Digital Commons Network^™

Dynamic Behavior Of Eccentrically Stiffened Plates, Charles Stuart Ferrell

Doctoral Dissertations

"The dynamic behavior of eccentrically stiffened rectangular plates is studied by the finite element method. The addition of stiffeners to a plate structure is a common method of increasing the rigidity of the structure with a minimum of weight increase. However, this stiffened plate configuration does not easily lend itself to analysis. This study is an approach to finding a rational method by which the dynamic behavior of such a stiffened plate structure may be determined. The governing differential equations for the finite element model are derived and the stiffness and mass matrices for the plate and stiffener elements are …

Optimization Of The Structural Design Of Asphalt Pavements : Technical Paper, Joseph C. Oppenlander, Salim Said Hejal, L. D. Burns

JTRP Technical Reports

No abstract provided.

Water Conservation Handbook, D J. Carder, G. W. Spencer

Natural resources published reports

This handbook is intended as a practical guide in some of the most common aspects of water conservation in the agricultural areas of Western Australia. It deals mainly with water conserved in dams for stock and domestic purposes on the farm.

the farm. The handbook does not attempt to deal with all aspects of handling and using water for agricultural purposes. This is a vast subject which extends into many fields such as engineering, irrigation and land use.

The guide does, however, touch on some important aspects of good management of agricultural land. It should be read in conjunction with …

Effects Of Low Temperature Reactor Radiation Upon Crystalline Sio2, Sami Fouad M El-Iskandarani

Archived Theses and Dissertations

No abstract provided.

Population Trends For Indiana —Counties —Cities —Towns 1960–1970, Jean E. Hittle

Indiana Local Technical Assistance Program (LTAP) Publications

This report presents tabulations and rankings that permit a direct comparison of population growth and population totals for city, town and county units.

1971 Handbook Of Facts And Figures On Indiana County Roads—Including Directory Of County Highway Departments, Jean E. Hittle

Indiana Local Technical Assistance Program (LTAP) Publications

This handbook will assist county road officials in the planning of county road operations. The data and information included in this handbook are either statistical or public information which are already available from the official sources, but which needed to be brought together for convenient distribution and use.

Anodic Dissolution Of Beryllium In Anhydrous Media, William Joseph James, Martin E. Straumanis

Chemistry Faculty Research & Creative Works

No abstract provided.

Report On The School Of Mechanical Engineering National Technical Center Saigon, South Vietnam, Myrne R. Riley

Civil, Architectural and Environmental Engineering Faculty Research & Creative Works

"Training in the discipline of Mechanical Engineering is offered in South Vietnam by the School of Mechanical Engineering, one of four engineering schools and a Merchant Marine School composing the National Technical Center located presently in the Phu Tho region of Saigon, South Vietnam. The school was established in 1956 for the training of engineers, for mechanical and industrial activities. It became part of the National Technical Center, established by Decree No. 213-Gd by the President of the Republic of Vietnam on June 29, 1957 and graduated the first class of 20 in the summer of 1960. The KS Degree, …

An Age Hardening Study Of Magnesium-Thorium-Manganese Alloys, Kuldip Singh Chopra

Doctoral Dissertations

"The age hardening processes in Mg-3.5 wt.% Th-1.0 wt.% Mn and Mg-1.0 wt.% Th-1.0 wt.% Mn alloys have been studied by light and electron microscopy, and by electron and X-ray diffraction. At aging temperatures of 300ºC and below, G.P. zone formation rapidly hardens these alloys followed by the precipitation of disc shaped plates during averaging. During aging above 300ºC, no G.P. zones form and the disc shaped precipitate grows to very large sizes. The combined results of X-ray and electron diffraction indicate that the disc shaped precipitate has a Mg₃Cd (DO₁₉) type structure. The basal plane of the Mg₃Th discs …

Permeability Scaling In A Numerical Coning Model, V. K. Dutta, Marion D. Arnold

Geosciences and Geological and Petroleum Engineering Faculty Research & Creative Works

A method is described for simulating coning into a wellbore using a numerical simulation model. The method allows the wellbore cells to be considerably larger than the actual wellbore. This makes coning studies feasible using an implicit pressure-explicit saturation type model with a reasonable time step. This capability is achieved by scaling the horizontal-vertical permeability ratios to give the proper vertical potential drop.

A Comparative Analysis Of Buyer Patterns In The Asphalt Paver Market, Leonard Llewellyn Decker

Masters Theses

No abstract provided by author.

Activation Volumes Of Carbon Diffusion In F.C.C. Iron-Nickel Alloys, James Raymond Keiser

Doctoral Dissertations

"The disaccommodation technique was used to determine the activation volume of carbon diffusion, ΔV, in six fcc iron-nickel alloys. Measurements were made at temperatures ranging from 68ºC to 90ºC and pressures up to six kilobars on samples having a nickel content between 31 and 63 at. %. A maximum activation volume of 3.9 cm³/mole was found at 34 at. % nickel. The compositional dependence of ΔV is satisfactorily reproduced by a magnetic energy continuum model in which it is assumed that the activation free energy of diffusion is essentially ferromagnetic in origin "--Abstract, page iii.

Evaluation Of A Cation Isotopic Substitution Technique In Conjunction With A High Temperature Gas Pycnometer For Determining The Stoichiometry Of Materials, Michael Clair Graves

Masters Theses

"This study was concerned with the evaluation of a high temperature gas pycnometer, used in conjunction with a cation isotopic substitution technique, for determining the stoichiometry of materials. Three methods were investigated for determining the correction factors for the thermal gradient effects in the gas pycnometer. The correction factors were shown to be dependent on the temperature, the sample volume, and the height of the sample in the sample chamber. Under the conditions of these experiments, the correction factors were shown to be essentially independent of sample grain size and pycnometer atmosphere. The determination of the stoichiometry of cadmium oxide …

Factors Affecting The Ductility And Microstructure Of Ti-6al-6v-2sn Titanium Alloy Weldments, Michael John Ball

Masters Theses

"The purpose of the investigation was to study the effect of material thickness, weld heat input and post weld heat treatment on the tensile properties and microstructure of Ti-6Al-6V-2Sn Titanium, and obtain a practical weld/thermal treatment cycle. The objectives were accomplished by electron beam and gas tungsten arc welding 0.060, 0.125 and 0.250 inch thick material and then heat treating at various temperatures and times. Electron beam and gas tungsten arc welding enabled an approximate 4:1 ratio of heat inputs to be utilized. Resultant welded and heat treated material was tensile tested and metallographically examined. Heat treatments involved both air …

A Computerized Decision Model For Making Quantitative Decisions With Regards To The Department Of Army's Equipment Improvement Recommendations, Lewis Neri

Masters Theses

"The management decision technique, currently in use, of determining priority of EIR evaluation is basically that of "feel and experience" along with the "most pressure" applied from outside the responsible organization. The feasibility of a computerized management decision concept has been studied at the lowest system with the objective of applying this to the next higher systems and finally arriving at an overall system value to obtain system priority. This study develops the technology of operations research and the associated computer techniques, delineates the problem and develops a mathematical model to simulate this management decision technique. Furthermore, it utilizes logical …

An Attempt To Characterize The ‘Turbulence Burst Phenomena’ Using Digital Time Series Analysis, B. Johnson, R. Saylor

Symposia on Turbulence in Liquids

Several attempts to measure "periodicity" in the output signal of hot wires and hot films located in the viscous sublayer have been made in recent years. The usual method is to perform an autocorrelation on the signal and to interpret the strong peaks in the correlation function as indicative of the mean period of the "turbulence bursts" during a particular sampling interval.

The data analyzed for the presence of "turbulent bursts" were from the test of a 60-foot, 8-oared racing shell at the David Taylor Model Basin of the Naval Ship Research and Development Center. The shell was instrumented with …

Compressibility Effects On Transient Gas Pipe Flow, Gerald Francis Mouser

Masters Theses

"Abstract (1) Methods of iterative solution for the partial-differential equations that govern the transient flow of gases in pipelines are obtained by using the method of characteristics and linear finite-difference techniques. Solutions are developed for 1) a constant gas compressibility factor throughout transient conditions, and 2) a variable gas compressibility factor at constant temperature dependent upon pressures encountered during transient flow. Theoretical studies are made to compare results using both approaches for pipelines operating at various constant flowing temperatures. Results show greater differences between the two methods at lower values of flowing temperature due to the more rapidly changing compressibility …

High Temperature Compressive Creep In Mullite, Peter C. Smith

Masters Theses

"Compressive creep measurements were made on two groups of mullites at temperatures between 1455ºC and 1520ºC. The first group consisted of commercially manufactured mullites. The second group was made up of 7 different mullite compositions spanning the alumina-silica solid solution range from 3Al₂O₃ • 2SiO₂ to 2Al₂O₃ • SiO₂ . Thermal activation energies and stress exponents were calculated for the mullites in the second group. Steady state strain rates taken at 1460ºC under loads of 100 and 110 psi varied between 1.3x10⁻⁴ in/in/hr and 15.4x10⁻⁴ in/in/hr. Activation energies were between 109 Kcal/mole and 204 Kcal/mole. Stress exponents calculated from data …

Organic Desorption From Carbon-I. A Critical Look At Desorption Of Unknown Organic Materials From Carbon, S. C. Allen, R. H. Pahl, Kenneth G. Mayhan

Chemical and Biochemical Engineering Faculty Research & Creative Works

No abstract provided.

Structure And Properties Of Silver Borate Glasses, Edward Nashed Boulos

Doctoral Dissertations

"Clear glasses form in the system Ag₂O-B₂O₃ up to about 35 mol.% (65 wt.%) Ag₂O. Infrared absorption, thermal expansion and density data indicated an analogy to the Na₂O-B₂O₃ system. Pentaborate-triborate group pairs appear to be formed upon the addition of Ag₂O to B₂O₃ up to 20 mol.% Ag₂O and diborate groups from 20 to 33 mol.% Ag₂O. This interpretation is supported by the comparison of the infrared absorption spectra of quenched and crystallized glasses. One crystallization product ,Ag₂O.4B₂O₃, has been identified previously. A new compound starts to appear at 28 mol.% Ag₂O. Silver is generally present as a network modifier …

Detection Of Delay Time And Filtering Using Sequency Domain Technique, Earl F. Richards

Doctoral Dissertations

"A procedure is presented by which it is possible to detect a known signal of unknown delay in a noisy medium contaminated by noise. From the results the characteristics of a sequency digital filter which would be required to remove the noise contamination is indicated. The Walsh functions are discussed and the sequency domain, which is analogous to the continuous frequency domain, is used in the spectral analysis of signals. The binary nature of the Walsh functions and their ease of generation makes processing of signals easier than the Fourier analysis approach. The applications of fast forward and inverse Walsh …

Column Research Council: Proceedings 1971, Column Research Council

CCFSS Library (1939 - present)

One of the purposes of the Council is to maintain a forum where problems related to the design and behavior of columns and other compression elements in metal structures can be presented for evaluation and discussion. The Annual Technical Session provides opportunity to carry out this function. The 1971 Annual Technical Session was held on May 25 and 26 at the Pick-Rosseve1t Hotel in Pittsburgh, Pennsylvania. Seventy-seven persons attended the Session and twenty-two papers were delivered. A panel discussion on "Fire Effects on Structural Stability" was held in the evening of May 25. In conjunction with the Technical Session, an …

Electrical Engineering Education In An Industrial Laboratory, J. Derald Morgan

Electrical and Computer Engineering Faculty Research & Creative Works

This paper describes a unique electrical engineering laboratory course. This laboratory is an example of industry-uni-versity cooperation in engineering education. The organization and operation of the course is outlined and explained. The educational benefits derived from such cooperation between industry and the university are briefly detailed. These benefits are extended to the students, the university, the faculty, and the participating industry. This paper provides the framework and challenge to industry from which other laboratory experiences can be conceived and developed. Copyright © 1971 by The Institute of Electrical and Electronics Engineers, Inc.

Deriving Dc Machine Torque By The Principle Of Virtual Work, George Mcpherson

Electrical and Computer Engineering Faculty Research & Creative Works

The purpose of this paper is to fill a gap which exists in the "textbook" theory of dc machines. The paper shows that the usual expression for dc machine torque can be obtained from the direct application of the principle of virtual work to the machine, making the traditional assumptions. The method provides additional benefits in that it demonstrates the reluctance torque which results from the saliency of the field structure and shows that compensating windings have no effect on the torque under the assumed linear conditions. Copyright © 1971 by The Institute of Electrical and Electronics Engineers, Inc.

Industry Participation In Electrical Engineering Education-Extra High Voltage Laboratory, J. Derald Morgan

Electrical and Computer Engineering Faculty Research & Creative Works

A unique electrical engineering laboratory course is described. This laboratory is an example of how industry can cooperate with universities in engineering education. The organization and operation of the course as well as the course material is outlined and explained, including the ways in which the industry participates in the operation of the laboratory. The educational benefits derived from such a cooperation between industry and the university are briefly detailed. These benefits are extended to the student, the University, the faculty, and the participating industry. This article provides the framework on which other laboratory experiences could be conceived and developed …

A Generalized Investigation Of Potentially Poor Soil Support By Regional Geomorphic Units Within The Adjacent 48 States : Preprint, Matthew W. Witczak, C. W. Lovell

JTRP Technical Reports

No abstract provided.

A Generalized Investigation Of Potential Aggregate Availability By Regional Geomorphic Units Within The Adjacent 48 States, Matthew W. Witczak, C. W. Lovell

JTRP Technical Reports

No abstract provided.

Criteria For No-Passing Zones : Technical Paper, Valkenburg Gerald Van, Harold L. Michael

JTRP Technical Reports

No abstract provided.

Techniques In Slipform Paving And Continuously Reinforced Concrete Pavement Construction, Olubayo Timothy Olateju

JTRP Technical Reports

No abstract provided.

Travel Time And Accident Benefits Due To Reconstruction Of U.S. 52 Bypass At Lafayette, Indiana : Progress Report, Alexander Edward Mcneil

JTRP Technical Reports

No abstract provided.