Digital Commons Network^™

Comparison Of Pulse And Fm Radar Altimeters Based On Terrain Return Theory, David L. Quinlan

Electrical and Computer Engineering ETDs

In this paper a comparison of pulse of fm radar altimeters is made from the standpoint of the mathematical expressions describing each system’s return signal from terrain at near-vertical incidence. The pulse-fm radar relationships resulting from this comparison facilitates application of the extensive information gained in previous pulse radar studies to the investigation of fm radar terrain return and the associated design of fm radar altimeters, and may also assist in the development of the new pulse-type radars.

Induction Heater Temperature Controller, Raymond A. Gore

Electrical and Computer Engineering ETDs

The author was presented with a system to control the power output of a radio frequency oscillator used for induction heating. The original system was unstable. It was stabilized but even then its performance was not satisfactory. Thus the problem was to design a satisfactory system using some of the components of the old system.

Conditional Effects In The Transistor Distributed Amplifier, Herbert D. Arlowe

Electrical and Computer Engineering ETDs

No abstract provided.

A Conversion Means Between The Crc-102a And Maniac I., Theodore E. Smart

Electrical and Computer Engineering ETDs

The University of New Mexico has acquired two general purpose computers; a CRC-102A and MANIAC I. The MANIAC I has been installed and is nearing operational status, while the CRC-102A has been in use for some time. When both computers are operating it will be desirable, in certain, cases, to program a problem for both. A means for translating a program for one of the machines into a program for the other with a minimum of manual effort would, therefore, be useful. The purpose of this project was to translate the commands for one computer into commands for the other …

A Method Of Measuring Temperature Changes Casued By Strong Shock Phenomena, Benjamin J. Goodier

Electrical and Computer Engineering ETDs

This thesis is concerned with the development of a method to measure the temperature of a metal surface during a time interval of a few microseconds while it is being subjected to a strong shock. The temperature of a special interest is the temperature of the free surface which appears after a strong shock has been reflected from that surface. This temperature remains constant until another shock wave is reflected from the surface, except for the change caused by heat loss to the surroundings by radiation.

Theory And Fabrication Of Point Contact Diodes Utilizing Reduced Single Crystal Rutile Tio2, Goebel Davis Jr.

Electrical and Computer Engineering ETDs

Single Crystal Rutile TiO2 upon reduction by heating in an atmosphere of hydrogen becomes a semiconductor, and the conductivity increases with the time and temperature of reduction. The reduction process creates oxygen vacancies with which there are associated two loosely bound electrons. These electrons may be raised to the conduction band by thermal excitation. Hence, an oxygen vacancy behaves like an impurity donor site.

Computer Programs For Determining Radar Return Power And Fading Spectra, Chung Chia

Electrical and Computer Engineering ETDs

The properties of radar terrain return at near vertical incidence have been under investigation at the University of New Mexico with Sandia Corporation, Albuquerque, New Mexico, and the United States Naval Ordinance Test Station, China Lake, California.

The Use Of Compensation With Directional Couplers, Roland Alan Lincoln

Electrical and Computer Engineering ETDs

This thesis describes an improved technique for measuring voltage standing wave ratio (VSWR). The reflectometer system is analyzed, and an improved coaxial system is presented which more accurately measures VSWR.

Transient Sensitivity Of Piezoelectric Accelerometers, William E. Baker

Electrical and Computer Engineering ETDs

No abstract provided.

Design Of Crystal Filters, Charles E. Schmidt

Electrical and Computer Engineering ETDs

This thesis concerns the application of electromechanical impedance elements to electric wave filters, so it is appropriate to begin with some discussion of such elements. The most important type is the piezoelectric resonator, most commonly made quartz.

Practical Analysis Of Blocking Oscillators, Richard D. Griffith

Electrical and Computer Engineering ETDs

The objective is to give a method of treatment of blocking oscillator circuits which will be of practical value for circuit design. An attempt has been made to reach a good compromise between accuracy, generality, and usefulness. The use of statistical methods to complement the mathematical analyses is stressed.

A Study Of Drift Mobility In Neutron Irradiated N-Type Germanium, William H. Closser

Electrical and Computer Engineering ETDs

With the advent of the transistor in the late 1940's have come an entirely new field of engineering and a greatly renewed interest in solid state physics. This paper will be concerned in general with the electrical properties of these materials, and specifically drift mobility of the minority carriers in n-type germanium. The minority carrier in n-type material is the hole. The definition of drift mobility is: the mean carrier velocity per unit electric field.

The Fields Of Electric Dipoles In Sea Water- The Earth-Air-Ionosphere Problem, Wallace L. Anderson

Electrical and Computer Engineering ETDs

In the initial part of the following investigation; expressions will be obtained for the Hertz potential in three regions of arbitrary conductive and dielectric properties. The regions are separated from each other by two infinite parallel planes. In directions normal to these planes, the regions above and below the intermediate layer are considered to be of semi-infinite extent. The regions are individually homogeneous. An electric dipole is located in one of the semi-infinite media, which will be called medium 1. The intermediate layer is called medium 2, and the other medium 3.

Acceleration Of A Symmetric Plasmoid In An Axial Magnetic Bias Field, Richard Daniel Jones

Electrical and Computer Engineering ETDs

A pulsed gas, electrodeless discharge, plasma accelerator facility has been developed for experimental studies of the coupling mechanism for the transfer of energy from a driving magnetic field to a plasma. Gas at low pressure is ionized by an azimuthal electrical field induced through the action of a rapidly varying axial magnetic field produced by the flow of current through a ring surrounding a confining glass shock tube. The tube is arranged to permit radial expansion of the ionized gas. Due to its conductivity, the plasma, once it is formed, can exclude the rapidly varying driving magnetic field for a …

A Radar Refraction Correction For Symmetric And Nonsymmetric Tropospheric Index Distributions, Ralph J. Rainey Jr.

Electrical and Computer Engineering ETDs

The high precision radars now in use have demonstrated the need for more exact refraction correction than is afforded by any fixed "standard" refractive index profile. The precision capabilities are even substantial enough to cause concern over the possible effects of the non-symmetric index distribution which introduces azimuthal errors. However, the indications are that the present limitation on true range measurements are primarily due to limitations on the radar itself, and a "gross" average correction is adequate for many cases of interest.

A Development Of An Equivalent Circuit Of A Hall Generator Which Utilizes A Flux Concentrator, Laurence L. Rosier

Electrical and Computer Engineering ETDs

The development of the transistor has brought about a great deal of research in the field of semiconductors. One of the results in this research is the development of the Hall effect. A number of new devices which utilize the Hall effect have been proposed; however, more theoretical and experimental work is required to determine which of these devices are practical. The success of the equivalent circuit approach in the other fields of electrical engineering suggests that an equivalent circuit which would represent Hall effect devices would be useful. The development of such an equivalent circuit should be centered about …

Scatter Matrix Analysis Of Plane Waves In A Layered Media, Bill W. Ashworth

Masters Theses

"The problem was the application of matrix theory to the solution of the reflection and transmission coefficients for a plane wave incident on a layered media. Background material relating to the problem was reviewed. Equations that were used in the solution of the problem were either derived or explained. The derivations for the reflection and transmission coefficients were carried out in order, starting with the simple case of normal incidence on a junction of two infinite media and progressing through the more difficult case of oblique incidence on a layer of finite thickness separating two infinite media. Scatter matrix analysis …

Design Of A Square Loop Magnetic Integrating Device, Fred Leland Grismore Jr.

Masters Theses

"The problem investigated in this research was the development of a static integrating circuit applicable to closed loop feedback control systems. Investigation of various methods of attack indicated that square loop magnetic cores offered characteristics required for the integration process. These include the ability to sum input information and the ability to store information for an indefinite period of time.

An experimental program was carried out, investigating the various properties of square loop magnetic materials and required design parameters. Through this work it was verified that the process of integration could be realized by using the partial switching volt-second absorption …

A Study Of Viscous Frictional Effects And Relay Characteristics On The Operation Of A Positional Relay Servomechanism, Earl F. Richards

Masters Theses

"The thesis describes some experimentally observed data and analytical approaches to the study of a relay servomechanism. The experimental data were secured from an analog simulation of a relay servo system. The results of this data were compared to the transient approach by use of the phase-plane method. The stability of the system was determined using a describing-function. The analytical approaches are described in the presentation.

A study of the effects of viscous friction is described, and the characteristic of the relay used in the system is given special attention. The response to input driving function was considered, and rise …

Pulse Height Digitizer For Fast Random Pulses, Andrew E. Pope

Electrical and Computer Engineering ETDs

The purpose of this project was to develop airborne electronic equipment which would digitize the amplitude of random, fast, video pulses to an accuracy greater than one percent. For a detailed description of this task, refer to Appendix A, Research Contract Proposal 56-13AEE, “Development of an Anglo-To-Digital Converter.” This report covers the complete system design and the development of several basic circuits, in their practical form, which demonstrate system design feasibility.

Demodulation Of A Special Am-Fm Signal, Donald W. Dearholt

Electrical and Computer Engineering ETDs

As telemetry becomes more and more important in returning information, new types of modulation arise. Sometimes the modulation used is a direct result of a particular type of transducer, although the output of the transducer may be modified before the carrier is modulated to cause a very different type of signal than would otherwise have occurred.

A Study Of Minimum Element Syntheis Of A Two-Pole Rc Driving Point Impedance, William F. Carlson

Electrical and Computer Engineering ETDs

The point of view taken in this thesis is from the point of view of economy. A network containing resistors of values 1 ohm and 1 megohm may present problems of accuracy and element tolerance limits which are not aided by the fact that all elements may be increased or decreased by a constant multiplier without changing the shape of the network gain curve.

A Microwave Technique For Determining The Electronic Properties Of A Moving Plasma, Bernard Hayes

Electrical and Computer Engineering ETDs

A microwave interferometer technique which may be used as a diagnostic tool for determining the electronic properties of a moving plasma is described and analyzed. The plasma and microwaves are confined in a wave guide and longitudinal observation is employed. The complex reflection coefficient determined from resultant standing-wave pattern provides the means for obtaining the complex dielectric constant, conductivity, electron concentration and collision frequency of electrons with molecules in the plasma. The plasma used for these experiments is the reaction products of a gas detonation.

Functional And Economic Considerations Of An Electrical Line Feeding Large Concentration Loads, Seth O. Lewis

Electrical and Computer Engineering ETDs

This paper discusses the considerations required for selecting particular characteristics of [transmission lines] and presents an original method of obtaining the most economical solution. A typical problem at the Public Service Company of New Mexico is solved to illustrate the usefulness of this method.

Design And Use Of A High Power Laser For Plasma Generation Studies., Philip N. Mace

Electrical and Computer Engineering ETDs

The advent of high power lasers to the technological scene has introduced the possibility of creating new effects utilizing the interaction of this high intensity light with matter. C. M. Fowler and D. B. Thomson of the Los Alamos Scientific Laboratory suggested in 1963 the possibility of using a high power laser to pre-ionize and heat a target material to be contained in an explosively driven theta pinch machine. There had been calculations performed by John Dawson, Princeton University, and A. Engel­hardt, Westinghouse Research Laboratories, which indicated that such an approach was theoretically feasible. The laser powers required, however, were …

Determination Of Required Component Reliability From System Reliability Requirements, Arthur M. Breipohl

Electrical and Computer Engineering ETDs

No abstract provided.

Analysis And Simulation Of A Cross-Correlation Communication System, Dennis Jay Gooding

Masters Theses

"Statement of the problem. The purpose of this study was (1) to calculate the probability of error as a function of receiver input signal-to-noise ratio for a typical communication system employing cross-correlation detection; (2) to design and construct an experimental model of such a communication system for the purposes of demonstrating the operation of the system and verifying the theoretical calculations"--Introduction, page 1.

Analysis And Synthesis Of A Current Regulator System, William P. Aiello

Electrical and Computer Engineering ETDs

This report describes a practical current regulator system used to accurately control the current delivered by a 500 kilowatt motor-generator unit. The generator supplies its current of 2000 amperes at 250 volts to a large water-cooled air-core solenoid used by LASL Group P-7 for experiments in connection with the Sherwood program.

After a general discussion of the system specifications and the basic regulator loop, each of the components in the basic regulator loop is described in considerable detail. The description, in most cases, is mathematical in nature although many circuit diagrams are included with brief descriptions when necessary for proper …

The Equalization And Optimization Of A Third-Order Type-1 Position Control System, Viswanatha Seshadri

Masters Theses

"While the practice of feedback control dates back to the day when the earliest living organisms began to react to their environmental conditions and the changes therein, it has been only during the past two decades that this technique came to be subjected to a scientific examination. Yet, an astoundingly rapid advancement has resulted in the field of servo-mechanisms, contributing substantially to the development of modern civilized existence and activity to its present standards, and promising to contribute, to an ever-increasing extent, to the accelerated progress of scientific and industrial enterprise in this space age.

The principal concerns of the …

Design Of An Intermediate Frequency Amplifier And Variable Frequency Oscillator, Robert Charles Mcintyre

Masters Theses

"Since the advent of the transistor in 1948 many technological barriers have been overcome in the field of semiconductors. Unfortunately, however, there is a considerable period of time between the discovery of a scientific phenomena and its widespread use and understanding by practicing engineers. The motivating factor which prompted this investigation was primarily the lack of knowledge which the author possessed concerning transistors. The selection of the amplifier and oscillator design confined the study primarily to the transistor. Considerable time, however, had to be spent in the study of basic transistor theory before any phase of the design could be …