Physics Commons^™

Implementation Of Uncertainty Propagation In Triton/Keno: To Support The Global Nuclear Energy Partnership, Charlotta Sanders, Denis Beller

Reactor Campaign (TRP)

Monte Carlo methods are beginning to be used for three-dimensional fuel depletion analyses to compute various quantities of interest, including isotopic compositions of used fuel.1 The TRITON control module, available in the SCALE 5.1 code system, can perform three dimensional (3-D) depletion calculations using either the KENO V.a or KENO-VI Monte Carlo transport codes, as well as the two-dimensional (2- D) NEWT discrete ordinates code. For typical reactor systems, the neutron flux is not spatially uniform. For Monte Carlo simulations, this results in non-uniform statistical uncertainties in the computed reaction rates. For spatial regions where the flux is low, e.g., …

Monaco/Mavric Evaluation For Facility Shielding And Dose Rate Analysis: To Support The Global Nuclear Energy Partnership, Charlotta Sanders, Denis Beller

Reactor Campaign (TRP)

Monte Carlo methods are used to compute fluxes or dose rates over large areas using mesh tallies. For problems that demand that the uncertainty in each mesh cell be less than some set maximum, computation time is controlled by the cell with the largest uncertainty. This issue becomes quite troublesome in deep-penetration problems, and advanced variance reduction techniques are required to obtain reasonable uncertainties over large areas.

In this project the MAVRIC sequence will be evaluated along with the Monte Carlo engine Monaco to investigate its effectiveness and usefulness in facility shielding and dose rate analyses. A previously MCNP-evaluated cask …

Dissolution, Reactor, And Environmental Behavior Of Zro2-Mgo Inert Fuel Matrix, Kenneth Czerwinski

Fuels Campaign (TRP)

This project will examine inert fuels containing ZrO₂ and MgO as the inert matrix. Ceramics with this inert matrix, Ce, U and eventually Pu will be synthesized and examined. While the Advanced Fuel Cycle Initiative focus is on inert fuels with Pu as the fissile component, this task will perform initial laboratory experiments with Ce and U. The initial work with Ce will be performed early in the project with results used as a basis for U studies. Reactor physics calculations will be used to examine suitable quantities of burnable poisons from the candidate elements Gd, Er, or Hf. …

Impact Of The Synthesis Process On Structure Properties For Afci Fuel Candidates, Kenneth Czerwinski

Fuels Campaign (TRP)

Synthesis of actinium mononitrides using carbothermic reduction of the corresponding oxides has a few outstanding issues, including the formation of secondary phases such as oxides and carbides and low densities of the final product. Furthermore the requirement of a high process temperature at 1700°C, for more than 12 hours is also a drawback particularly for Americium-bearing samples. Therefore, it is important to explore the use of other possible routes to synthesize actinide mononitrides.

A low temperature process is used in this research to produce actinide mononitrides using a fluoride route in which the first step is to mix the actinide …

Solution-Based Synthesis Of Nitride Fuels, Tyler A. Sullens, Kenneth Czerwinski

Fuels Campaign (TRP)

The preliminary studies into the synthesis of actinide nitride fuels through a low temperature, liquid ammonia based synthesis route have been conducted on the uranium containing system, and there is good indication for the success of synthesizing uranium (III) nitride. The dissolution of iodine in ammonia is a rapid process, resulting in a pale green solution, which does not result in any observable oxidation of iodine. The cannula transfer of dissolved iodine into the reaction vessel containing U metal has been conducted with little to no residual iodine remaining in the original flask. The metal being used for these reactions …

Development Of A Novel Modular Mid-Infrared Sensor For The In-Situ Detection Of The Btex Compounds In Water, Raymond Mccue

Doctoral

This research thesis describes the design, construction and testing of a novel modular mid-infrared fibre optic sensing system for the detection of hydrocarbons in water. It is the adverse effects to these hydrocarbon pollutants on flora and fauna that has led to the development of sensing systems for their detection and quantification. The key sensor design feature, its modularity, utilises simple low cost commercially available optical components, which are inherently suited to construct compact rugged sensing systems to perform in-situ measurements which are ideally preferred for environmental sensing. The various laboratory-based prototypes constructed weee calibrated for two target analytes over …

Digital Elevation Accuracy And Grid Cell Size: Effects On Computed Topographic Attributes, Rob H. Erskine, Timothy R. Green

Timothy R. Green

Terrain attributes are commonly used to explain the spatial variability of agronomic, pedologic, and hydrologic variables. The terrain attributes studied here (elevation, slope, aspect, and curvature) are estimated readily from digital elevation models (DEMs), but questions remain about how the accuracy and sample spacing of the elevation data affect the estimated attributes. The main objective of this study was to quantify differences in each terrain attribute due to factors affecting DEM accuracy and grid cell size. Three data sources were compared: (i) real-time kinematic global positioning system (RTKGPS); (ii) satellite-differentially corrected global positioning system (DGPS); and (iii) U.S. Geological Survey …