Open Access. Powered by Scholars. Published by Universities.®
Science and Technology Studies Commons™
Open Access. Powered by Scholars. Published by Universities.®
- Institution
- Publication
- Publication Type
Articles 1 - 12 of 12
Full-Text Articles in Science and Technology Studies
Synchrotron Radiation Based Experimental Determination Of The Optimal Energy For Cell Radiotoxicity Enhancement Following Photoelectric Effect On Stable Iodinated Compounds, S Corde, A Joubert, J F. Adam, A M. Charvet, J F. Le Bas, F Esteve, H Elleaume, J Balosso
Synchrotron Radiation Based Experimental Determination Of The Optimal Energy For Cell Radiotoxicity Enhancement Following Photoelectric Effect On Stable Iodinated Compounds, S Corde, A Joubert, J F. Adam, A M. Charvet, J F. Le Bas, F Esteve, H Elleaume, J Balosso
Stéphanie Corde
This study was designed to experimentally evaluate the optimal X-ray energy for increasing the radiation energy absorbed in tumours loaded with iodinated compounds, using the photoelectric effect. SQ20B human cells were irradiated with synchrotron monochromatic beam tuned at 32.8, 33.5, 50 and 70 keV. Two cell treatments were compared to the control: cells suspended in 10 mg ml1 of iodine radiological contrast agent or cells pre-exposed with 10 mM of iodo-desoxyuridine (IUdR) for 48 h. Our radiobiological end point was clonogenic cell survival. Cells irradiated with both iodine compounds exhibited a radiation sensitisation enhancement. Moreover, it was energy dependent, with …
Numerical Study On Springback With Size Effect In Micro V-Bending, Zhi Fang, Haina Lu, Dongbin Wei, Zhengyi Jiang, Xianming Zhao, Di Wu
Numerical Study On Springback With Size Effect In Micro V-Bending, Zhi Fang, Haina Lu, Dongbin Wei, Zhengyi Jiang, Xianming Zhao, Di Wu
Faculty of Engineering and Information Sciences - Papers: Part A
With the development of microforming technology, the demand on accuracy of the metallic micro components is elevating. While springback phenomenon which is inevitable during bending process, can cause unpredicted dimensional error, bringing difficulties to the downstream assembly, and let alone the springback in microforming as the measurements of tools and workpieces downsize hundreds even thousands times. This paper focuses on the springback effect that occurs after the micro Vbending a classic processing method to manufacture microparts. Numerical simulation has been conducted to investigate the size effect in terms of Voronoi tessellation and springback. A finite element (FE) model of the …
Effect Of Holding Temperature And Time On Ferrite Formation In Dual Phase Steel Produced By Strip Casting, Zhiping Xiong, Andrii Kostryzhev, Nicole Stanford, Elena V. Pereloma
Effect Of Holding Temperature And Time On Ferrite Formation In Dual Phase Steel Produced By Strip Casting, Zhiping Xiong, Andrii Kostryzhev, Nicole Stanford, Elena V. Pereloma
Faculty of Engineering and Information Sciences - Papers: Part A
Conventional dual phase (DP) steel (0.08C-0.81Si-1.47Mn-0.03Al, wt. %) was manufactured by the laboratory simulation of strip casting. The effect of holding temperature and time on microstructure evolution was studied using a quench-deformation dilatometer. Microstructures were observed using optical and scanning electron microscopy. The results showed that the nose temperature of ferrite phase field is around 650 °C. The kinetics of ferrite formation is fast within the first 100 s of holding at this temperature, and then formation of ferrite continues at a slower rate until it reaches the fraction corresponding to that defined by the lever rule. 70~80 % ferrite …
Effect Of A Grain-Refined Microalloyed Steel Substrate On The Formation Mechanism Of A Tight Oxide Scale, Xianglong Yu, Zhengyi Jiang, Jingwei Zhao, Dongbin Wei, Cunlong Zhou, Qingxue Huang
Effect Of A Grain-Refined Microalloyed Steel Substrate On The Formation Mechanism Of A Tight Oxide Scale, Xianglong Yu, Zhengyi Jiang, Jingwei Zhao, Dongbin Wei, Cunlong Zhou, Qingxue Huang
Faculty of Engineering and Information Sciences - Papers: Part A
The formation mechanism of tight oxide scale on the microalloyed steel was investigated at temperatures of 550-850 °C in dry air. Microstructural characterisations reveal that the spallation of oxide scale dominates at the centre of coarse grains on the oxidation initiation. The fine-grained steel improves the adhesive properties of oxide scale by enhanced grain-boundary diffusion. The lower activation energy and higher oxidation rate accelerate cation/anion migration along grain boundaries, leading to high magnetite content in the oxide scale. The approach by grain refinement at initial oxidation has been proposed to generate the pickle-free tight oxide scale.
Enhancement Of Trace Organic Contaminant Degradation By Crude Enzyme Extract From Trametes Versicolor Culture: Effect Of Mediator Type And Concentration, Ngoc Luong Nguyen, Faisal Ibney Hai, Jinguo Kang, Frederic Leusch, Felicity Roddick, S Faraj Magram, William Price, Long Nghiem
Enhancement Of Trace Organic Contaminant Degradation By Crude Enzyme Extract From Trametes Versicolor Culture: Effect Of Mediator Type And Concentration, Ngoc Luong Nguyen, Faisal Ibney Hai, Jinguo Kang, Frederic Leusch, Felicity Roddick, S Faraj Magram, William Price, Long Nghiem
Faculty of Engineering and Information Sciences - Papers: Part A
The performance of two redox mediating compounds, namely 1-hydroxybenzotriazole (HBT) and syringaldehyde (SA), was compared in terms of enhancement of enzymatic degradation of a diverse set of 14 phenolic and 16 non-phenolic trace organic contaminants (TrOCs) and the toxicity of the treated media. Extracellular enzyme extract (predominantly containing laccase) from Trametes versicolor culture achieved efficient degradation (70-95%) of nine phenolic and one non-phenolic TrOCs. Mediator dosing extended the spectrum of efficiently degraded TrOCs to 13 phenolic and three non-phenolic compounds, with moderate improvements in removal of a few other non-phenolic compounds. TrOC removal efficiency improved significantly as the HBT dose …
Effect Of Austenite Deformation Temperature On Nb Clustering And Precipitation In Microalloyed Steel, E V Pereloma, A G Kostryzhev, A Alshahrani, C Zhu, J M. Cairney, C R. Killmore, S P. Ringer
Effect Of Austenite Deformation Temperature On Nb Clustering And Precipitation In Microalloyed Steel, E V Pereloma, A G Kostryzhev, A Alshahrani, C Zhu, J M. Cairney, C R. Killmore, S P. Ringer
Faculty of Engineering and Information Sciences - Papers: Part A
The effect of thermomechanical processing conditions on Nb clustering and precipitation in both austenite and ferrite in a Nb-Ti microalloyed steel was studied using electron microscopy and atom probe tomography. A decrease in the deformation temperature increased the Nb-rich precipitation in austenite and decreased the extent of precipitation in ferrite. Microstructural mechanisms that explain this variation are discussed. 2013 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
The Effect Of Processing Parameters On The Microstructure And Mechanical Properties Of Low-Si Transformation-Induced Plasticity Steels, Fayez Alharbi, Azdiar A. Gazder, Andrii Kostryzhev, Bruno C. De Cooman, Elena Pereloma
The Effect Of Processing Parameters On The Microstructure And Mechanical Properties Of Low-Si Transformation-Induced Plasticity Steels, Fayez Alharbi, Azdiar A. Gazder, Andrii Kostryzhev, Bruno C. De Cooman, Elena Pereloma
Faculty of Engineering and Information Sciences - Papers: Part A
A base low Si, high-A1 transformation-induced plasticity (TRIP) steel and one with 0.03Nb and 0.002Ti (wt percent) additions were subjected to thermo-mechanical processing (TMP) and galvanising simulations. T
Photonic Aharonov-Bohm Effect In Photon-Phonon Interactions, Enbang Li, Benjamin J. Eggleton, Kejie Fang, Shanhui Fan
Photonic Aharonov-Bohm Effect In Photon-Phonon Interactions, Enbang Li, Benjamin J. Eggleton, Kejie Fang, Shanhui Fan
Faculty of Engineering and Information Sciences - Papers: Part A
The Aharonov-Bohm effect is one of the most intriguing phenomena in both classical and quantum physics, and associates with a number of important and fundamental issues in quantum mechanics. The Aharonov-Bohm effects of charged particles have been experimentally demonstrated and found applications in various fields. Recently, attention has also focused on the Aharonov-Bohm effect for neutral particles, such as photons. Here we propose to utilize the photon-phonon interactions to demonstrate that photonic Aharonov-Bohm effects do exist for photons. By introducing nonreciprocal phases for photons, we observe experimentally a gauge potential for photons in the visible range based on the photon-phonon …
The Effect Of Ageing On Microstructure And Mechanical Properties Of Powder Ti-5al-5mo-5v-1cr-1fe Alloy, Mansur Ahmed, Dmytro Savvakin, Orest M. Ivasishin, E V. Pereloma
The Effect Of Ageing On Microstructure And Mechanical Properties Of Powder Ti-5al-5mo-5v-1cr-1fe Alloy, Mansur Ahmed, Dmytro Savvakin, Orest M. Ivasishin, E V. Pereloma
Faculty of Engineering and Information Sciences - Papers: Part A
The thermo-mechanically processed powder Ti-5Al-5V-5Mo-1Cr-1Fe alloy was aged at 9.23 K for 1-8 h in order to investigate the effect of ageing time on the microstructure-mechanical properties relationships. The microstructures of the alloy after ageing cosist of the both primary and secondary alpha phases with retained B matrix phase. The shift of B peaks in X-ray pattern with ageing time indicates an increase in lattice parameter distorition due to diffusion into the retained B phase of more B stabilisers with smaller atomic radius compared to the elemental Ti. The tensile test results indicate that the sample aged for 1 h …
Effect Of Niobium Clustering And Precipitation On Strength Of A Nbti-Microalloyed Ferritic Steel, Andrii Kostryzhev, Abdullah Alshahrani, Chen Zhu, Julie Cairney, Simon Peter Ringer, Chris Killmore, E V. Pereloma
Effect Of Niobium Clustering And Precipitation On Strength Of A Nbti-Microalloyed Ferritic Steel, Andrii Kostryzhev, Abdullah Alshahrani, Chen Zhu, Julie Cairney, Simon Peter Ringer, Chris Killmore, E V. Pereloma
Faculty of Engineering and Information Sciences - Papers: Part A
The microstructure-property relationship of an NbTi-microalloyed ferritic steel was studied as a function of thermo-mechanical schedule using Gleeble 3500 simulator, optical and scanning electron microscope, and atom probe tomography.
Effect Of Directional Solidification Rate On The Microstructure And Properties Of Deformation-Processed Cu-7cr-0.1ag In Situ Composites, Keming Liu, Zhengyi Jiang, Jingwei Zhao, Jin Zou, Zhibao Chen, Deping Lu
Effect Of Directional Solidification Rate On The Microstructure And Properties Of Deformation-Processed Cu-7cr-0.1ag In Situ Composites, Keming Liu, Zhengyi Jiang, Jingwei Zhao, Jin Zou, Zhibao Chen, Deping Lu
Faculty of Engineering and Information Sciences - Papers: Part A
The influence of directional solidification rate on the microstructure, mechanical properties and conductivity of deformation-processed Cu-7Cr-0.1Ag in situ composites produced by thermo-mechanical processing was systematically investigated. The microstructure was analyzed by optical microscopy and scanning electronic microscopy. The mechanical properties and conductivity were evaluated by tensile-testing machine and micro-ohmmeter, respectively. The results indicate that the size, shape and distribution of second-phase Cr grains are significantly different in the Cu-7Cr-0.1Ag alloys with different growth rates. At a growth rate of 200 μm s-1, the Cr grains transform into fine Cr fiber-like grains parallel to the pulling direction from the Cr dendrites. …
Numerical Modeling Of Size Effect In Micro Hydromechanical Deep Drawing, Hideki Sato, Ken-Ichi Manabe, Dongbin Wei, Zhengyi Jiang
Numerical Modeling Of Size Effect In Micro Hydromechanical Deep Drawing, Hideki Sato, Ken-Ichi Manabe, Dongbin Wei, Zhengyi Jiang
Faculty of Engineering and Information Sciences - Papers: Part A
A modeling of tribological size effects in micro deep drawing (MDD) and micro hydromechanical deep drawing (MHDD) is a main focus in this study. The inner and outer pockets in which the different friction coefficients can be applied at different lubrication conditions are considered on the blank surface. The ratio of the area of outer pockets to inner pockets is changed with the decrease in the size. The low friction coefficient at the outer pockets is assumed in MHDD by considering the lubrication effect of fluid medium. The numerical analysis is performed under six lubrication conditions. The analytical results of …