Digital Commons Network^™

A State-Space Approach To Rlct Two-Port Transfer-Function Synthesis, Eddie R. Fowler, Rao Yarlagadda

Electrical and Computer Engineering Faculty Research & Creative Works

This paper presents an interesting procedure for the synthesis of an RLCT two-part transfer function. An RLC ladder, consisting of n reactive elements and two resistors, is derived by using a tridiagonal matrix developed by Navot. The entries in this matrix are expressed in terms of the element values of the ladder network. Two voltage drivers are introduced into the ladder network to obtain a desired short-circuit transfer-admittance function numerator degree, using the classical theorems on transmission zeros. If the numerator degree of the transfer function is i (i < n), then, in general, (i) ladder networks need to be derived. The final network, corresponding to this transfer function, is obtained by paralleling the ladder networks (with transformers if necessary). Extensions to general short-circuit transfer admittance, open-circuit transfer impedance, and voltage transfer functions are briefly discussed. © 1972, IEEE. All rights reserved.

Reply To The Comments Of H. M. Princen [2], Robert A. Medrow, B. T. Chao

Mechanical and Aerospace Engineering Faculty Research & Creative Works

No abstract provided.

Effects Of Cold Working Under Pressure On Subsequent Yield, J. G. Hoeg, Robert L. Davis

Mechanical and Aerospace Engineering Faculty Research & Creative Works

A method utilizing high pressure fluid environments is described whereby a three-dimensional subsequent yield surface was determined for 304 stainless steel cylindrical parent specimens of this material were prestrained in axial compression under fluid pressure and then small sub specimens were sectioned from these parent specimens. Finite element techniques were used to optimize the parent specimen size so that a zone of uniform axial stress woidd result during the prestraining. Longitudinal strains in this zone were monitored during the prestraining and the subspecimens were cut from this region in a manner that did not allow the machining to appreciably affect …

Forming Of 7075-T6 Aluminum In High Pressure Environments, Richard L. Pendleton, Robert L. Davis

Mechanical and Aerospace Engineering Faculty Research & Creative Works

Plates of 7075-T6 Aluminum have been folded along a major axis in pressure environments of atmospheric, 20,000 psi, and 40,000 psi. A finite element computer program is used to determine the stress state in the plates at various loads. Tension and compression tests conducted in pressure environments up to 70,000 psi were used to construct models using effective stress, effective strain, and pressure as parameters to predict the behavior of the material under various stress conditions. A prediction of the occurrence of fracture in the folded plate was possible using the computer results and the pressure dependent model. As better …

A Strain Energy Comparison Of Discrete Modeling For Vibrating Continuous Systems, S. K. Tolani, Richard Dale Rocke

Mechanical and Aerospace Engineering Faculty Research & Creative Works

Lumped parameter models commonly used to describe continuous one-dimensional and Bernoulli-Elder beam vibration problems have been compared on the basis of maximum system, strain energy. The consistent mass matrix approach has been included in the comparison. Standard matrix techniques have been employed to mathematically obtain desired solutions. Closed form solutions and solutions via the models to Ike system strain energy were obtained for all systems in three dynamic states: Free vibrations, constant base acceleration, and half sine base acceleration. Behavior of the strain energy errors, in general, were found to be similar to those of the frequency root errors. © …

Interactions Of Pesticides And Phytoplankton, Pamela H. Philyaw

Retrospective Theses and Dissertations

No abstract provided.

An Investigation Of Methods For Reuse Of Rubber Tires, Charles Edward Armbruster

Retrospective Theses and Dissertations

Methods of reusing/recycling the more than 250 million automobile and truck tires which are worn out each year were investigated. The existing methods of reusing tires account for about 30 percent of the volume of scrap tires generated each year. These methods are, Retreading, Reclaiming (by reducing to ground up rubber and fiber), and Tire Splitting (stamp items out of sidewall and tread areas). Several possibilities for reusing/recycling the unused 70 percent were discovered. These methods are as follows: Destructive Distillation -- a method of recovering chemicals from tires by pyrolitic action. It is anticipated that eventually as much as …

Minimum Weight Design Of Stiffened Cylindrical Shells Using Structural Synthesis, Joseph Eugene Heckelbeck

Retrospective Theses and Dissertations

Several search methods for unconstrained minimization in the minimum weight design of a stiffened cylindrical shell are investigated. The cylindrical shell, under study, is stiffened with bar shaped stiffeners in the longitudinal and circumferential directions, and capable of being loaded both axially and radially with up to ten separate load conditions. For this investigation, it was necessary to alter an unconstrained minimization program for use on the IBM 360 computer by employing double precision techniques. The computer runs obtained on this system are compared with those provided by the prior work of William Morrow and Lucien Schmit. The results show, …

Kinetic Analysis Of The Radiation Polymerization Of Methyl Methacrylate–Kaolin Clay Composites, J. J. Beeson, Kenneth G. Mayhan

Chemical and Biochemical Engineering Faculty Research & Creative Works

In the first of a two‐part series, a kinetic study has been made on the effects of gamma rays (60Co) in air and inert gas on the polymerization of a 50:50 weight‐mixture methyl methacrylate (MMA)–kaolin clay system. The effect of dose rate (7.35–24.9 rads/sec), temperature (25° to 75°C), and total dose on the percentage conversion of monomer to polymer was studied. The rate of formation of polymer at 25°C in the composite system was found to be faster when compared to a bulk MMA system at the same dose rate. This acceleration showed that the clay had a catalytic effect …

Entrance Effects On Capillary Degradation Of Dilute Polystyrene Solutions, J. D. Culter, Kenneth G. Mayhan, Gary Kent Patterson, A. A. Sarmasti, J. (Jacques) L. Zakin

Chemical and Biochemical Engineering Faculty Research & Creative Works

No abstract provided.

Measurement Of Turbulence In An Annular Jet, George Philip

Masters Theses

"An experimental investigation was conducted for an annular jet which consisted of a circular jet and a concentric wake. The annular air jet mixed with quiescent atmospheric air. The jet velocity was kept constant at 137.0 feet per second which corresponds to a Reynolds Number of 73,200. Using the technique of hot-wire anemometry, mean velocities, turbulence intensities and Reynolds stresses were measured in the longitudinal and lateral directions. Two distinct flow regimes, the free stream jet regime and the diffusing jet regime, are observed. In the free stream jet regime, higher turbulence intensity and shear stress occur in the inner …

Cold-Formed Steel Structural Elements Subjected To Time-Dependent Loading, Charles G. Culver

CCFSS Library (1939 - present)

This report summarizes the results obtained from a comprehensive study of the behavior of thin-walled, cold-formed members subjected to impact or shock loading. The influence of local buckling and the concept of effective width in the elastic post-buckling range on the dynamic response of these members is described. Analytical and experimental results for thin compression elements, beams and columns are discussed. Comparisons between the analytical and experimental results are presented. Application of the results obtained from this research to practical situations involving impact or shock loading of cold-formed members is also discussed.

Discussion, A. G. Fabula, Gary Kent Patterson

Chemical and Biochemical Engineering Faculty Research & Creative Works

No abstract provided.

Low Temperature Lattice Parameters And Expansion Coefficients Of Ai2au And Lif Gruneisen Constants Of Lif, Martin E. Straumanis, Jayant S. Shah

Materials Science and Engineering Faculty Research & Creative Works

There is no difference in the thermal expansion behavior of an intermetallic compound (Al2Au) and of an ionic (LiF), except in the magnitude of the expansion coefficients, which for both compounds upon cooling below 40°K approach zero. The lattice parameters of the two compounds mentioned decrease uniformly and without anomalies with lowering the temperature, approaching a constant value below 40°K. The a–T relationship between 40 and 180° is given in form of equations. A pump working on the Joule‐Thomson principle was used for cooling. The GRÜNEISEN parameter, γ, of LiF between 40 and 180°K is a constant, contrary to theoretical …

Irradiation Enhanced Decomposition Of A Nickel-Carbon Solid Solution, B. L. Shriver, Manfred Wuttig

Materials Science and Engineering Faculty Research & Creative Works

This investigation was performed to determine the effects of room temperature neutron irradiation on the distribution of carbon in a nickel-0.3 wt.% carbon alloy. The experiment consisted of comparing the amount of carbon in solid solution and the internal stresses of both unirradiated and irradiated (1013 fn-cm-2 < ΦF < 1018 fn-cm-2) samples following isochronal anneals between 100 and 1200°C by using the magnetic Dis accommodation technique. The results indicate that the amount of carbon remaining in solid solution decreases with increasing neutron dose. At temperatures below 200°C this is due to the trapping of carbon by mobile irradiation-produced defects. Between 200 and 600°C the formation of metastable carbides is enhanced by the presence of irradiation-produced defects. No differences are observed in irradiated and unirradiated samples above 600°C. © 1972.

Polynary Telluride Glasses Containing Silver, H. E. Anthonis, N. J. Kreidl

Materials Science and Engineering Faculty Research & Creative Works

No abstract provided.

Thermal Expansion Behavior Of Silicon At Low Temperatures, Jayant S. Shah, Martin E. Straumanis

Materials Science and Engineering Faculty Research & Creative Works

Lattice parameters, thermal expansion coefficients and Grüneisen parameters of silicon are determined by an X-Ray diffraction method in the temperature range of 180-40 K without the use of liquid gases. Thermal expansion of silicon becomes negative below 120 K which is discussed in terms of its lattice vibrations and crystal structure. © 1972.

Nonstoichiometry In Batio3, G. J. Conger, Harlan U. Anderson

Materials Science and Engineering Faculty Research & Creative Works

No abstract provided.

Dissolution Potentials And Activation Energies Of Insb Single Crystals, Martin E. Straumanis, Lih Da Hu

Materials Science and Engineering Faculty Research & Creative Works

The rest (or corrosion) and dissolution potentials of InSb single crystals in HC1 were determined. There is no potential difference (within error limits) between the inverse {111} faces in pure HC1. A difference of up to 44 mV and more develops as soon as the InSb electrode is anodically dissolved. The potential becomes less noble in the sequence In{111}, {100}, {110}, Sb{111}. The Tafel relationship is observed over three decades of current density. With additions of FeCl3, FeCl2, K3Fe(CN)6, K4Fe(CN)6, H2C4H4O6 to 2N HC1, the anodic potentials of both inverse {111} faces are shifted to more active values; the e'H …

Comment On The Nature Of The Disaccommodation In Hcp Co-C Alloys, J. Keiser, Manfred Wuttig

Materials Science and Engineering Faculty Research & Creative Works

No abstract provided.

Activation Volumes Of Carbon Diffusion In Fcc Iron-Nickel Alloys, J. Keiser, Manfred Wuttig

Materials Science and Engineering Faculty Research & Creative Works

The Dis accommodation technique was used to determine the activation volume of carbon diffusion, ΔV, in six fcc iron-nickel alloys. Measurements were made at temperatures ranging from 68 to 90 °C and pressures up to 6 kbar on samples having a nickel content between 31 and 63 at.%. A maximum activation volume of 3.9 cm3/mole was found at 34 at.% nickel. The compositional dependence of ΔV is satisfactorily reproduced by a magnetic-energy continuum model in which it is assumed that the activation free energy of diffusion is essentially ferromagnetic in origin. © 1972 The American Physical Society.

Pbo Transformation Induced By Water, Charles A. Sorrell

Materials Science and Engineering Faculty Research & Creative Works

No abstract provided.

Proceedings Of The 2nd International Symposium On Lower-Cost Housing Problems, Oktay Ural

International Symposia on Low Cost Housing Problems

To protect and improve the total human environment is a major concern of all the nations of the world. This is well noted in the recent activities of the United Nations. The provision of decent homes for every family of our world is an integral part of the human environment. It is this belief which generated the initial interest for the planning of the International Symposia on Lower-Cost Housing Problems.

The purpose of the Second International Symposium is many sided: to generate concern on the housing problems around the world as they exist today; to gather people who share mutual …

An Application Of Bubble Shape Theory To The Determination Of Air Transfer Through Adsorbed Surface Films, Robert A. Medrow

Mechanical and Aerospace Engineering Faculty Research & Creative Works

No abstract provided.

The Temporal Stability Of Trip Generation Relationships : Technical Paper, Edward J. Kannel, Kenneth W. Heathington

JTRP Technical Reports

No abstract provided.

Computerized Slope Stability Analysis: The Sliding Block : Technical Paper, Aditya Mohan, Carlos Mendez, C. W. Lovell

JTRP Technical Reports

No abstract provided.

Computerized Slope Stability: A Sliding Block Model, Aditya Mohan

JTRP Technical Reports

No abstract provided.

Chronological Listing Of Research Reports, Division Of Research, Kentucky Department Of Highways

Kentucky Transportation Center Research Report

No abstract provided.

Subject Listing Of Research Reports, Division Of Research, Kentucky Department Of Highways

Kentucky Transportation Center Research Report

No abstract provided.

The Plasma Polymerization Of Vinyl Monomers. I. The Design, Construction, And Operation Of An Inductively Coupled Plasma Generator And Preliminary Studies With Nine Monomers, L. F. Thompson, Kenneth G. Mayhan

Chemical and Biochemical Engineering Faculty Research & Creative Works

An apparatus was constructed which would allow vinyl‐type monomers (and others) to polymerize at ambient temperatures in the presence of an inductively coupled RF field. The details of the construction of the system are reported along with preliminary results obtained from nine monomers: styrene, methylvinyldichlorosilane, vinyl acetate, acrylonitrile, vinyl fluoride, 1,1‐difluoroethylene, vinyl chloride, ethylene, and 1,3‐butadiene. Copyright © 1972 John Wiley & Sons, Inc.