Physics Commons^™

Pulsed Electro-Acoustic (Pea) Measurements Of Embedded Charge Distributions, Jr Dennison, Lee H. Pearson

Conference Proceedings

Knowledge of the spatial distribution and evolution of embedded charge in thin dielectric materials has important applications in semiconductor, high-power electronic device, high-voltage DC power cable insulation, high-energy and plasma physics apparatus, and spacecraft industries. Knowing how, where, and how much charge accumulates and how it redistributes and dissipates can predict destructive charging effects. Pulsed Electro-acoustic (PEA) measurements— and two closely related methods, Pressure Wave Propagation (PWP) and Laser Intensity Modulation (LIMM)— nondestructively probe such internal charge distributions. We review the instrumentation, methods, theory and signal processing of simple PEA experiments, as well as the related PPW and LIMM methods. …

Interaction Of Ultrashort-Laser Pulses With Induced Undercritical Plasmas In Fused Silica, Jeremy Gulley, Sebastian Winkler, William Dennis, Carl Liebig, Razvan Stoian

Jeremy R. Gulley

Ultrafast light-material interactions near the damage threshold are often studied using postmortem analysis of damaged dielectric materials. Corresponding simulations of ultrashort pulse propagation through the material are frequently used to gain additional insight into the processes leading to such damage. However, comparison between such experimental and numerical results is often qualitative, and pulses near to but not exceeding the damage threshold leave no permanent changes in the material for postmortem analysis. In this article, a series of experiments is presented that measures the near- and far-field properties of a 140-fs laser pulse after propagation through a fused silica sample in …

Measurements Of The Temperature Dependence Of Radiation Induced Conductivity In Polymeric Dielectrics, Jodie Corbridge Gillespie

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

Radiation Induced Conductivity (RIC) is the change in conductivity of a material due to bombardment from incident high energy radiation. This study is to determine the effect of RIC and RIC's temperature dependence in polymeric dielectrics, specifically Kapton HN, Kapton E, PTFE Teflon, Tefzel, and Low Density Polyethylene (LDPE). Interest in these materials arises from applications for use in future spacecraft, specifically the James Webb Space Telescope (JWST).

One major issue in the design of JWST, as in all spacecraft, is the charging and arcing of exposed materials, resulting in fatal damage to the electronics and/or the craft itself. Particles …

Transparent Actuator Made With Few Layer Graphene Electrode And Dielectric Elastomer, For Variable Focus Lens, Taeseon Hwang, Hyeok-Yong Kwon, Joon-Suk Oh, Jung-Pyo Hong, Seung-Chul Hong, Youngkwan Lee, Hyouk Ryeo Choi, Kwang J. Kim, Mainul Hossain Bhuiya, Jae Do Nam

Mechanical Engineering Faculty Research

A transparent dielectric elastomer actuator driven by few-layer-graphene (FLG) electrode was experimentally investigated. The electrodes were made of graphene, which was dispersed inN-methyl-pyrrolidone. The transparent actuator was fabricated from developed FLG electrodes.The FLG electrode with its sheet resistance of 0.45 kΩ/sq (80 nm thick) was implemented to mask silicone elastomer. The developed FLG-driven actuator exhibited an optical transparency of over 57% at a wavenumber of 600 nm and produced bending displacement performance ranging from 29 to 946 μm as functions of frequency and voltage. The focus variation was clearly demonstrated under actuation to study its application-feasibility in …

Electron Energy Dependent Charging Effects Of Multilayered Dielectric Material, Gregory Wilson, Jr Dennison, Amberly Evans Jensen, Justin Dekany

Graduate Student Publications

Measurements of the charge distribution in electron-bombarded, thin-film, and multilayer dielectric samples showed that charging of multilayered materials evolves with time and is highly dependent on incident energy; this is driven by electron penetration depth, electron emission, and material conductivity. Based on the net surface potential’s dependence on beam current, electron range, electron emission, and conductivity, measurements of the surface potential, displacement current, and beam energy allow the charge distribution to be inferred. To take these measurements, a thin-film disordered SiO2 structure with a conductive middle layer was charged using 200-eV and 5-keV electron beams with regular 15-s pulses at …