Digital Commons Network^™

Oxygen Enriched Atmosphere Roasting, Clarence Wells Jr

Bachelors Theses and Reports, 1928 - 1970

The possible benefits of oxygen enriched atmosphere roasting have been known to metallurgists for many years, but only since the development of equipment and processes to produce cheap oxygen in very large amounts has much ser­ious consideration been given this matter.

Foraminifera From Pleistocene Beds Near San Pedro, California, R. F. Mitchell

Bachelors Theses and Reports, 1928 - 1970

The age of rocks found in drill cores, and consequently the depths to possible oil-bearing formations has in many localities been determined by micro-paleontologic studies during the past three decades. Of the different micro-fossils used in this work, foraminifera have been studied most, are the best described, and hence, by far the most helpful.

A Comparative Study Of Some Rock Drill Bits, Paul Louis Terrasson

Masters Theses

"This paper describes a comparative study which was made of the wear and efficiency of different types of rock-drill bits when used under various drilling conditions...The four types of experiments which were carried out had the following purposes: 1. Determine the influence of the size of the bit. 2. Determine the influence of the design of the bit. 3. Determine the influence of the type of hammer. 4. Compare the performances of steel and tungsten carbide bits in limestone and in granite"--Introduction, page 1.

Experiments With Air Entrainment In Cement Concrete, Kentucky Highway Materials Research Laboratory

Kentucky Transportation Center Research Report

In September, 1946, the Research Laboratory prepared and distributed a comprehensive report entitled. "A Summary of Experiments With Air Entrainment in Cement Concrete", which covered field and laboratory experimentation conducted over a period of six years. In February, 1947, specific recommendations based on this report and another dealing with the pressure method of determining air contents resulted in adoption of air entrainment for all concrete pavements and the pressure method as the only accepted method of control.

Among the several projects included in the six years of research were four experimental roads which, of course, are still in service. Although …

The Geology And Ore Deposits Of The Ruby Gulch Mine, Henry J. Roletto, John X. Combo

Bachelors Theses and Reports, 1928 - 1970

The Ruby Gulch Mine, owned and operated by the Ruby Gulch Mining Company, Zortman, Montana, is one of the most important low-grade gold producers in the state. Sit­uated in the Little Rocky Mountains, the mine has had an interesting history since its discovery shortly before the turn of the century.

An Investigation Of A Particular Weldment Failure, Byron Clow

Bachelors Theses and Reports, 1928 - 1970

Two sets of weld-test coupons, supposedly made under identical conditions, were submitted to this institution last year for approval and certification under the A.S.M.E. Welder's Qualification Code. The first set of coupons was unsatisfactory. The second set, made by the same operators one month later, was satisfactory.

The Corrosion Resistance Of Iron-Tin Compacts As Produced By Powder Metallurgy, Robert W. Gambill

Bachelors Theses and Reports, 1928 - 1970

The art of Powder Metallurgy deals with the preparation of metal powders and their utilization. As a more pertinent definition, the following has been suggest­ed: "Powder Metallurgy is the art of producing metal powders and shaped objects from individual, mixed, or alloyed metal powders, with or without the inclusion of non-metallic consti­tuents".

The Problem Of The Tensleep Sandstone, George D. Mccarthy

Bachelors Theses and Reports, 1928 - 1970

Sandstone is probably one of the most important groups of rocks in existence today. The economic importance of so insignifi­cant a thing as a mass of sand grains grows with the true reality of the situation. By increasing our knowledge of grains of sand, or particles of sandstone in all their ram­ifications, it would undoubtedly reflect upon our everyday life by increasing commercial possibilities of an undevel­oped natural resource of Montana.

Isopach Maps And Discussion Of The Ordovician And Devonian Of Montana And Adjacent Areas, Arden F. Blair

Bachelors Theses and Reports, 1928 - 1970

The intensive postwar search for new petroleum horizons has resulted in widespread prospecting in the northern Great Plains. No commercial production has as yet been derived from Ordovician or Devonian rocks in Montana, but the relat­ively few tests that have penetrated to critical depths have disclosed encouraging conditions which merit further consider­ation, especially in Devonian strata.

General Geology And Mines Of Northwestern Montana, Robert L. Sandvig

Bachelors Theses and Reports, 1928 - 1970

The five counties discussed in this paper compose the northernmost and westernmost counties in Montana. On the eastern boundary are Glacier National Park and the Continental Divide; on the southern boundary are Missoula and Powell counties; Idaho lies on the southwestern and western side; and the Canadian border lies along the northern edge. The region is on the Pacific Ocean side of the Rocky Mountains. Three major rivers, the Clark Fork, the Flathead, and the Kootenai drain this area into the Columbia River.

A Preliminary Investigation Of Chromite, Lester C. Brown

Bachelors Theses and Reports, 1928 - 1970

The purpose of this thesis was to study the effects of cryolite and a mixture of cryolite and aluminum oxide on a chromite concentrate with special reference to the ability to break the bond between the ferrous iron and chromic oxide in the chromite.

Glaciation In Montana, Alvin H. Lense

Bachelors Theses and Reports, 1928 - 1970

Glacial deposits are increasingly entering into consideration in engineering projects, soil surveys, ground-water supply, sources for industrial materials, and other economic enterprises. In the field of en­gineering, glacial deposits if present must be consider­ed in connection with reservoir sites, dam or bridge abutments, road building, and other types of construction work.

Some Applications Of Automatic Control, N. H. Ceaglske

Journal of the Minnesota Academy of Science

No abstract provided.

Laboratory Model Shaking Table; An Investigation Of Defects And Suggested Improvements, George C. Horak

Bachelors Theses and Reports, 1928 - 1970

The laboratory model is considered in this thesis. Information gained from this investigation has not been trans­ferred to the larger industrial machines. Some of the factors noted concerning the efficiency of the laboratory shaking table are inherent in this small scale model only.

Study Of The Properties Of Coarse Aggregates, James L. Young Jr.

Kentucky Transportation Center Research Report

Research Project C-22 is an investigation of the geologic aspects of limestone aggregate that might cause failure if used in highway construction. This represents work being carried on at the Highway Materials Research Laboratory in Lexington. The end point of this work is to determine the cause or causes of failure and provide a test that will delete faulty materials from construction work.

In order to evaluate the engineering aspect of the author's work, a study ef the physical tests of these same aggregates is to be made. A correlation between Laboratory Analysis and performance Surveys of these same aggregates …

Heat Sealing Properties Of Ethyl Cellulose Modified Lacquers., William B. Moore 1924-2015

Electronic Theses and Dissertations

No abstract provided.

The Solubility Of Copper In High-Iron And Low-Iron Slags, Charles Burroughs Gill

Masters Theses

"A thesis giving the details of construction of a rotating induction furnace and its use to experimentally determine the amounts of copper absorbed in high-iron and low-iron slags at various temperatures. A rotating induction furnace is advantageous for slag study in that the slag is contained in a molten pure metal cup and does not come in contact with any refractory, which would be attacked by the slag and contaminate it. The molten pure metal cup is formed by melting the pure metal in a refractory crucible and spinning this inside an induction coil. The induction coil supplies heat for …

The Use Of Wetting Agents In Clay Bodies, Nathan Russell Sewell

Masters Theses

"It has been observed that one of the weak points in the present method of commercially preparing stiff mud bodies is the de-airing process, which involves passing them thru a vacuum chamber. Difficulties in maintaining a good vacuum, power costs, and work stoppages due to clogged vacuum chambers, are some of the problems. It was thought that perhaps a very definite contribution could be made in the field of ceramic engineering if some method could be devised for preparing a workable ceramic body of good dry and fired properties without the use of a vacuum chamber. In attacking the problem, …

Ceramic Possibilities Of Some Missouri Clays And Shales, Leonard Nathanael Larson

Masters Theses

"Although many of the shales and clays of Missouri have in the past been, or are presently being used for the manufacture of heavy clay products such as face brick, common brick, sewer pipe, and tile, there is in these post-war years a significant shortage of these products within the state and country. Especially in the northwestern part of Missouri is there a distinct shortage, as only one structural clay plant is known to be operating in that area. The St. Louis and Southeastern Missouri districts are better prepared to meet construction demands, with several structural clay plants operating at …

Ethylcellulose Lacquer Coatings For Polystyrene Plastics., Stuart V. Heil

Electronic Theses and Dissertations

An ethylcellulose lacquer system for both decorative and protective purposes was developed for use on polystyrene plastics. It was found that a one-coat lacquer containing only alcohol solvents produced the most satisfactory finish. Formulations were based on experimental work, conducted to determine the effect of the various lacquer components on the plastic. The results of a study of formulations on a two-coat system are presented.

An Investigation Into The Adaption Of The Induction Furnace For Determining The Equilibrim Diagram Of The System Cu2s-Fes, John R. Cole

Bachelors Theses and Reports, 1928 - 1970

This investigation was started in an effort to find an accurate and efficient method of determining the freezing points of ferrous and cuprous sulphides, mixtures of the two substances, and from this to establish the liquidus line of the equilibrium dia­gram.

A Study Of Mine Scraper Buckets And Their Efficiency, Austin Bond Clayton

Masters Theses

"The use of power drawn scrapers, often called "slushing", for the moving of ore, stops filling, and waste rock has become standard practice in many mining operations. Several types of scrapers have been developed by practical application or by trial and error methods. However, a direct comparison of these scraper types under identical conditions has not been noted in a review of literature on the subject of mechanical loading. Written inquiries to authorities on scraping practice have brought replies that no previous comparisons of scraper types on a modal scale have been attempted. Therefore, the following thesis problem was set …

An Analysis Of Man Power Efficiency In Drilling Procedures In The Tri-State Mining District, Julian Alban Fuller

Masters Theses

"This thesis embodies the results of an investigation, by the time study method, of certain phases of drilling procedures recently brought into practice in the Tri-State mining district. The field work was accomplished during the months of July, and August 1945; the data obtained therefrom and the analysis presented in this dissertation apply to the practice in effect at that time"--Preface, page ii.

Permability And Porosity Of Devonian Dolomites In Northwestern Montana, Jack W. Nordquist

Bachelors Theses and Reports, 1928 - 1970

The purpose of this investigation is to record data per­taining to porosity and permeability derived from physical tests performed on Devonian dolomites occurring in northwestern Montana, and to subsequently summarize the results obtained as an aid in determining the possibility of those dolomites being suitable reservoir rocks for oil and gas accumulation.

Copper Commando - Vol. 3, No. 15, Victory Labor-Management Production Committees Of Butte, Anaconda And Great Falls

All Issues, Copper Commando, World War II

In this issue… World War II, B A & P Railroad, mines, Butte, Montana, American Red Cross, Marcus Daly, Great Northern Railroad, Northern Pacific Railroad, Milwaukee Railroad, Oregon Short Line, tower car, air brakes, School of Mines, New Works tailing pit

The Reaction Of Ethylcellulose With Fatty Acid And Its Application To The Varnish Industry : Ii. Ethylcellulose In Pencil Lacquers., Albert L. Kimmel

Electronic Theses and Dissertations

Ethylcellulose was refluxed with Stearic, Oleic, Linseed Fatty acids, and a neutral Mineral Oil in the presence of a solvent. The products recovered were analyzed to determine if any possible reaction had taken place. Conditions for the reaction were carried out so that the temperatures obtained could be in the near range of varnish cooking, that is between 375 and 500°C. The I solvents used were diethylbenzene, boiling point 180oC and tetralin, boiling point 208oC. In each case approximate stoichiometric proportions of the fatty acids and ethylcellulose were used. These were refluxed to a sensible minimum viscosity of solution. The …

A Study Of The Separation Of Feldspar From Missouri Granite, Vernon Louis Kasten

Masters Theses

"The greatest use of feldspar is as a flux in the Ceramic Industry where it is used in the manufacture of abrasives, floor tile, terra cotta, china, and earthenware of all types. It is also used in the manufacture of glass and enamels, and much is used as grinding medium in powdered form because it is softer than the common abrasive, quartz...Missouri Granites are composed of feldspar, quartz, mica, and other materials, which may or may not occur in all the samples. It is the purpose of this investigation to attempt a separation of the feldspar from these other components …

The Solubility Of Zinc Ethyl Xanthate In Water, Thomas M. Mckenzie

Bachelors Theses and Reports, 1928 - 1970

A determination of the solubility of zinc ethyl xanthate was attempted by measuring the refractive index of a saturated solution of that salt. The small increment in refractive index effected by adding zinc ethyl xanthate to water in saturation quantities rendered measurements difficult and of dubious accuracy.

Hydrogen Overvoltage Of Cadmium Bismuth And Antimony Bismuth Alloys, Edwin W. Stevens

Bachelors Theses and Reports, 1928 - 1970

A method to measure hydrogen overvoltage was devel­oped and checked with metals of known overvoltage. Alloys of bismuth and antimony and of bismuth and cad­mium were prepared and their overvoltages determined.

Copper Commando - Vol. 2, No. 24, Victory Labor-Management Production Committees Of Butte, Anaconda And Great Falls

All Issues, Copper Commando, World War II

In this issue...war heros, Anaconda, "Killer" Kelly, Butte, France, invasion, England, copper, 75 million pounds, tanks, planes, guns, tramming department, smelter materials, Great Falls, safety department