Open Access. Powered by Scholars. Published by Universities.®
Science and Technology Studies Commons™
Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 4 of 4
Full-Text Articles in Science and Technology Studies
The Ocean Thermal Energy Conversion Strategies And Analysis Of Current Challenges, Lasantha Meegahapola, Lanka Udawatta, Sanjeeva Witharana
The Ocean Thermal Energy Conversion Strategies And Analysis Of Current Challenges, Lasantha Meegahapola, Lanka Udawatta, Sanjeeva Witharana
Dr Lasantha G Meegahapola
This paper presents different roots of Ocean Thermal Energy Conversion (OTEC) strategies and challenges faced in terms of efficiency and economy of OTEC plants. The conversion strategies primarily focus on open cycle, closed cycle and hybrid plants. The efficiency studies mainly skew towards the effect of plant distance and thermal gradient towards plant efficiency. The economic analysis is based upon the effect of per unit cost for OTEC plant together with other important considerations such as Plant Factor (PF) and offshore distance, which determine the cost of power generation. Some illustrative examples are also provided using the derived equations under …
Comparative Analysis Of Dynamic Line Rating Models And Feasibility To Minimise Energy Losses In Wind Rich Power Networks, Mathew Simms, Lasantha Meegahapola
Comparative Analysis Of Dynamic Line Rating Models And Feasibility To Minimise Energy Losses In Wind Rich Power Networks, Mathew Simms, Lasantha Meegahapola
Dr Lasantha G Meegahapola
Wind power generation has indicated an exponential increase during last two decades and existing transmission network infrastructure is increasingly becoming inadequate to transmit remotely generated wind power to load centres in the network. The dynamic line rating (DLR) is one of the viable solutions to improve the transmission line ampacity during high wind penetration without investing on an additional transmission network. The main objective of this study is to identify the basic differences between two main line rating standards, since transmission network service providers (TNSPs) heavily depend on these two standards when developing their line rating models. Therefore, a parameter …
Transient Stability Analysis Of A Power System With High Wind Penetration, Lasantha Meegahapola, Damian Flynn, Tim Littler
Transient Stability Analysis Of A Power System With High Wind Penetration, Lasantha Meegahapola, Damian Flynn, Tim Littler
Dr Lasantha G Meegahapola
This paper presents transient stability analysis for a power system with high wind penetration. The transient stability has been evaluated based on two stability criteria: rotor angle stability and voltage stability. A modified IEEE-14 bus system has been used as the main study network and simulations have been conducted at several wind power penetration levels, defined as a fraction of total system generation. A wide range of scenarios have been presented based on the wind farm voltage at the point of connection, i.e. low voltage (LV) distribution level and high voltage (HV) transmission level, and the type of wind generator …
Flicker Propagation Analysis In Distribution Networks With Embedded Generation, D Perera, L Meegahapola, S Perera, P Ciufo
Flicker Propagation Analysis In Distribution Networks With Embedded Generation, D Perera, L Meegahapola, S Perera, P Ciufo
Dr Lasantha G Meegahapola
Embedded generators such as wind generators can produce observable voltage fluctuations during variable wind conditions hence flicker. The flicker produced by such intermittent and fluctuating generating sources can propagate to other parts of the distribution network while creating power quality issues in distribution feeders. This study presents a flicker emission analysis for a doubly-fed induction generator (DFIG) based wind farm and investigate the pertinent factors which influence flicker propagation and attenuation in distribution feeders. Study has shown that voltage fluctuations are significantly influenced by the attenuation characteristics of various load types (i.e. constant power, impedance and current loads) connected to …