Digital Commons Network^™

Development, Application And Operating Results Of The Center Peripheral Discharge Rod Mill, David Porter Hale

Professional Degree Theses

"The use of a rod mill for producing manufactured sand is not a recent application. A Marcy Open End Rod Mill has been operating at the plant of the Sun Sand Company, Thayer, West Virginia, since 1925. In early 1940 an 8' x 12' rod mill of the open end type was installed at Shasta. Dam, near Redding, California for sand production. In 1942 work began on Fontana Dam, a Tennessee Valley Authority Project on the Little Tennessee River. The flow sheet included two 9' x 12' high discharge rod mills driven by a single 800 H.P. motor. All of …

Experimental Studies Of The Effect Of Moisture On Strength Of Mine Roof-Shales, Rolf W. Roley

Professional Degree Theses

"The mining and production of coal by underground mining operations has long been recognized as one of this nation's most hazardous industries. Tabulated data from the State of Illinois, for example, reveal that in that State between 1882 and 1945 there have been 7,789 men killed in coal mining accidents of one form or another. Further inspection of the data indicates that 3,711 of these men were killed underground by falls of roof or rock….

As previously stated, this experiment was designed to determine whether or not any appreciable change in strength as measured by Transverse Breakage would result from …

A High-Temperature X-Ray Diffraction Camera And Its Application To Copper And Titanium, Robert R. Penman

Masters Theses

"The purpose of this research was threefold, and consists of the following sections: 1. Effective use of a high temperature x-ray camera, capable of reaching temperatures of 1000 ºC. 2. Investigation of the thermal dilation of certain cubic metals. 3. Accurate determination of the lattice constant (aₒ) of Beta Titanium at 900 ºC "--Introduction, page 1.

Analytical Investigation Of Bending Effects On The Stability Of A Tube Subjected To External Pressure, Charles Young

Masters Theses

"The behavior of thin and moderately thick-walled tubes under various types of loadings has been a major problem of several leading industries for many years. Predominant among these, and the one for which this thesis was primarily undertaken, is the oil industry. The problem attacked in this thesis, however, is not limited to that industry alone, having ample application in industries that are sub-marine in nature, or any industry in which the application of external pressures on equipment is likely to be responsible for buckling failures...In this thesis, the problem of finding the effect of bending on the collapsing pressure …

A Mineral Dressing And Economic Study Of A Complex Arsenical Ore, Luigi D. Piana

Bachelors Theses and Reports, 1928 - 1970

The factors that influence the choice of a method for treat­ment of an ore comprise the technical and economic limitations and advantages, derived in detail and balanced according to the exigencies of the particular situation.

Caustic Leaching Of Montana Chromite, Chester Freshour

Bachelors Theses and Reports, 1928 - 1970

Chromite is the most important ore used for the production of chromium and chromium alloys. At present, the domestic production is insignificant as compared with the amount of chromite consumed in the United States.

An Investigation Into The Precipitation Of Copper From Mine Water, Using Sulfur Dioxide To Reduce The Ferric Ion Content, David S. Gleason

Bachelors Theses and Reports, 1928 - 1970

The experiments which were preformed showed that sulfur dioxide would reduce the ferric ion content of the mine waters to a very low figure. The reduction in the ferric ion content would improve the efficiency of the precipitation process, and also increase the recovery of copper.

Application Of The Electric Furnace To The Melting Of Cathode Copper At The Tacoma Smelter, Alvin H. Nelson

Bachelors Theses and Reports, 1928 - 1970

In the field of copper metallurgy, the major chang­es effected in the original metallurgical scheme have been based largely upon the lowering in grade of copper ores, and the more particular demands of the fabricators of the metal. The former trend fostered the development of mineral beneficiation, which in turn caused the con­version from blast furnace to reverberatory furnace smelting.

The Casting Of Anodes For The Series System Of Electrolytic Copper Refining, Robert R. Kupfer

Bachelors Theses and Reports, 1928 - 1970

The electrolytic refining process, while usually considered an auxiliary process used in conjunction with pyrometallurgical extraction, deserves a special niche in the complex metallurgy of copper. The development of electrolytic copper refining, for example, is largely responsible for the prominence of the electrical industry. Conversely, it could be stated that the electrical industry played an important part in the development of the copper industry.

Application Of Thermistors To Temperature Measurements In Experimental Investigations, J. F. Herrick, Earl A. Glarborg

Journal of the Minnesota Academy of Science

No abstract provided.

A Study Of The Power Consumption Of Mine Scrapers, Stanley Francis Johnsen

Masters Theses

"Since scrapers were first employed in underground mining work, numerous changes in scraper design have transpired until now there are several common types of scrapers in use in mines over the world. The proved models of scrapers have been developed over a period of more than fifty years. Although specific scrapers have been tested to determine the amount of power consumed, no literature could be found concerning the relative power consumption of the different types of scrapers when operated under identical conditions. Purpose of Problem - The purpose of this study is to determine the relative efficiency of different types …

Aerodynamic Research For An Improved Rotor Control System On Helicopters, Delmar Wallace Breuer

Masters Theses

"Since the author has always been interested in Aeronautical Engineering, and in particular, rotary-winged-aircraft, the problem of research for aerodynamic improvement of rotary-wing control systems was chosen. This problem was suggested by the Army Aircorps Officials of Wright-Patterson Field of Dayton, Ohio as being a valuable and practical problem for the government. It is also valuable and practical for the author since it follows his general course of undergraduate study and since it fits closely into the field for which he is preparing himself...The requirement with which the author is most concerned is the design system for the producing of …

The Barite Industry In The United States, James Byron Chaney

Masters Theses

"Within the past few years, barite has become one of the most important non-metallic substance mined in the United States, as expressed by the large increase in production since 1943. The purpose of this treatise is to combine in a single volume important information concerning the geographical distribution, geology, mining methods, milling or beneficiation methods, production and utilization of barite in the United States. A large number of references has been used in preparing this treatment. The information has, as far as possible, been brought up-to-date. It is thought by the writer that the paper will present to the reader …

Design Of A Wind Tunnel For The Missouri School Of Mines And Metallurgy, William E. Speece

Masters Theses

"For some time there has been a need for a wind tunnel at the School of Mines for experimental work in the Civil and Mechanical Engineering Departments. With the expanding program and the possibility of establishing an Aeronautical Engineering School here, the need will be even more pronounced. So the problem will be of definite practical value. It was the original idea to design a small tunnel, build the tunnel, and to run a series of smoke tests on various structural models. However, after discussing the possibility of such a problem with school authorities, it was decided that if a …

A Preliminary Investigation Of The Titanium-Copper Equilibrium System, August Robert Savu

Masters Theses

"The element titanium has a high degree of chemical activity at room temperature when in a finely divided condition. In the massive state this activity is only exhibited at high temperatures. The powdered metal is highly pyrophoric. Titanium forms quite stable sulphides and carbides, although these are subject to oxidation at high temperatures. It also form nitrides. Titanium being a transitional element forms hydrides with hydrogen which are stable at ordinary temperatures, but which dissociate at red heat liberating the hydrogen and leaving the metallic titanium in a very active state. Alloys are formed with such metals as aluminum, manganese, …

Analytical Investigation Of Thin And Moderately Thick-Walled Tubing Under Peripheral And Biaxial Loading, Frank Joseph Cizek

Masters Theses

"The problem then, resolves itself into a study of the behavior of thin-walled and moderately thick-walled cylinders under the effects of an external fluid pressure acting alone, or the effects of an external fluid pressure acting simultaneously with an axial loading. In this thesis a theoretical or analytical approach will be used. Some application and reference will be made to oil-well casings in particular, but the solutions will not be restricted to oil-well casing alone. it must be recognized that the tubing problem involves the problem of unstability before the proportional limit of the metal is exceeded and a similar …

A Correlation Of Formulas For The Flow Of Fluids In Pipes, John Gorman Duba

Masters Theses

"At present there exist two quite distinct fields in fluid flow in pipes, the one in water supply and the other in the petroleum industry. It is the purpose of this paper to discuss the various pipeline flow formulas as used in both fields and to correlate the exponential type formula which is much used in practice with the Nikuradse curves obtained in the laboratory"--A Brief Historical Review, page 5.

The Fort Union Formation Of Montana And Adjacent Areas, Charles Christman

Bachelors Theses and Reports, 1928 - 1970

The Fort Union formation is one of the most import­ant and best known geologic formations of the northern Great Plains, and is found lying almost horizontal at the surface over large areas in this region.

A Discussion Of The Geology And An Isopach Map Of The Pennsylvanian System In Wyoming And Adjacent Areas, B. R. Alto

Bachelors Theses and Reports, 1928 - 1970

Pennsylvanian strata in Wyoming and adjacent areas have been the subject of much work and discussion. Most of the work has been due to the economic importance of the system as an oil producer in this region. Oil production from strata of Pennsylvanian age is rather recent history; and therefore, much of the available information is local­ized and incomplete.

An Isopach Map And A Discussion Of The Permian In Wyoming And Adjacent Areas, Willard Leskela

Bachelors Theses and Reports, 1928 - 1970

The accelerated post-war demand for petroleum products with resultant high prices and dwindling reserves has spurred producers to an extensive search for new fields and for ad­ditional production in known fields. Exploration and discov­ery is dependent on the collection and correlation of vast amounts of data both in the field and that found in liter­ature.

Roasting And Leaching Of Montana Chromite, Jerry D. Murphy

Bachelors Theses and Reports, 1928 - 1970

The United States, although the leading consumer of chromite, depends almost entirely on imports for its supply. Domestic production of chromite is limited, because high-grade imported ore is plentiful and inexpensive in normal times. There are several large deposits of chromite in the United States, representing millions of tons of low grade ore. These deposits form a strategic reserve that must be used in time of national emergency.

Sulfatizing Roasting Of A Copper Sulfide Ore, Walter D. Finnegan

Bachelors Theses and Reports, 1928 - 1970

At present copper sulfide ores are recovered by pyrometallurgical processes. While the recovery of cop­per from sulfide ores by hydrometallurgical means has long been considered attractive, the impurities, low re­covery and mechanical difficulties have kept this process from becoming commercial.

A Study Of The Diffusion Of Electroplated Coatings In The Solid State., Michael R. Writt

Bachelors Theses and Reports, 1928 - 1970

The term diffusion means an equalization or homogenization of diverse materials. Specifically ap­plied to metals, diffusion is the interchange of atoms. It is, in effect, an invasion of one crystal lattice by the atoms of one or more other crystal lattices. Therefore, the study of diffusion must involve the geometry and physics of crystal lattices as well as their energies.

The Drainage Problem In The Draper Area, Utah, Stanley H. Van Orman

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

As a rule, in the practice of irrigation, more water is delivered to a project than is used by the plants, evaporated, or removed by natural drainage. It is now generally accepted that, in the West, irrigation and drainage are necessary complementary practices. With comparatively good irrigation practice the efficiency is about 34 percent; that is, approximately one-third or the water is actually used by the crops. With rather poor irrigation practice the efficiency may drop as low as 12 percent.

A Study Of The Physical Properties Of Low Tin Solders, Cornelius P. Dwyer

Bachelors Theses and Reports, 1928 - 1970

In 1947, out of the 100,000 long tons of tin con­sumed in the United States, 25,000 tons went into solder. Tin plate took 39,000 tons while babbit, bronze and coll­apsible tubes accounted for approximately 17,000 tons. Solder ranked second to tin plate and required more than the next three major uses combined.

The Effect Of Manganese And Magnesium On The Hardening Of Copper-Aluminum Alloys, Robert M. Hansen

Bachelors Theses and Reports, 1928 - 1970

During recent years, duralumin and all aluminum alloys have been made the object of much discussion regarding their hardening mechanism. The commercial success of nearly all of the alloys of aluminum and mag­nesium is dependent on their ability to age or precipitation harden.

Oxygen Enriched Atmosphere Roasting, Clarence Wells Jr

Bachelors Theses and Reports, 1928 - 1970

The possible benefits of oxygen enriched atmosphere roasting have been known to metallurgists for many years, but only since the development of equipment and processes to produce cheap oxygen in very large amounts has much ser­ious consideration been given this matter.

Foraminifera From Pleistocene Beds Near San Pedro, California, R. F. Mitchell

Bachelors Theses and Reports, 1928 - 1970

The age of rocks found in drill cores, and consequently the depths to possible oil-bearing formations has in many localities been determined by micro-paleontologic studies during the past three decades. Of the different micro-fossils used in this work, foraminifera have been studied most, are the best described, and hence, by far the most helpful.

A Comparative Study Of Some Rock Drill Bits, Paul Louis Terrasson

Masters Theses

"This paper describes a comparative study which was made of the wear and efficiency of different types of rock-drill bits when used under various drilling conditions...The four types of experiments which were carried out had the following purposes: 1. Determine the influence of the size of the bit. 2. Determine the influence of the design of the bit. 3. Determine the influence of the type of hammer. 4. Compare the performances of steel and tungsten carbide bits in limestone and in granite"--Introduction, page 1.

Experiments With Air Entrainment In Cement Concrete, Kentucky Highway Materials Research Laboratory

Kentucky Transportation Center Research Report

In September, 1946, the Research Laboratory prepared and distributed a comprehensive report entitled. "A Summary of Experiments With Air Entrainment in Cement Concrete", which covered field and laboratory experimentation conducted over a period of six years. In February, 1947, specific recommendations based on this report and another dealing with the pressure method of determining air contents resulted in adoption of air entrainment for all concrete pavements and the pressure method as the only accepted method of control.

Among the several projects included in the six years of research were four experimental roads which, of course, are still in service. Although …