Open Access. Powered by Scholars. Published by Universities.®
- Institution
- Publication
- Publication Type
Articles 1 - 8 of 8
Full-Text Articles in Physics
Ultrashort Pulse Laser Filamentation Electrical And Optical Diagnostic Comparison, James E. Wymer
Ultrashort Pulse Laser Filamentation Electrical And Optical Diagnostic Comparison, James E. Wymer
Optical Science and Engineering ETDs
Results presented here examine the effect of changing gas pressure on the radio frequency (RF) emissions of an ultrashort pulse laser filament plasma and how those emissions vary longitudinally in the laser focal region. We use a WR284 rectangular waveguide with a 1.5 cm hole that allows the beam through. A 3.2 GHz microwave signal is emitted in the waveguide, and signals are received through a waveguide-to-coax antenna connected to an HP8470B Schottky diode. By enabling and disabling the 3.2 GHz signal, we measure both the self-emitted RF from a USPL filament and subsequently the degree of attenuation a filament …
Femtosecond Pulse Compression Via Self-Phase Modulation In 1-Decanol, Jacob A. Stephen
Femtosecond Pulse Compression Via Self-Phase Modulation In 1-Decanol, Jacob A. Stephen
Electronic Theses and Dissertations
Ultrafast science is a branch of photonics with far reaching applications in and outside the realm of physics. Ultrashort laser pulses on the order of femtoseconds (1 fs = 1 × 10−15 s) are widely used for ultrafast science. Many lasers can produce pulses on the order of 100 fs, with state of the art, high end lasers being capable of producing pulses around 30 fs. However, many experiments require pulses around 10 fs or shorter. Femtosecond pulses are typically generated using spectral broadening via self-phase modulation, followed by dispersion compensation. The most common spectral broadening technique exploits the nonlinear …
Generation And Use Of Femtosecond, Gigawatt, Near Infrared Laser Pulses From An Amplified, Mode-Locked, Ti:Sapphire Laser, David Anthony Valdés
Generation And Use Of Femtosecond, Gigawatt, Near Infrared Laser Pulses From An Amplified, Mode-Locked, Ti:Sapphire Laser, David Anthony Valdés
Optical Science and Engineering ETDs
This work modeled the early to middle successes achieved in the field of ultrafast, high peak power optics, beginning with the work of Nobel Prize winners Donna Strickland and Gérard Mourou in 1985. In our work, 100 fs light pulses of around 800 nm were generated by a Ti:Sapphire oscillator, then amplified to approximately 30 GW peak power using a chirped pulse amplification system that included regenerative and multi-pass amplifiers. As a verification of our pulses having high peak powers and ultrashort durations, they were then used to strike water, glass, and a Kerr Cell. Supercontinuum generation was observed as …
In Situ Measurement Of Three-Dimensional Ion Densities In Focused Femtosecond Pulses, James Strohaber, Cornelis J. Uiterwaal
In Situ Measurement Of Three-Dimensional Ion Densities In Focused Femtosecond Pulses, James Strohaber, Cornelis J. Uiterwaal
Department of Physics and Astronomy: Dissertations, Theses, and Student Research
We image spatial distribution of xenon ions in the focus of a laser beam of ultrashort, intense pulses in all three dimensions, with a resolution of three by twelve microns in the two transverse directions. This allows for studying ionization processes without spatially averaging ion yields. Our in situ ion imaging is also useful to analyze focal intensity profiles and to investigate the transverse modal purity of tightly focused beams of complex light. As an example, the intensity profile of a Hermite-Gaussian beam mode HG recorded with ions is found to be in good agreement with optical images.
Ultrashort Laser Pulse Interaction With Photo-Thermo-Refractive Glass, Leo Siiman
Ultrashort Laser Pulse Interaction With Photo-Thermo-Refractive Glass, Leo Siiman
Electronic Theses and Dissertations
Photo-thermo-refractive (PTR) glass is an ideal photosensitive material for recording phase volume holograms. It is a homogeneous multi-component silicate glass that demonstrates all the advantages of optical glass: thermal stability, high laser damage threshold, and a wide transparency range. Moreover the ability to record phase patterns (i.e. spatial refractive index variations) into PTR glass has resulted in the fabrication of volume holograms with diffraction efficiency greater than 99%. The conventional method of recording a hologram in PTR glass relies on exposure to continuous-wave ultraviolet laser radiation. In this dissertation the interaction between infrared ultrashort laser pulses and PTR glass is …
The Effects Of Electrode Geometry On Current Pulse Caused By Electrical Discharge Over An Ultra-Fast Laser Filament, Matthew Bubelnik
The Effects Of Electrode Geometry On Current Pulse Caused By Electrical Discharge Over An Ultra-Fast Laser Filament, Matthew Bubelnik
Electronic Theses and Dissertations
The time-resolved electrical conductivity of a short-pulse generated plasma filament in air was studied. Close-coupled metal electrodes were used to discharge the stored energy of a high-voltage capacitor and the resulting microsecond-scale electrical discharge was measured using fast current sensors. Significant differences in the time dependence of the current were seen with the two electrode geometries used. Using sharp-tipped electrodes additional peaks in the time-resolved conductivity were seen, relative to the single peak seen with spherical electrodes. We attribute these additional features to secondary electron collisional ionization brought about by field enhancement at the tips. Additional discrepancies in the currents …
Evaluation Of The Photo-Induced Structural Mechanisms In Chalcogenide, Cedric Lopez
Evaluation Of The Photo-Induced Structural Mechanisms In Chalcogenide, Cedric Lopez
Electronic Theses and Dissertations
Chalcogenide glasses and their use in a wide range of optical, electronic and memory applications, has created a need for a more thorough understanding of material property variation as a function of composition and in geometries representative of actual devices. This study evaluates compositional dependencies and photo-induced structural mechanisms in As-S-Se chalcogenide glasses. An effective fabrication method for the reproducible processing of bulk chalcogenide materials has been demonstrated and an array of tools developed, for the systematic characterization of the resulting material's physical and optical properties. The influence of compositional variation on the physical properties of 13 glasses within the …
Towards Direct Writing Of 3-D Photonic Circuits Using Ultrafast Lasers, Arnaud Zoubir
Towards Direct Writing Of 3-D Photonic Circuits Using Ultrafast Lasers, Arnaud Zoubir
Electronic Theses and Dissertations
The advent of ultrafast lasers has enabled micromachining schemes that cannot be achieved by other current techniques. Laser direct writing has emerged as one of the possible routes for fabrication of optical waveguides in transparent materials. In this thesis, the advantages and limitations of this technique are explored. Two extended-cavity ultrafast lasers were built and characterized as the laser sources for this study, with improved performance over existing systems. Waveguides are fabricated in oxide glass, chalcogenide glass, and polymers, these being the three major classes of materials for the telecommunication industry. Standard waveguide metrology is performed on the fabricated waveguides, …