Digital Commons Network^™

Physical Properties Of Concrete At Early Ages, Karl H. Dunn

Masters Theses

"There are well over 100,000 miles of concrete pavements existing today on our United States highway system. The development of these pavements during the first half of this century has been a process of learning from construction applications and mistakes. However, the unexpected increase in traffic load has brought highway designers to experiment with relatively new types and designs of concrete pavement construction.

Some designers, in an effort to reduce temperature warping stresses, have used short slabs 10 to 15 feet in length, generally unreinforced. Another type of construction is the definitely jointed slabs, the slabs being from 20 to …

Physical Properties Of Concrete At Early Ages, Curtis E. Weddle Jr.

Masters Theses

"The introduction of the motor vehicle and the subsequent rapid expansion of the highway systems of the United States have brought with them many problems.

The Civil Engineer, in his attempts to provide adequate safe avenues of travel for the populace, has been faced with many problems. Handicapped by the need for speed in design and lack of information of the trends in motor vehicle design, the engineer has been forced at times to utilize design methods inconsistent with good engineering practices.

Of the many types of pavement sections which have been designed in an effort to provide structurally and …

A Determination Of The Sonic Modulus Of Early Age Concrete, William Dale Nelson

Masters Theses

"The problem which the writer is analyzing in this thesis was suggested by Professor E. W. Carlton of the Civil Engineering Department. It is a determination, by use of sonic testing equipment, of the growth in the sonic modulus of early age concrete.

Since 1938 when T. C. Powers published his paper, "Measuring Young's Modulus of Elasticity by Means of Sonic Vibrations", in the proceedings of the American Society of Testing Materials, Vol. 38, Part II, a great deal of work has been done on the applications of sonic testing of concrete. It began a new era in concrete testing, …

The Strength Of Bituminous Mixtures And Their Behavior Under Repeated Loads, Part 2, Leonard E. Wood, William Harner Goetz

JTRP Technical Reports

No abstract provided.

Selection And Retention Of Civil Engineer Employees : Technical Paper, Arthur K. Branham

JTRP Technical Reports

No abstract provided.

The Effect Of Base Course Gradation On The Results Of Laboratory Pumping Tests : Technical Paper, W. P. Chamberlin, Eldon J. Yoder

JTRP Technical Reports

No abstract provided.

Selection And Retention Of Civil Engineers, Arthur K. Branham

JTRP Technical Reports

No abstract provided.

Correlation Of Accident Rates And Roadway Factors, John C. Woo

JTRP Technical Reports

No abstract provided.

Load Deformation Characteristics Of Bituminous Mixtures Under Various Conditions Of Loading : Technical Paper, William Harner Goetz, John Francis Mclaughlin, Leonard E. Wood

JTRP Technical Reports

No abstract provided.

Filter Materials For Emergency Use In Diatomite Type Water Filters, Robert Wassell Mcleane

Masters Theses

"A completely different type of filter, using diatomaceous earth as the filter media, had been in use for many years for filtration of industrial liquids, however, the use of diatomaceous earth for water filtration purposes had been discouraged due to the rapid clogging of the filter material. "As late as 1930 it was reported that the very excellence of filtration with diatomite prevented its extensive use in water filtration except where complete elimination of bacteria and suspended matter is essential.”

Diatomaceous earth, however, seemed to exhibit the general properties the research groups were seeking; in the refined state it exhibited …

The Magnitude And Directions Of Strains And Stresses In Edge Loaded Concrete Slabs, William M. Baldwin

Masters Theses

"The concrete industry in the United States represents one of the fastest growing segments of the national economy. Many reasons for this may be given, among which are, the durability of concrete structures, the local availability of a large portion of the materials used in concrete, and its wide range of adaptability to the designs of engineers and architects.

One of the most recent changes in concrete usage is the change from reinforced concrete to prestressed concrete. The term prestressed as used herein refers to any type of reinforced concrete in which the reinforcing material has a stress prior to …

Hydraulic Model Studies Of Culvert Operation, Eugene M. West

Kentucky Transportation Center Research Report

Since 1951 the Division of Research has been engaged in a comprehensive study of highway drainage problems. This study has included special investigations of rainfall and runoff, drainage structures in use and the practices used in their design, culvert hydraulics, and other relevant investigations. To date, reports have been published concerning runoff and rainfall variables (1 and 2)* and the effects of barrel roughness upon culvert operation (3), together with the preparation of a drainage manual for the use of Highway Department engineers and consultants.

The most recent special project, part of the over-all study, has dealt with the effects …

Determination Of The Effect Of Air-Entraining Agents On Certain Physical Properties Of Concrete At Early Ages, James Arthur Spilman

Masters Theses

"Air entrained concrete over the past eighteen years has received national recognition as a result of its satisfactory performance in highway concrete pavements and other concrete structures subjected to outside exposure.

Numerous highway departments over the entire United States have laid test slabs made of air entrained concrete. Among those to date are Pennsylvania, New Jersey, New York, Connecticut, Massachusetts, Vermont, Maine, Illinois, Missouri and California. The primary purpose in building these test slabs was to investigate their durability or resistance to freezing and thawing and the action of various salts on air entrained concrete. The results of the test …

The Strength Of Bituminous Mixtures And Their Behavior Under Repeated Loads, Leonard E. Wood, William Harner Goetz

JTRP Technical Reports

No abstract provided.

Physical Properties Of Concrete At Early Ages, Peter G. Hansen

Masters Theses

"One of the principal types of heavy duty pavements in use in Missouri and in many other states is that known as rigid type portland cement concrete.

There have been two major trends in this type of pavement design. One of these trends is the use of short slabs, i.e., 15 to 25 feet, with no reinforcement. Another trend consists of concrete slabs containing distributed reinforcement such as wire mesh or reinforcing bars with joints occurring at fairly large intervals of 50 to 100 feet. As loads on the highways have increased the designers have increased the slab thicknesses and …

Measurement Of Irrigation Water, Eldon M. Stock

Reports

Foreword: Although irrigation has been practiced in Utah for more than one hundred years, irrigation water still is being distributed to farmers with little or not thought about its measurement. A farmer would not think of buying or selling other farm commodities, such as hay, grain, beef cattle, or dairy products, without weighing or accurately measuring them, but at the same time he is often content to accept and pay for the irrigation water received with little or no knowledge as to the actual amount received, or whether or not he is receiving the amount he is entitled to. Measurement …

The Design And Construction Of An Electrolytic Cell For Aluminum Reduction, Thomas H. Melrose

Bachelors Theses and Reports, 1928 - 1970

The purpose of this investigation was to design and construct a laboratory size electrolytic cell in which to reduce alumina, using the same basic materials that are used in a commercial size cell. The cell was designed to have a capacity of approxi­mately 100 grams of metallic aluminum produced every 8 hours. The cell was constructed so it could be operated continuously.

Investigation Of Inclusions In Armco Ingot Iron, Edwin J. Duncan

Bachelors Theses and Reports, 1928 - 1970

Various chemical and electrolytic separation methods were investigated in an attempt to separate the in­clusions in Armco ingot iron. Residues obtained were X-rayed for identification purposes. The microstruc­tures of this iron were studied with the object of de­termining the relative sizes, locations, and possible compositions of the inclusions.

Effect Of Recovery On The Recrystallized Grain-Size Of High Purity Aluminum, Rodney L. Helterline

Bachelors Theses and Reports, 1928 - 1970

When a cold-worked metal is annealed, it’s physical properties hange as a result of a new grain structure. The annealing treatment is divided into three stages according to the changes that occur in the distorted metal: (1) recovery, (2) recrystallization, and (3) grain growth.

Polarography Of Indium, John Jackson

Bachelors Theses and Reports, 1928 - 1970

The purpose of this thesis is to study the various aspects of the polarography of indium. The eventual goal would be to develop a method of analyzing indium in unknowns. The investigation is approached by studying the indium ions in various electrolytes and in various concentrations.

Geology Of The Ragged Point Oil Field Musselshell County, Montana, David M. Amos

Bachelors Theses and Reports, 1928 - 1970

The Ragged Point oil field is located in Northwest Musselshell County, in the Lake Basin field of central Mon­tana, and on the western border of the Great Plains region. The surface topography is that of a plain marked by erosion and moderate folding. The stratigraphy of central Montana shows periodic marine invasions from the Cordilleran trough, with normal marine limestones interbedded with sandstone sand shales. These sediments are over 12,000 feet thick, with the Creta­ceous Eagle and Colorado formations exposed at the surface on the Ragged Point anticline. Undifferentiated Cambrian lime­stones and shales are the oldest rocks encountered in drilling.

An Investigation Of Continuous Steel Beams In The Plastic Range, Robert Adams Shoolbred

Masters Theses

"The purpose of this thesis is to investigate the action of beams in the plastic range. The test specimen will be a 4WF 13 structural shape continuous over three supports having equal span lengths of seven feet. Three types of loading were chosen. The first loading will be concentrated in the center of each span. The second loading will be a concentrated load in the center of one span only. The third loading will be the settlement of the two end supports until a plastic hinge forms at the center support, then the two spans will be loaded with concentrated …

Horizontal Pressures On Retaining Walls Due To Line Surface Loads, John B. Heagler

Masters Theses

"Among the oldest types of structures with which engineers have had to deal are those which serve to laterally restrain masses of earth, or to prevent earth embankments from assuming their natural angle of repose. This is necessary where space is limited or the natural slope would encroach upon other property. These structures, usually called retaining walls, are subjected to forces, both lateral and vertical due to the pressures exerted by the backfill material and any loads imposed on the backfill material. The first step in the design of the retaining wall is to determine the magnitude, position, and line …

Evaluation Of Sprinkler Irrigation Systems In Northern Utah, Jay M. Bagley, Wayne D. Criddle

Reports

Summary and Conclusions: Sprinkler irrigation will continue to expand in Utah as well as in other irrigated areas of the world. This method of irrigation is suitable to all farm crops grown in the state and to most soils. It is particularly adapted to steep foothill areas where the water supply can be obtained at higher elevation and pumping is not necessary to develop pressure for the sprinkler systems. Also, much of the irrigated land of the state, particularly along the Wasatch front, is owned and operated by "part-time" farmers. Having the water under complete control and the irrigation schedule …

The Application Of Electric Energy To The Metallurgy Plants In Montana, Edwin J. Duncan

Bachelors Theses and Reports, 1928 - 1970

Since the year 1800, metallurgy has been affiliated with electricity. In fact, the two industries have grown side by side, being naturally dependent upon each other and having a parallel growth.

The Construction And Operation Of A Universal Specimen Mount With Protective Lead Shield For The Purpose Of Determining Pole Figures Using The Schulz-Decker Transmission Technique, Richard L. Fausner

Bachelors Theses and Reports, 1928 - 1970

It was the purpose of this study to construct a universal mount, to construct a protective lead shield, to operate the instrument, and to provide a pole figure using the transmission method of Schulz and Decker. There are at present several lengthy x-ray methods of determining the grain orientation of metals. These methods are mainly photographic. In order to provide a rapid means of obtaining the necessary information concerning the grain orientation of a metal, a universal mount was constructed.

The Lucky Hit Mine Of Jefferson County, Montana, Bruce B. Goddard

Bachelors Theses and Reports, 1928 - 1970

Many mines in the Cardwell Mining District have been more or less steady producers of gold, silver, lead and zinc since 18SO. The area first came into prominence with the discovery of gold at the Mayflower Mine in 1896. Soon after the Mayflower discovery, many claims were located in the nearby Saint Paul Gulch area, northeast of Whitehall. The Lucky Hit Mine is located in Saint Paul Gulch area of the Cardwell Mining District.

Nonmetallic Mineral Resources Of Montana (Except Fuels), F. L. Rytlewski

Bachelors Theses and Reports, 1928 - 1970

Essentially, the paper is composed of seven parts, each of which concerns a group of related nonmetallic minerals such as ceramic materials, gemstones, or abra­sives. Following the data pertaining to the minerals of each group are index mars locating the major mineral deposits which are known to date. Production and reserve figures are listed by tables in cases where such information is available.

The Flotation Concentration Of A Complex Low-Grade Lead Zinc Ore, Edward James Fong

Bachelors Theses and Reports, 1928 - 1970

This report is concerned primarily with the beneficiation of a low-grade complex lead-zinc ore. The depletion of high grade veins has caused the mineral engineer to seek deposits deeper in the earth's crust or to find lower grade deposits. The other alternative has placed more research problems on Mineral Dressing Engineers in particularly the iron, copper, lead and zinc fields.

Host Rocks And Gangue Minerals Associated With Copper Deposits In Plutonic Igneous Rocks, Richard D. Montgomery

Bachelors Theses and Reports, 1928 - 1970

All of the information on the various districts has come directly from published reports. The investigation was suggested by Mr. Forbes Robertson. The geographical extent of the deposits was confined to the western United States. Many of these deposits are of the disseminated porphyry type. A few of the de­posits, such as at Butte, Montana, were of the fissure vein type.