsity Letters
• Lane, Chester. Largest Audience in History Attends Christmas Oratorio
• Louisville Alumni Banquet Tonight
• Need Seen for Student Chapels
• Backer, Don. Diddlemen Face First Crucial Test Tonight
• Attention – 31-W Open
• Debating Is to Return to Hill
• Sunday Musicals Are Not Planned
• Dougherty, Russ. Kentucky Intercollegiate Press Association …

Cornell University School Of Civil Engineering Tests On Light Beams Of Cold-Formed Steel, Cornell University School Of Civil Engineering

CCFSS Library (1939 - present)

I SCOPE OF THIS REPORT It has been mentioned repeatedly in previous Reports that the spot welds in the web joining the two parts of the beam tended to pull apart at the supports. It is therefore obvious that, in order to properly design such beams, this fact must be taken into consideration. The present report undertakes to give an analysis of this behavior and to stipulate certain requirements with respect to these welds (strength, spacing) which have to be met in order that such failures may be excluded. The present analysis pertains only to beams made up of two …

Newark Engineering Notes, Volume 4, No. 1, November, 1940, Newark College Of Engineering

Newark Engineering Notes

A journal by the administration, faculty and alumni of the Newark College of Engineering. This issue includes: "The President's Diary" by Allan R. Cullimore "Defense Shelters for Civilians" by Harold N. Cummings "Highways and Defense" by Robert W. Van Houten "Bomb Shelters as Recreation Rooms" by Odd Albert "The Cover Design" "A Precision "Q" Meter" by Alfred Heinz "Some Fundamentals of Geology" by D. C. Frost "Named Adviser for Training" "Economics for Industrial Engineers" by George D. Wilkinson "Graduate Students—Newark College of Engineering" "Promotions and Appointments" "Professionalities" "A. S. M. E. Student Chapter Growth" "Fall Convocation Addressed" by Dr. Jackson …