Digital Commons Network^™

"Design And Construction Practices As Viewed By A Maintenance Engineer", R. L. Parker

Kentucky's Annual Forum on Transportation

No abstract provided.

Contribution To Public Safety By Highway Maintenance And Traffic Control Operations, H. H. Sandusky

Kentucky's Annual Forum on Transportation

No abstract provided.

Employee Safety In The Use Of Men And Equipment On Highway Maintenance, Jack Carson

Kentucky's Annual Forum on Transportation

No abstract provided.

Planning Future County Road Systems, James T. Sabel

Kentucky's Annual Forum on Transportation

No abstract provided.

Soils, Their Classification, And Some Of Their Relations To Highway Construction, O. F. Threlkeld

Kentucky's Annual Forum on Transportation

No abstract provided.

Comments On Report Given By C. T. Warwick On The Following Subject: "My Idea Of An Ideal Organization As It Relates To Maintenance, Equipment, Traffic And Safety.", Raymond Pile

Kentucky's Annual Forum on Transportation

No abstract provided.

A Test Road For The Evaluation Of Sandstone As An Aggregate In Plant-Mix Bituminous Pavements, Ellis G. Williams

Kentucky Transportation Center Research Report

In eastern Kentucky, deep deposits of sandstones and shales overlie the vast deposits of limestones that prevail throughout the central part of the state. Whereas locally available limestones of high quality comprise the major sources of crushed stone or aggregate for highway paving in the central part of the state, some areas of eastern Kentucky are so far removed from sources of these and other high-type aggregates that transportation of materials becomes a major cost item. It is a matter of record that these costs frequently approach or even exceed the cost of the material at the source, Since aggregate …

An Early Tertiary Stream Channel Between Fish And Pipestone Creeks, Ten Miles West Of Whitehall, Montana, Henry D. Olson

Bachelors Theses and Reports, 1928 - 1970

Driving between Butte, and Whitehall, Montana, on highway U.S. 10S, one observes an interesting phenomenon in the lower end of Little Pipestone Creek canyon. One side and the bottom of the canyon is cut inthe hard igneous rocks of the Boulder Batholith, and the other side of the canyon is made of unconsoli­dated sand, gravel, and cobbles.

A Bank Gravel Base Containing Calcium Chloride [Report No. 1], William B. Drake

Kentucky Transportation Center Research Report

This report is concerned with a bank gravel base construction project, and particularly with that part of the base containing calcium chloride as a stabilizing agent. The project was carried out on a relocation of U.S. 62, between Kuttawa in Lyon County and Kentucky Dam on the Tennessee River. A part of the project, as shown on the general location map in Fig. 1, was in Livingston County between the Cumberland and Tennessee Rivers.

Test 472: John Deere 60, Nebraska Tractor Test Lab

Nebraska Tractor Tests

EXPLANATION OF TEST REPORT: John Deere 60

TEST A: The manufacturer's representative operates the tractor for a minimum of 12 hours using light to heavy drawbar loads in each gear.

This serves as a period for limber up, general observation and adjustments. Adjustments that are permissible include valve tappet clearance, breaker ,point gap, spark plug gaps, clutch and others of a similar nature. No new parts or accessories can be installed without having mention made of it in the report. No data' are recorded during this preliminary run except the time that the engine is operated.

BELT HORSEPOWER TESTS

TEST …

Comparative Refining Methods Of A Cane Sugar Solution., Pramod Lal Sarma

LSU Historical Dissertations and Theses

No abstract provided.

Porosity-Permeability Relationships Of Unconsolidated Sands, Robert Marchel Ponder

Masters Theses

"Unconsolidated sand reservoirs containing oil and gas present difficult problems to the petroleum engineer. Among these problems is that of the determination of the reservoir porosity to facilitate oil and gas reserve and evaluation calculations.

This problem is especially difficult because, to the author's knowledge, no method has been devised to obtain a core sample of the unconsolidated sand that retains the same porosity and permeability characteristics in the laboratory as it had underground. As a result, the petroleum engineer must rely upon empirical methods of calculating the reservoir porosity when the sand is not consolidated.

Many investigators have attempted …

The Effect Of Grain Size On Shearing Strength Of Sand, Keyhan Samimi

Masters Theses

"The object of this study is to determine experimentally the effect of definite grain size on the shearing characteristics of sandy soils. As it will be discussed in detail under the article - The Mechanics of Shear, the shearing characteristics of sandy soils depends on many factors such as grain size and shape, soil structure and relative density, the water content of soil. An attempt is made throughout the entire investigation to determine the effect of definite grain size on the shearing value and the angle of internal friction under the dry and saturated conditions. Furthermore, the results of shear …

Temperature Kinetics Of Nitrogen Dioxide-Ammonia Reactions, George Dillender Jr.

Masters Theses

"The purpose of this project was to study the rapid rate of reaction of nitrogen dioxide and ammonia and if possible to determine the mechanism of the reaction.

The author became interested in this project through his interest in rockets, jets, and the types of fuel that are used to propel them.

The prospect of using nitrogen dioxide and ammonia as a possible fuel was the basic reason for the selection of this project.

Very little has been done in the study of the reaction of nitrogen dioxide and ammonia, although the reaction seems to be a simple one.

How …

Test 470: Oliver 77 Lpg, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

Test 479: Harris Power Horse 53, Nebraska Tractor Test Lab

Nebraska Tractor Tests

No abstract provided.

An Investigation As To The Uses Of The Topographic Map And Improvements Desired By The General Public, George O. Boeckman

Masters Theses

"The demand for topographic maps from hunters, fishermen, vacationers, professional engineers etc, has been increasing with each passing year. In 1940 people bought some 700,000 copies of topographic maps. In 1946 sales had jumped to well over 2,000,000 copies. Civilian use of these maps by veterans has contributed substantially to the tremendous expansion of demand for maps since World War II. In recent years, the quality of topographic maps has been greatly improved by refinements in methods and by the use of aerial photography in map compilation. This advancement, and an ever-increasing demand from engineers, geologists, and many others for …

Hydrology Of Small Drainage Areas, James Kinchen Searcy

Masters Theses

"Realizing the need for data on small drainage areas the Missouri Highway Commission in 1947 began a cooperative project with the Water Resources Division of the United States Geological Survey which includes the establishment of small area gaging stations and recording rain gages.

The purpose of this investigation is to study some of the data collected in the few years of operation of these small area stations with the aim of testing some of the hydrologic tools useful in the study of larger drainage basins to determine their applicability on small drainage basins. The relationship between the runoff of large …

X-Ray Studies Of Zirconium Cyanonitride, John T. Ballass

Masters Theses

"The purpose of this research was to study, by means of x-ray and metallographic analysis, a material reported to be zirconium cyanonitride.

The x-ray analysis had a three fold purpose, the determination of the symmetry of the constituents, the number of phases present, and the crystal structure type. Metallography was used to confirm some of the results obtained by x-ray analysis establishing certain definite phase relationships present in the microstructure.

The sample investigated contained three principal elements namely zirconium, nitrogen, and carbon. On the basis of constitution this work is a contribution toward the development of the three component equilibrum …

Experimental Techniques In The Kinetic Study Of Rapid Gas Phase Reactions, William Dean Burch

Masters Theses

“In recent years chemical kinetics has assumed a prominent role in Chemical Engineering studies. While a considerable amount of data is available in the general field, very little is available for rapid gas phase reactions, i. e., reactions that are completed in from a few milliseconds up to a few seconds. Recently techniques have been developed for the measurement of the rate of such reactions.

With the advent of jet aircraft, the study of very rapid oxidation reactions becomes imperative. One such reaction that presents itself in this category is the oxidation of anhydrous ammonia in the vapor state by …

Direct Reduction Of Zinc Sulfide Under Vacuum, Merritt E. Langston

Masters Theses

"The present work is a continuation of the previous investigations of Gross and Warrington and Liu in which the effect of various reducing agents on the vacuum reduction of zinc sulfide was studied. The author became interested in this topic while reading the papers by these investigators in which they recommended that further work be performed in an attempt to prevent zinc sulfide from distilling over during reduction, thereby contaminating the zinc condensate. The original plan was to perform a few runs for the purpose of duplicating the results that were reported by Liu, and from this point carry on …

Activation Energy For Recrystallization In Rolled Silver, Krishan Kumar Tangri

Masters Theses

"In several metals the process of recrystallization is accompanied by a change in the orientation of the recrystallized material with respect to the cold rolled material. If the change is sufficiently large, the changing position of the crystals can be determined by measuring the change in the intensity of the characteristic Bragg-reflection with a Geiger counter x-ray spectrometer. Recent determinations of the activation energies of copper and a 50/50 iron-nickel alloy have been made by using this x-ray technique. Both of these metals show a decided shift in the orientation as the material is recrystallized.

Silver was examined to find …

The Application And Utilization Of Mining Models For Instruction And Display, William M. Shepard

Masters Theses

"The subject of the utilization of mine models for instruction and display at institutions offering courses in mining engineering has not been widely discussed in the literature. The value of models as visual aids in teaching has long been recognized, and they have been extensively employed by some institutions and by some instructors. However, the writer believes that a wider range of types of models are suitable for instruction purposes than have been employed in the past, and that mining models, properly arranged and adequately labelled, may be used in displays to give both the layman and the beginning student …

A Study Of Size Of Diamonds In Diamond Drilling, Robert J. M. Miller

Masters Theses

" ''A Study of Size of Diamonds in Diamond Drilling' is the research problem which will be discussed in this treatise.

The author's interest in the effect of size of diamonds was created by Mr. R. D. Longyear of the E. J. Longyear Company of Minneapolis, Minnesota. Mr. Longyear, when asked for suggestions for a research problem concerning diamond drilling suggested, among other things, that there was a need for further work on the factor of size of stones. After extensive reading and reviewing, the author learned that many investigators had recognized changes in results attributable to changes in size …

An Economic Study Of The "C" Factor, David Hunter Robinson

Masters Theses

"After due consideration of the facts and hypothetical conditions enumerated herein, it was decided that this work would be devoted to developing a means of determining the most economical “C” factor to be used; one that will be consistent with ease of operating the plotting machine, the required accuracy of the finished compilation and economy. In other words, the highest value of the "C" factor that will produce results within the accuracy requirements under normal operating procedures.

As a secondary project, it was decided to plot a curve using points determined by analyzing a series of spot readings made at …

An Investigation Of End-Anchorage And Performance Of Sr-4 Strain Gages On A Prestressed Concrete Beam, Howard W. Nunez Jr.

Masters Theses

"In recent years there has been brought to the attention of engineers and architects a new medium of construction---prestressed concrete. Reinforced concrete has long been recognized as a satisfactory material for use in the construction of buildings, bridges, highways, tanks and other structures. However, most concrete designers will concede that this material has many drawbacks. For instance, in a simple beam of rectangular cross-section, roughly only one half or the concrete is relied on to resist compressive forces. The tensile strength of the concrete is considered to be zero, and steel bars or rods must be inserted to carry the …

Design Of A Galvanometer To Be Placed Within A Tubular Antenna For The Purpose Of Measuring Antenna Current Distribution, Ferdinand Henry Mullersman

Masters Theses

"The object of this paper is to design such a galvanometer for application to cylindrical UHF antennas and to discuss the procedure involving its use. The galvanometer will then be placed inside a completely isolated parasitic antenna and the distribution of current along the antenna will be measured"--Introduction, page 5.

An Investigation Of The Deformation Textures Of Titanium, Dean Nesbit Williams

Doctoral Dissertations

"With the increase in production of titanium in recent years has come a great interest in the mechanical properties and in the possible uses of this metal. Due to the affinity of titanium for oxygen, nitrogen, carbon, and hydrogen, and the market effect of these elements on the mechanical properties, much of the work previously reported is unreliable. As purer commercial grades of titanium and high purity iodide titanium have become available for examination, research has been undertaken to correct and expand the knowledge of the properties of titanium. Although the uses of titanium are limited at the present time, …

A Study Of The Dissolution Of Titanium In Acids With Ammonium Fluoride Added, Charles Burroughs Gill

Doctoral Dissertations

"Titanium can no longer be considered a rare metal, even though the modern era of its production came into being only a few years ago. The first discovery of titanium was in 1791 by an English clergyman, the Reverend William Gregor, and the name titanium became universally adopted when so called by a German mineralogist, Martin Klaproth, who rediscovered titanium three years later. Not until 1887 was the relatively pure, 75 percent, metal prepared by L. F. Nilson and O. Pettersson, whose experiments were repeated in 1910 by M. A. Hunter. Hunter is given credit for producing the first metallic …

A Study Of The Effect Of Jointing On The Blasting Of Granite, Graniteville, Missouri, Avery Ala Drake

Masters Theses

"Purpose of investigation: The purpose of this investigation is to attempt to determine the influence that joints exert upon the blasting of granite and if joints are induced by blasting. The problem grew out of an explosive evaluation project that was conducted by the Mining Department, Missouri School of Mines. In late May 1950, the project was moved into the granite area near Graniteville, Missouri. It became apparent upon study of this area that the jointing would have certain effects upon the results obtained. Dr. J. D. Forrester, Chairman, Department of Mining Engineering, Missouri School of Mines, Rolla, Missouri, suggested …